In an RL-circuit, the higher the value of the inductance the rate of change of the current stays the same. the slower will be the the rate of change of the current. O the rate of change of the current varies sinusoidally. the faster will be the the rate of change of the current.

In an RL-circuit, the higher the value of the inductance the rate of change of the current stays the same. the slower will be the the rate of change of the current. O the rate of change of the current varies sinusoidally. the faster will be the the rate of change of the current.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 24CQ: Would you use a large inductance or a large capacitance in series with a system to filter out low...

See similar textbooks

Related questions

Q: A truck's wheel (r = 23 cm) turning at 111 rev/min increases its velocity to 335 rev/min within 14.4…

A: Given data :- radius r = 23 cm = 0.23 m initial angular velocity ω0 = 111 rev/min or…

Q: A spring with original length of 35cm is pulled by a force 13N, stretching it to 38cm. Determine the…

Q: the figure, two long straight wires are perpendicular to the page and separated by distance d₁ =…

Q: A cubical block of ice 57.0 cm on an edge is placed on a level floor over a speck of dust. Locate…

Q: Two point charges (91 = -3µC and q2 = 8 μC) are fixed along the x-axis, separated by a distance d =…

Q: i. Suppose 8.5x10-19 J of work is done to bring the nucleus of an atom from some infinite distance…

Q: Two charged particles are separated by 10 cm. Suppose the charge on each particle is doubled. Part A…

Q: If a cup of coffee has a temperature of 90 celsius and you quickly sip a bit of it. What is the…

A: Temperature of the coffee left in the cup will be same ,i.e., 90℃.

Q: Estimate the time needed for a glycine molecule to diffuse 15 um in water at 20^o C if its…

Q: A glucose solution being administered with an IV has a flow rate of 4.05 cm3/min . What will the…

Q: In the figure, two circular arcs have radii a = 13.1 cm and b = 10.6 cm, subtend angle = 70.0°,…

Q: A nylon rope used by mountaineers elongates 1.8 m under the weight of a 68-kg climber. If the rope…

Q: 13 R3 1₂ R6 E1 E2 E3 m R₁ R4 M R₁ R5 m R₂ R8 E4 T

Q: A diverging mirror with a focal length of 90cm is used as a side-view mirror on a car. Another car…

Q: 2) A hot bar of lead with Ti Pb, Mpb = .6 kg, is dropped into an iron pot (mFe = .3 kg) that has…

Q: Suppose 8.5x10−19 J of work is done to bring the nucleus of an atom from some infinite distance away…

A: Electric potential energy of the nucleus =work done to bring the nucleus to the particular location…

Q: Two point sources of light are separated by 5.5 cm a. As viewed through a 13 μmμm diameter pinhole,…

A: Given data Seperation between two point sources is d = 5.5 cm Diameter pinhole is D = 13micro m

Q: How fast must a meterstick be moving if its length is measured to shrink to 0.443 m? Xc What is the…

Q: 12. The net effect when two waves combine either constructively or destructively 13. The combination…

A: 16. The time required for a wave to complete one cycle. Means, time for a complete vibration of a…

Q: You apply a flame to 2 L of water for a certain time and its temperature rises by 2°C. If you apply…

A: You apply a flame to 2 L of water for a certain time and its temperature rises by 2°C. If you apply…

Q: An electric eel can generate a 115-V, 0.7-A shock for stunning its prey. What is the eel's power…

Q: Ch31 P34. A rare decay mode has been observed in which 222Ra emits a 14C nucleus. The decay equation…

Q: QUESTION 3 A 5.0-cm-radius conducting loop with a resistance of 4.0 is in the presence of a uniform…

Q: How many farenheits are 300 K? Show computation

Q: Determine the acceleration of the block on the ramp if the coefficient of friction is 0.3 Fapp=SON…

A: mass (m) = 100 kg applied force (F) = 50 N coefficient of friction = 0.3

Q: The average person drinks 2.6 L of water a day. If you drink 2.6 L of water at 0 degrees C and heat…

A: Given data as per question T1 = 0 T2 = 37 Volume = 2.6L density = 1g/ml

Q: A jet airplane in level flight has a mass of 8.60 x 104 kg, and the two wings have an estimated…

Q: Suppose there is a 0.45 mm thick layer of 20°C water between two microscope slides. The area of…

A: Write the given values with the suitable variables. t=0.45 mm=0.45×10-3 mA=7.2 cm2=7.2×10-4 m2u=0.95…

Q: What fraction of the air molecules in a house must be pushed outside while the furnace raises the…

Q: Two capacitors C, and C₂ are connected in series. a) Derive an expression for the equivalent…

Q: What is the formula and variables in finding the weather

Q: Sun is 4 X 10^26 watts and Los Angeles 3 X 10^8 watts How many cities like Los Angeles could be…

