In an RC circuit, what is the value of the ratio V. /E when the current in the circuit reaches 13.95% of its peak value? V. = voltage across the capacitor and E = emf of the %3D power source. Express your result as a percentage with 2 decimal places (i.e if the result is 76.14 % write 76.14 without the % sign and not 0.7614)

In an RC circuit, what is the value of the ratio V. /E when the current in the circuit reaches 13.95% of its peak value? V. = voltage across the capacitor and E = emf of the %3D power source. Express your result as a percentage with 2 decimal places (i.e if the result is 76.14 % write 76.14 without the % sign and not 0.7614)

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 69AP: Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r =...

See similar textbooks

Similar questions

The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
A 2.00- and a 7.50F capacitor can be connected in series or parallel, as can a 25.0- and a 100k resistor.Calculate the four RC time constants possible from connecting the resulting capacitance and resistance in series.
The timing device in an automobile’s intermittent wiper system is based on an RC time constant and utilizes 0.5.00F capacitor and available resistor. Over what range must R be made to vary to achieve time constants from 2.00 to 15.0 s?
Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r = 1,00 . (a) Find the equivalent resistance of the circuit and the current out of the battery. (b) Find the current through each resistor, (c) Find die potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
Consider an RC circuit in which R = 0.5 Ω, C=0.1 F, and Eo = 20 V. Given that the capacitor haszero initial charge, determine the current in the circuit after 0.25 seconds.
The RC charging circuit in a camera flash unit has a voltage source of 285 V and a capacitance of 131 µF. HINT (a) Find its resistance R (in ohms) if the capacitor charges to 90.0% of its final value in 13.2 s. Ω (b) Find the average current (in A) delivered to the flash bulb if the capacitor discharges 90.0% of its full charge in 1.14 ms. A
in RC circuit with R1=2.4 KΩ and R2=1.2 KΩ ,C=47 μF and E=12 V, DURING chargin process determine charge accumulated by the capacitor after 3.5 s , and find captitor voltage after 2 s , then in the discharging process when electrical source removed from the ciruit calculate total current in the circuit after 1.5 s.
An RC circuit have 9 V source and lies at 54 seconds of time constant. Then, find the voltage across the capcitor after 153.6 seconds of charging. A. 9.636 V B. 8.477 V C. 7.258 V D. 6.899 V
The RC charging circuit in a camera flash unit has a voltagesource of 275 V and a capacitance of 125 µF. (a) Findits resistance R if the capacitor charges to 90.0% of its finalvalue in 15.0 s. (b) Find the average current delivered to theflash bulb if the capacitor discharges 90.0% of its full chargein 1.00 ms.
An RC circuit has a 5.5 kΩ resistor and a 8.0 µF capacitor in series, how long will ittake for the fully discharged capacitor to be charged to 95% once the switch is closed? _______How long would it if a second 8.0 µF capacitor is added in series? _______
An RC (resistor + capacitor) circuit will have an exponential voltage response of the form v(t) = A + B e -t/RC where A and B are constants that express the final voltage and the difference between the initial voltage and the final voltage, respectively. Given R = 10 kΩ and C = 0.1 µF, a starting voltage of 5 Volts and an ending voltage of 0 Volts, what will the voltage be at t = 1 ms? At what time will the voltage be 0.5 Volts?
Consider an initially uncharged capacitor in an RC circuit. The resistance is 20,000 Ohms and the capacitance is 500 x10• F. If the source potential being used to charge the capacitor is 15 V, how long after charging begins will the power delivered to the resistor be 25 % of its maximum value?