in the circuit below only the current flowing in the second

Q: Consider the open-loop transfer function of a negative feedback system, G(s) = K(s+3) s(8-1) Which…

A: Here we discuss about the stability of control system.

Q: An audio amplifier has an impedance of 7500 Ohm. It must be coupled to a horn with an input…

A: Given,The impedance of audio amplifier is,Z=7500 ΩThe input impedance is,Zin=12 Ω

Q: Three impedances (4-j6) 2, (6+j8) 2, and (5-j3) 2, are connected in parallel. Calculate the current…

A: The current dividation rule states that the measure of current in a specific branch in a parallel…

Q: Compare the methods for electric power transmission with respect to usage, cost. connection,…

A: Introduction - Electric power transmission  - A transmission line is a specialised wire used to…

Q: 3-phase, 126 MVA, 132 kV, 50 Hz, 355 mm² underground cable of outer radius 18 mm. Note: consider…

A: Given data, The supply frequency = 50Hz Area of the underground cable = 355mm2 The radius of the…

Q: Determine the lower [cut off frequency for the network of fig (1-7) using the following parameters.…

A: Amplifier having positive slope of gain on lower frequency and negative slope at higher frequency…

Q: For the following signals determine whether or not they are periodic if they are periodic then find…

A: summation of two or more than two periodic signals will be periodic only if ratios of their…

Q: The drain-to-source voltage at the pinch-off point of a particular JFET is 7 V. If the…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 1 8 Let K=2, G₁(s)=5G₂(s) == Find K₁ so that = 0.6 and ts=0.1 sec for a 1% tolerance.

A: Transfer function: A system, sub-system, or component's transfer function (also known as system…

Q: 7. Assuming that all flip-flops are in reset condition initially, write output observed at QA up to…

A:

Q: Solve for the overall h-parameters in the attached network

A: The given circuit is as shown below,

Q: The switch in the circuit shown in figure beside has been in position "a" for a long time, and then…

A: In this question we need to find a voltage VC(t)

Q: The following are the correct sign conventions for analyzing circuits using Kirchhoff's Laws EXCEPT:

A: The direction of current travelling in a circuit can be given as the positive potential as the…

Q: 1. Find the total quality of water available in the period of the month. 2. Determine the average…

A: It is given that: Area of Lake=500 km2Total drainage area of lake =Ax=6000 km2 with lakeInitial…

Q: A 3.5-ohm resistor is in series with a 25 micro-Farad capacitor. The combination is in parallel with…

A: In this question we need to find a current I1 and I2

Q: Q1/ A / let Q1=8 Mc be located at p1(2,5,8) while Q2=-5Mc is at p2(6,5,8), FIND F2. B/ A point…

A: Q1/A It is given that:Q1=8μC at p12,5,8Q2=-5μC at p26,5,8

Q: Q1. Choose the correct answer Which of the following is the نقطة واحدة ?main advantage of Self bias…

A: We are authorized to answer only 1 question at a time isnce you have not mentioned which question…

Q: A 150 kVA three phase transformer supplies 100KVA at 50percent lagging power factor. The…

A: Voltage regulation is the change in the secondary terminal voltage of a transformer when full or…

Q: % contribution R3E1 IR3E2 +1. R3E2 +1 x 100 R31 E2 I R₂ R₁ 50 ΖΩ R4 E₁ 10 10 V 11 V 3 A b a R2 R4 R₁…

A:

Q: The charge 10-5 e-3t C is removed from a sphere through a wire. Find the current in the wire at t =…

A:

Q: Create a block diagram or a circuit of a gyroscope

A: It is asked to create a block diagram of a gyroscope.

