In circuit shown in the figure, the switch that is closed for a long time is opened at t=0. Find vc(t) for t>=0

Q: 1. The switch in the circuit shown belowhas been closed for a long time; and is opened at t= 0, a)…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: What is the time constant (tau) of the circuit? and Find Vc at t=0.05 sec after the circuit is…

A: To find the time constant of the RC circuit  And also find the voltage across capacitor at t= 0.05…

Q: The switch in the circuit has been in position A for a long time. At t = 0, the switch oves to…

A: A resistor (R), an inductor (L), and a capacitor (C) make up an RLC circuit, which can be used in…

Q: 11. 7.11 The switch in the circuit seen  has been in position 1for a long time. At t=0, the switch…

A: When the switch is in position 1 for a long time, the current through the inductor is, As the…

Q: Q3: The switch in the circuit in the following figure has been closed for a long time and then…

A:

Q: The switch in the circuit seen in has been in position a for a long time. At t=0, the switch…

A: When the switch is at position “a” for long time, the capacitor will act as open circuit. The…

Q: Find the general form of v.(t), for all t> 0, in the circuit of the following figure.

A:

Q: In the circuit shown in the following figure, u, (t) is the input voltage. The current i (t) through…

A:

Q: Q.36: The switch in the circuit shown in figure beside has been in position "a" for a long time, and…

A:

Q: The switch shown in the circuit has been closed for a long time and is opened at t= 0. Find v(t) and…

A:

Q: 1. The switch in the circuit shown belowhas been closed for a long time; and is opened at t = 0, a)…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: The switch in the circuit shown has been closed for a long time before being opened at t =0. a) Find…

A: for t <0 I = 1515+20+40I=0.2 mAV1(0) = 20 K ×0.LmA         = 4VV2(0-) = 40×0.2            = 8V

Q: Use step-by-step approach to find V0(t) for t > 0. Plot the response.

A: The given circuit is The switch SW1 is closed at t=0, initially, it is open.

Q: The switch in the circuit shown in figure beside has been in position "a" for a long time, and then…

A: In this question we need to find a voltage VC(t)

Q: 2) For the circuit 1k2 a 10mA I(t) t=0 1kQ 20µ b. Find V.(0*) b) Name all three cases depending on…

A:

Q: The switch in figure below has been open for a long time and is closed at t = 0. The circuit…

A: When the switch is in closed condition at t=0;capacitor is intially charged to a voltage of 10V.so…

Q: Q.4: For the circuit shown beside when the switch is closed for a long time, then the switch is…

A:

Q: Is the system below overdamped, underdamped, or critically damped? Show your work ( u means X106).

A:

Q: Q4/A: The switch in the circuit shown below has been closed for a long time, and it is opened at t…

A:

Q: In the circuit in the figure below, the switch, which has been closed for a long time, opens at t=0.…

A:

Q: Q.2 The switch in Figure Q.2 has been in position 'A’ for a long time. At t = 0 s, the switch moves…

A:

Q: The circuit shown below has reached steady state at t = 0-. If the make-before-break switch moves to…

A: first draw the t = 0- circuit and calculate the current then obtain t = 0+ circuit and using the KVL…

Q: Q.32: For the circuit shown, the switch has been in position "1" for a long time. At t=0, the switch…

A:

Q: the circuit shown below, the value of vc (t) for 0 ≤t< 1 is equal to which of the

A: In this question , we will find voltage across capacitor for t= 0 to 1..

Q: 1. Find the energies of r(t) = u(t) – u(t – 2) and y(t) = u(t) – 2u(t – 1) + u(t – 2), for t € R,…

A: 1) Given x(t)=u(t)-u(t-2)

Q: Homework 1 The switch in the circuit in below has been closed for a long time, and it is opened at t…

A:

Q: Find i(t) and v(t) for t > O in the circuit shown. i + 3.5u(t) A (4 0.2 F 20 H V ll

A:

Q: The switch in figure below has been open for a long time and is closed at t = 0. The circuit…

A:

Q: The switch in the circuit below has been closed for several minutes. It is finally thrown open at t…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: In the circuit shown below the switch S is closed at t = O and opened again at t = n seconds. Prior…

A: The solution is given below ?

Q: The switch in the circuit given below opens at t=0 s after being kept closed for a long enough time.…

A: Given circuit, R=2 ΩVs=4 V Switch is closed for a long time and opened at t=0 s

Q: 2. The switch in the circuit shown in Figure below has been open for a long time. Att = 0 the switch…

A: Disclaimer:  Since you have asked multipart questions, we will solve the first three subpart for…

Q: B) For the circuit shown below, the switch is opened for a long time, at t=0 it is closed. i) Find…

A:

Q: For the circuit shown, the switch opens at t = 0. Find Ve(t) for t > 0. Vc(t) 1 µF Vc(t) 10Ω 40 V

A: At t&lt; 0   switch is closed  Circuit is steady state and capacitor will open circuited and the the…

Q: The switch in the circuit in Fig. below has been open for a long time. At t%3D0 the switch is…

A: The solution can be achieved as follows.

Q: The switch shown in the circuit has been closed for a long time and is opened at t 0. Find v(t) and…

A: Given circuit shown The switch is closed for long time and opened at t=0Vs(t)=0 v      for t&lt;030…

Q: Solve the problem with these conditions: R; = 4R; and R, = 2R;. Assume that all switches have been…

A:

Q: Homework 1 The switch in the circuit in below has been closed for a long time, and it is opened at…

A:

Q: For the circuit shown below, the initial conditions are zero, Vdc is a voltage source continuous and…

A: The solution is given below

Q: 3) The switch in the circuit shown has been closed for a long time and is opened at =0. a. Calculate…

A: As per Bartleby guidelines, we are allowed to solve only three subparts of a question if you want a…

Q: The switch shown in the circuit has been closed for a long time and is opened at t= 0. Find v(t) and…

A: Draw the circuit for t &lt; 0.

Q: The circuit below has fully adjusted. The switch is closed at t=0 s. Determine the expression for…

A: Case 1 t&lt;0, Switch will be on open position and in steady state inductor behave as short circuit.…

Q: (i) Draw a simplified circuit for condition at t 0. (ii) Calculate the initial value of current,…

A: This is the transient response question. Here the switching time and switch position plays a vital…

Q: The switch closes at t = 0 after being open for a long time. Given that R = 7 k. Find an expression…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: After being open for a long time, the switch shown in the circuit below closes at t = 0 Find VR(t)…

A:

Q: The switch in the circuit shown has been closed for a long time, and it is opened at t = 0. Find…

A: In this we will find energy stored in capacitor....

Q: For t<0 in the circuit below, the value of v(t) is equal to which of the following?

A: KVL (Kirchhoff's Voltage Law) states that the algebraic sum of all voltage in a closed loop is zero.…

Q: The switch in the circuit has been closed for a long time before being opened at t=0. Find Vo (t)…

A: Ohm's law: This law states that the current is directly proportional to the voltage and inversely…

Q: In the given circuit, where R = 1 ohm and and L=1H, solve for i(t) using convolution. The…

A:

Q: Q1. For the circuit shown, assume that the switch has been open for a long time. Find the voltage…

A:

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).