In the adjacent circuit, the voltages and values of resistance are unknown. The value of the current running through R1 is 5.3 mA going from left to right, and the current through R3 is 1.8 mA from the top of R3 to the bottom. The value of the current through R2 running from right to left (in mA) is: R1 R2 R3; V1 V2 O a. 2.65 O b. 10.60 O c.7.10 O d. -3.50 O e. 3.50

In the adjacent circuit, the voltages and values of resistance are unknown. The value of the current running through R1 is 5.3 mA going from left to right, and the current through R3 is 1.8 mA from the top of R3 to the bottom. The value of the current through R2 running from right to left (in mA) is: R1 R2 R3; V1 V2 O a. 2.65 O b. 10.60 O c.7.10 O d. -3.50 O e. 3.50

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 55P: A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any...

See similar textbooks

Similar questions

A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
Integrated Concepts (a) What energy is dissipated by a lightning bolt having a 20,000-A current, a voltage of 1.00102 MV, and a length of 1.00 ms? (b) What mass of tree sap could be raised from 18.0°C to its boiling point and then evaporated by this energy, assuming sap has the same thermal characteristics as water?
If the battery in the circuit below is 7.16V, resistor R1=331.15ΩΩ, and resistor R2=51.49ΩΩ, what is the magnitude of the current flowing through the circuit? Please give your answer in units of milli-Amps (mA).
You connect a battery, resistor, and capacitor as in (Figure 1), where E = 46.0 V, C = 5.00 μF, and R = 130 Ω. The switch S is closed at t = 0. When the voltage across the capacitor is 8.00 VV, what is the magnitude of the current in the circuit? At what time tt after the switch is closed is the voltage across the capacitor 8.00 V? When the voltage across the capacitor is 8.00 V, at what rate is energy being stored in the capacitor?
In the circuit below, if the battery in the circuit below is 5.9V, resistor R1=76.03ΩΩ, and resistor R2=77.61ΩΩ, what is the magnitude of the current that passes through R1? Give your answer in units of milli-Amps (mA).
1. 9. In the circuit shown in the figure above, a power supplier of 50 V is connectedacross a resistance network. If R1 = 20 Ω, R2 = 10 Ω, R3 = 10 Ω, and R4 = 40 Ω. Whatis the equivalent resistor of the circuit? 2. 10. What is the current flowing through the R4 resistor in the circuit shown in Problem 9? 3. 11. What is the voltage across the R1 resistor in the circuit shown in Problem 9? 3.
The diagram below shows a circuit where; R1 = 6.0 Ω, R2 = 4.0 Ω, R3 = 2.0 Ω, V1 = 6.1 Volts, V2 = 14.0 Volts, and V3 = 28.8 Volts. What is the value of I1? In solving this problem, initially pick the current directions as shown. If the actual current turns out to be in the opposite direction, then your answer will be negative. If you get a negative number, enter it as negative.
A circuit with a resistance R = 88 Ω is connected to a battery with potential difference across the terminals of ΔV = 6.5 V. a. Input an expression for the current passing through the circuit, I. (b) What is the current in milliamps, mA? (c) If the resistance of the circuit was increased by a factor of ten, Rnew = 10R, what is the new current in milliamps, mA?
If 480 C pass through a 4.0- resistor in 10 min, what is the potential difference across the resistor?
In the circuit shown in the figure below, V1= 1.50 V, V2= 2.50 V, R1= 4.00 Ω, and R2= 5.00 Ω. What is the magnitude of the current, i1, flowing through resistor R1?
The circuit contains three resistors, A, B, and C, which have equal resistances. epsilon = 110V. Which resistor generates the most thermal energy after the switch is closed? a.B b.A c.All three generate the same amount of thermal energy. d.C e.A and B
Given the circuit, where the rate at which R1 is dissipating electrical energy is20.0W. When the total current flowing in the circuit is 3.50A, find:a.) R1 and R2 (4pts)b.) Emf of the battery (2pts)c.) Current through both R2 and the 10.0-ohm resistance (4pts)d.) What is the total electrical consumption