Q: Three balls with the same radius 28 cm are in water. Ball 1 floats, with half of it exposed above…

Q: Find the coefficient of friction that will keep the block from moving. Fapp= 200 N 40° 60kg

Q: Two ideal gases have the same mass density and the same absolute pressure. One of the gases is…

A: Given Two ideal gases at same mass density i.e Helium and neon respectively p1 = p2 And at same…

Q: The self-induced emf in a loop opposes a. the net resistance in loop b. the inductance…

Q: Calculate the following values: NA, acceptance angle, Oc at the core-cladding interface, and A…

Q: The left ventricle of a resting adult’s heart pumps blood at a flow rate of 83 cm3/s, and an average…

A: Write the given values with the suitable variables. Q=83 cm3/s=83×10-6 m3/sΔP=75.5 mm Hg=75.5×133.3…

Q: A car (rwheel = 50 m) with initial angular velocity of 9.2 rev/s begins to decelerate to rest within…

A: Given: The radius of the wheel is 50 m. The initial angular speed is 9.2 rev/s. The time interval is…

Q: webassign.net/web/Student/Assignment-Responses/la = 29005162 Error Update : 5. [-/1 Points] DETAILS…

Q: What radius needle should be used to inject a volume of 519 cm3 of a solution into a patient in 34…

Q: A bus is traveling with a uniform velocity of 20 m/s. At the instant it passes a car at rest, the…

A: Given: Velocity of bus, v = 20 m/sec Acceleration of car, a = 4 m/sec2

Q: A child bounces in a harness suspended from a door frame by three elastic bands. (a) If each…

A: a) Given Mass of child M = 7.15 kg Strech in elastic band ∆x = 0.250 m To find Spring constant…

Q: Mass of a body is 9 kg, what is it's weight?

A: Given data : Mass = m Acceleration due to gravity = g To find…

Q: A gas is compressed at a constant pressure of 0.800 atm from 11.00 L to 1.00 L. In the process, 390…

Q: oman walks, her entire weight is momentarily placed on one heel of her high-heeled shoes. This…

A: Given m=63.5 kgA=1.4 cm2=1.4×10-4 cm2

Q: Two equal resistances are connected in parallel across a 150V DC source. What potential difference…

Q: A football is kicked at 25.0 m/s at an angle of 31.0° above the horizontal. Assume it starts 1.00 m…

Q: A beam of unpolarized light shines on a stack of five ideal polarizers, set up so that the angles…

A: Here we have to use malus law to find the required angle between the axis of two polariser

Q: The work function of cesium is 2.1 eV. ▾ Part A Determine the lowest frequency photon that can eject…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 M (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
Referring to Figure 23.57(b), what is the direction of the current induced in the coil: (a) If the current in the wire increases? (b) If the current in fine wire decreases? (c) If the current in the wire suddenly changes direction? Explicitly show how you follow the steps in the Problem-Solving Strategy for Lenz’s Law.
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
When a wire is connected between the two ends of a solenoid, the resulting circuit can oscillate like an RLC circuit. Describe what causes the capacitance in this circuit.
Figure OQS1.I is a graph of the magnetic flux through a certain coil of wire as a function of time during an interval while the radius of the coil is increased, the coil is rotated through 1.5 revolutions, and the external source of the magnetic field is turned off, in that order. Rank the emf induced in the coil at the instants marked A through K from the largest positive value to the largest-magnitude negative value. In your ranking.
Two rectangular loops of wire lie in the same plane as shown in Figure OQ31.11. If the current I in the outer loop is counterclockwise and increases with time, what is true of the current induced in the inner loop? More than one statement may be correct, (a) It is zero, (b) It is clockwise, (c) It is counterclockwise, (d) Its magnitude depends on the dimensions of the loops, (e) Its direction depends on the dimensions of the loops.
Would you use a large inductance or a large capacitance in series with a system to filter out low frequencies, such as the 100 Hz hum in a sound system? Explain.
True or False; explain why Similar to capacitance, inductance contains only geometric information of the system, and how it is arranged
A rectangular circuit containing a resistance R is pulled at a constant velocity v → away from a long, straight wire carrying a current I0 (see below). Derive an equation that gives the current induced in the circuit as a function of the distance x between the near side of the circuit and the wire.
Question 2: Part (a) Express the inductance of the solenoid, L, in terms of N, d, and A. L = ______ Part (b) Calculate the numerical value of L in henries. L = ______
The circuit shown in the figure contains a resistor and a solenoid. A battery is connected by closing the switch in the figure and provides an EMF Vbat = 15 V. At a time t = 50 ms after the switch is closed the current in the circuit reaches a value of 1.0 A which corresponds to 25 % of its steady state value. What are the values of the resistance and inductance? State your answer to 2 s.f.