In short-track speed skating, the track has straight sections and semicircles 16 m in diameter. Assume that a 69 kg skater goes around the turn at a constant 11 m/s. (Figure 1) Part A What is the horizontal force on the skater? Express your answer with the appropriate units. HA F = Value Units Submit Previous Answers Request Answer X Incorrect; Try Again; 7 attempts remaining Figure 1 of 1 Part B What is the ratio of this force to the skater's weight? F Submit Previous Answers Request Answer

In short-track speed skating, the track has straight sections and semicircles 16 m in diameter. Assume that a 69 kg skater goes around the turn at a constant 11 m/s. (Figure 1) Part A What is the horizontal force on the skater? Express your answer with the appropriate units. HA F = Value Units Submit Previous Answers Request Answer X Incorrect; Try Again; 7 attempts remaining Figure 1 of 1 Part B What is the ratio of this force to the skater's weight? F Submit Previous Answers Request Answer

Name: In short-track speed skating, the track has straightsections and semi
Uploaded: 2024-03-20T06:57:57.000Z
Channel: Bartleby
Description: In short-track speed skating, the track has straightsections and semicircles 16 m in diameter. Assume thata 69 kg skater goes around the turn at a constant11 m/s.Part A(Figure 1)What is the horizontal force on the skater?Express your answer with the

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Illinois Jones is being pulled from a snake pit with a rope that breaks if the tension in it exceeds 755 .(A) If Illinois Jones has a mass of 70.0 and the snake pit is 3.40 deep, what is the minimum time that is required to pull our intrepid explorer from the pit? (B) Explain why the rope breaks if Jones is being pulled from the pit in less time than that calculated in part (A).
The block shown in figure #1 above has a mass of 4.30 kg. The applied force (? ⃑ ) has a magnitude of 31.2 N and is 32.0° above the horizontal, frictionless surface the block in on. a. What is the normal force (magnitude and direction) that acts on the block? b. What is the acceleration (magnitude and direction) that is experienced by the block?
Consider the scenario in the figure below. Suppose m1 = 4.5 kg, m2 = 6.5 kg. Thecoefficient of kinetic friction between block 2 and the ramp 0.54. The system is set intomotion so that block 2 is sliding down the ramp.a) What is the magnitude of the acceleration of the blocks?b) What is the tension in the string?
A dancer is standing on one leg on a drawbridge that is about to open. The coefficients of static and kinetic friction between the drawbridge and the dancer's foot are μs and μk, respectively. n⃗ represents the normal force exerted on the dancer by the bridge, and F⃗g represents the gravitational force exerted on the dancer, as shown in the drawing.(Figure 1). For all the questions, we can assume that the bridge is a perfectly flat surface and lacks the curvature characteristic of most bridges. Before the drawbridge starts to open, it is perfectly level with the ground. The dancer is standing still on one leg. What is the horizontal component of the friction force f⃗? (Express your answer in terms of some or all of the variables n, μs, and/or μk.) (Figure 2). The drawbridge then starts to rise. The dancer continues to stand on one leg. The drawbridge stops just at the point where the dancer is on the verge of slipping. What is the magnitude f of the frictional force now? (Express…
1. Consider a plane of mass 50,000 kg in takeoff when the thrust for each of its four engines is 25,000 N. If the plane is facing an air drag force of 10,000 N; What is the acceleration of the plane? 2. Peter, who has a mass of 80 Kg is skateboarding at 5 m/s when he smacks into a brick wall and comes to a dead stop in 0.25 sec. What is his acceleration? What is the force acting on him? 3. A boxer punches a sheet of paper in midair and bring it from rest up to a speed of 20 m/s in in 0.02 sec. Mass of paper is 0.005 Kg. a.What acceleration is imparted to the paper? b.What force does the boxer exert on it? c. What force does the paper exert on the boxer? 4. If you stand next to a wall on a frictionless skateboard and push the wall with a force of 40 N, how hard does the wall push on you? If your mass is 75 Kg, what will be your acceleration? 5. What average net force is required to bring a 1200 kg car to rest from a speed of 25 m/s (90 km/h) in 10 seconds? 6. A 50 Kg toolbox is being…
A high jumper approaches the bar at 6.5 m/s horizontally. She experiences a vertical reaction force of 1555 N for a period of 0.28 s. If the high jumper weighs 698 N what is: (Remember projectile motion concepts) and draw an free body diagram. a) her resultant velocity immediately after leaving the ground? b) her angle of take-off c)What is the horizontal component of the velocity at c.2) the instant of release? c.3) the highest point? c.4) 0.33 seconds after release? d) What is the vertical component of the velocity at d.1) the instant of release? d.2) the highest point? d.3) 0.33 seconds after release? e) What is the acceleration? e.2) in the vertical direction? e.3) in the horizontal direction? please answer all parts, a-e.
At the airport, you observe some of the jetsas they take off. With your watch you find that it takes about 35seconds for a plane to go from rest to takeoff speed. In addition,you estimate that the distance required is about 1.5 km. (a) If themass of a jet is 1.70 * 105 kg, what force is needed for takeoff? (b)Describe the strategy you used to solve part (a)
In the figure (Figure 1), if mAmA =1.00 kgkg , mBmB = 1.10 kgkg and θθ=34.0 ∘∘, what will be the magnitude of the acceleration of the system? Which direction will the mAmA move? Up the incline Down the incline If mAmA=1.00 kgkg and the system remains at rest, what must the mass mBmB be? Calculate the tension in the cord for Part A. Calculate the tension in the cord for Part C.
Part A What average force is needed to accelerate an 8.30-gram pellet from rest to 150 m/sm/s over a distance of 0.920 mm along the barrel of a rifle? Express your answer with the appropriate units.
Block 1 (m1 = 6 kg) is resting on top of block 2 (m2 = 2 kg) on the floor of an elevator. The elevator is moving downward with an increasing speed and the magnitude of the acceleration is 1 m/s2. On a sheet of paper, draw the free body diagrams for block 1 and block 2 using the two-subscript notation from class. After completing the free body diagram, enter below each force and its x & y-components. Remember that the x-component is the "i" component and the y-component is the "j" component.NET force on Block 1Fnet1 = i + j NNET force on Block 2Fnet2 = i + j N Tries 0/2 FORCES on BLOCK 1Weight force on block 1 by EarthW1E = i + j NNormal force on block 1 by block 2N12 = i + j N Tries 0/2 FORCES on BLOCK 2Weight force on block 2 by EarthW2E = i + j NNormal force on block 2 by block 1N21 = i + j NNormal force on block 2 by SurfaceN2S = i + j N
Can cars "stop on a dime"? Part A Calculate the acceleration of a 1600 kgkg car if it can stop from 34 km/hkm/h on a dime (diameter=1.7cm.)(diameter=1.7cm.) Express your answer to two significant figures and include the appropriate units. Part B How many g's is this? Express your answer using two significant figures. Part C What is the force felt by the 68 kg occupant of the car? Express your answer to two significant figures and include the appropriate units.