In the above circuit, when Ri=0, the frequency a is 1.2 kHz in the amplitude spectrum drawn. The capacitance of the capacitor for the same circuit is 0.6 microF. What should be the value of the R resistor so that the quality factor remains unchanged at 1.5 ohms when the Ri resistor is 1.5 ohms?

Q: Problem 2: If S(t)-4sinc(t).cos(1000nt)+6cos200xt.sin(1000nt) a. What is C(t) b. The spectrum of the…

A:

Q: Determine the eight-point DFT of the signal x(n) = (1, 1, 1, 1, 1, 1, 0, 0} and sketch its magnitude…

A: 8 point DFT of the signal : x(n)={1,1,1,1,1,1,0,0} to sketch its magnitude and phase

Q: A Nyquist plot is obtained by plotting the amplitude (NOT in a log scale!) and phase (in degrees) of…

A:

Q: For the system with (s + 300)(s + 50000) s(s + 20)(s + 4000) G(s) = 1- Find the analytical…

A: Given transfer function is as follows

Q: A series circuit consists of an oscillating voltage source (@=20 rad/s), a 302 resistor and an…

A:

Q: "If the transmission bandwidth using the ideal Nyquist channel is W=5MHz and the roll-off factor of…

A:

Q: In a series RLC circuit driven by an ac generator, the angular frequency is tunable in the sense…

A: Given,

Q: Derivative Approach For the transfer function, determine the sensitivity to the variation…

A: The solution is given below

Q: With regards to the Nyquist plot, calculate the phase (in degrees) of the following transfer…

A: Given transfer function is =

Q: In a series RLC circuit driven by an ac generator, the angular frequency is tunable in the sense…

A:

Q: For the Paralle RLC Circuit with Fo=8MH , BW=970 Hz and R=203 ohm Find the Values of Quality factor…

A: As per the guidelines of Bartleby we have to solve 1st three subpart of the question for rest…

Q: In a simple series RLC circuit, from first principles, determine the conditions necessary for…

A: RLC series circuit is shown below in frequency domain

Q: Obtain and sketch magnitude and phase S p (n) = 26 (n) – 6 (n – 1) – 6 (n – 2) (a

A:

Q: (c) A power supply with ms voltage 400V and frequency 50HZ is equipped with a resonant harmonic…

A:

Q: Draw the magnitude plot and phase plot for the following transfer function. jw + 10 H(w) = jw(jw+…

A: Given H(w)=[jw+10]/[jw(jw+5)^2]

Q: A power supply with rms voltage 380V and frequency 50HZ is equipped with a resonant harmonic filter…

A:

Q: Which one of the following figures represents the positive frequency spectrum of x.(t)? Note in this…

A:

Q: For a parallel resonant circuit, if the damped frequency is √8 rad/s and the bandwidth is 2 rad/s,…

A: Given, A parallel resonant circuit having, Damped frequency, ωd=8 radsec Bandwidth, BW = 2 radsec

Q: 5.2-7 Given m(t) e-, fe = 104 Hz, kf = 6000x, and k, = 8000x. %3D %3D %3D %3D (a) Find Af, the…

A: Initially, the bandwidth of signal is to be found. Later, based on modulation index value, bandwidth…

Q: An RLC series resonant circuit has the following parameter: fr=5000/2Hz, impedance at resonance =5k…

A: An RLC series resonant circuit has the following parameter : fr=50002πHzImpedance at resonance:…

Q: Draw the magnitude plot and phase plot for the following transfer function. jw + 10 H(w) = jw(jw +…

A: We need to plot magnitude and phase of given Transfer function .