Q: * How CDMA more important ?than TDMA and FDMA

A: 1. Because CDMA systems utilize the whole available spectrum of frequency, each user who needs more…

Q: 4. The open-loop transfer function of a system is given by, 10 (s+3) (s+5) (s-1) (s² + 4s+8) (a)…

A:

Q: Design an Ayrton shunt by indirect method to provide an ammeter with current ranges , 3A, 5A, 8A, If…

A: The meter voltage should be calculated by using the meter current and resistance and by using this…

Q: Question2): Find the current and voltage for each element in the fig. (2) Sketch the vand i curves.…

A: First we will calculate the impedance and then current by using current and impedance relationship…

Q: QUESTION 6 A rectangular loop of length a-4.00 cm and width b-2.00 cm is put in a region of uniform…

A:

Q: Q1/ Find the state and output equations for the electrical network shown in The below figure if the…

A: Electrical network: This is a network that contains the electrical elements as resistors, inductor,…

Q: An inverter with a resistive load, VDD = 3.3 V, P = 0.1 mW, VL = 0.2 V, K'n = 60 UA/V2 and VT N =…

A: Solution- Given,VDD = 3.3 VP = 0.1 mWVL = 0.2 VKn' = 60μA/V2VTN = 0.75 V Let transistor operate in…

Q: ns. 1. Iron los..........varies approximately as V². 2. Cu loss..........it also varies as but…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A light ray to be transmitted from an index (n₁) to another index (n₂). It reaches the surface…

A:

Q: Explain in detail the construction and working .. principle of MI Instrument with drawings and…

A: Given  Explain the construction and working of moving iron instrument. Please find the below…

Q: Refer to the Figure below. V₁0 H Z₁ Cs Compute for Zo= kohms if VDD=20V. RG-192Mohms, RD-2.1 kohms,…

A: Brief description:  For the given MOSFET we need to compute the value of output impedance. In the…

Q: Refer to the given circuit below. Determine the Norton Equivalent Current Source if R3 is to be…

A:

Q: Refer to the given circuit below. Using Superposition Theorem, determine the percent contribution of…

A:

Q: A 250kVA single phase transformer has an iron loss of 2kW and the maximum efficiency at 0.8 P.F…

A:

Q: 03: Find the R.M.S value of the current waveform shown below. If the current flows through a 602…

A:

Q: For the figure 2 below, how do I find: Total impedence ZT The voltage V1 in phasor form The current…

A: As per the guidelines of we supposed to answer first three subpart only

Q: Consider a single phase transformer with primary and secondary turns of 1000 and 200 respectively…

A: Given:R1=10.5ΩR2=2.5ΩX1=12.5ΩX2=2.5ΩRm=15.55KΩXm=10KΩK=1000200=5

Q: 501az A Determine the total current in a wire of radius 1.6 mm if J = P m² Select your answer. 5.026…

A: In this question we need to choose a correct option

Q: 2. A 3-phase, 11kV, star-connected alternator has armature resistance of 1 2/phase and a synchronous…

A:

Q: 8.A. One characteristic of a typical universal motor is that it A. is usually designed for low-speed…

A: Universal motor is a special motor designed to operate on AC as well as DC supply.   Centrifugal…

Q: 1. In Figure 1, determine (a) the current supplied by the source, (b) the voltage drop across each…

A: We need to find out source current and voltage across each resistor for given circuit

Q: Obtain Fourier transform of signal e-lalt u(t). 2 Find the inverse transform of X(f) 1+ 2(jw-1) j

A: According to the bartleby's guidelines we have to solve only one question posted by students so…

Q: Discuss and explain what is Voltage Multiplier?

A:

Q: 2. A two-pole three phase 50 Hz Y-connected AC generator has 9 slots per pole and 6 conductors per…

A: To find flux per pole if the voltage on open circuit is 1.1 kV  Given: A 3- phase generator no. of…

Q: Electrical Engineering For a unit feedback system having the following gain functions: G(s) Ks -…

A: Given: For a unity feedback system having the following gain functions: Gs=Ks-4.21s22s+5.7 To find:…

Q: A power system has 2 buses with bus1 as slack bus and bus 2 as PQ bus and bus voltages as V1=1 20°…

A: Real Power: The actual power that is delivered to the load, such as a transformer, induction motors,…

Q: The expression of output in the following CMOS circuit is AL Output 13 DECE

A:

Q: Mention four difference between conventional and non convectional energy sources.

A:

Q: Find the energy stored in free space for the region 2 mm < r < 3 200 < 90°, given the potential…

A: Solution- a) V = 200/r volts We know,E =-∇V∇V=1h1∂V∂uu^+1h2∂V∂vv^+1h3∂V∂ww^       for spherical…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.