Q: An RLC series circuit has a 2.50 Ω resistor, a 100 µH inductor, and an 80.0 µF capacitor. (a) Find…

A: Given data, The value of resistance is R = 2.50 Ω. The value of inductor is L = 100 µH. The value…

Q: A parallel RLC network is constructed using R = 5 Ω, L = 100 mH, and C = 1 mF. (a) Compute Q0. (b)…

A:

Q: Draw the magnitude plot and phase plot for the following transfer function jw + 10 iw(iw + 5)2 H(w)…

A:

Q: Example 05:- For the filter circuit shown, sketch the frequency response and determine the cutoff…

A: To get cutoff frequencies first transfer function is obtained.by comparing the obtained transfer…

Q: Problem 6' Use asymptotic approximations to sketch frequency response plots for the following system…

A:

Q: ı just need fınal aswer In the circuit in the figure, Rs = 3.8 kΩ, R1 = 82 kΩ, R2 = 22 kΩ, RC = 5.6…

A: consider the given question;

Q: A filter circuit consisting of a series L-C in parallel with an inductor is to be designed to pass a…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Construct the magnitude and phase plot for the following transfer functions 100(s +20) H(s) = s(s+…

A: By observing se can se that the system is single input single output. The order of the system can be…

Q: A filter circuit consisting of a capacitor C, in series with a parallel combination of Cp-L is to be…

A: It is given that: Passing frequency=fp=50 KHz=50×103  HzBlocking frequency=fb=20 KHz=20×103…

Q: 1. For the system shown below, do the following: R(s) + E(s) K(s + 5) sis2 + 4s +25) C(s) a. Sketch…

A: Given, The block diagram of the system is shown below,

Q: Please can you solve it fast 2) Which ones are correct about Nyquist's Theorem in sampling? I.…

A: Please can you solve it fast 2) Which ones are correct about Nyquist's Theorem in sampling? I.…

Q: Plot the phase angle Vs frequency curve on a logarithmic scale.G(S)=10/(S(1+0.1S)(1+0.5S)) Determine

A: According to question:

Q: For the series RLC circuit shown, the frequency of the voltage source v, 20cos(@) V is adjusted…

A: In the circuit, Resistor, inductor and capacitor are connected in series.  At resonance XL = 38 ohm…

Q: Q4) A random signal with a random phase is given as in the following. The phase has a uniform…

A: The random phase of a signal is given below, X(t) = 4 cos2 200πt+θ(t)Andf(θ)=12π-π<θ≤π0otherwise…

Q: Consider RLC circuit which is connected in series. Inductance in 25 mH and resistance is 10 Ohm,…

A: The solution can be achieved as follows.

Q: Question 5. A signal has a double-sided magnitude and phase spectra shown below The Magnitude…

A: We need to find out time domain expression of given Fourier transform and we need to find average…

Q: b- For the circuit shown below, find the frequency domain of the o/p signal and draw the spectrum…

A: Find the time domain function of the given circuit,

Q: In the circuit given above, the frequency a is 1.7 kHz in the amplitude spectrum drawn when Ri=0.…

A:

Q: The table below shows the amplitude and phase at some frequencies for a given system. Find the…

A:

Q: Construct the magnitude and phase plot for the following transfer functions H(s) = 41 (s+0) (s +52…

A: Given  A transfer function.we need to draw both magnitude and phase plot. Please find the below…

Q: 1 kΩ 2 kM Vout Vin C = 20 µF, 2 kΩ 1 kΩ +

A:

Q: In the amplitude spectrum drawn when Ri=0 in the circuit given above The frequency a is 2.4 kHz. The…

A:

Q: 8-9. Given the following transfer functions: 4s + 1 1+ 2s G(s) and G(s) = s+1 (2s + 1)(4s + 1) (a)…

A: Given:  Transfer functions: G1s=4s+1s+1,G2s=1+2s2s+14s+1=14s+1. G1s has a zero at -14 and a pole at…

Q: Consider the sequence x[n] = [-3, 0, –1, {10}, 1, 0, 3], where the number in {:} corresponds to n =…

A: Given the sequence x[n]=[-3,0,-1,{10},1,0,3] , where {.} corresponds to n=0. a) We need to write…

Q: 19. Determine the analytical expression for the magnitude frequency response and phase frequency…

A: According to question: Expression of magnitude frequency response is calculated as   Expression of…

Q: a) Design a parallel RLC circuit using component values from the tables given below, with a resonant…

A:

Q: When Ri=0 in the circuit given above, the frequency a is 1.5 kHz in the amplitude spectrum drawn.…

A: