A 3.5-ohm resistor is in series with a 25 micro-Farad capacitor. The combination is in parallel with a coil which has an impedance of 13L 59 ohms. The total current flowing to the circuit is 7L-30 A. Find the values of the two currents 11 and 12 flowing in each branch circuit.

A 3.5-ohm resistor is in series with a 25 micro-Farad capacitor. The combination is in parallel with a coil which has an impedance of 13L 59 ohms. The total current flowing to the circuit is 7L-30 A. Find the values of the two currents 11 and 12 flowing in each branch circuit.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter22: Resistive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 2PP

See similar textbooks

Related questions

Q: Determine inverse z-transform of the following equations: Please box the final answers.

Q: Discuss and explain how filter circuits for AC and DC power supply works.

A: AC circuit have a finite frequency and time period. AC filters are used to block or pass the certain…

Q: Q4/ Evaluate the state space expression for the below circuit if the output is the current through…

Q: A balanced delta-connected load with impedance per phase of 30/30° is connected to an abc-sequence…

Q: The following information is given in connection with an alternator slot = 144; poles = 8; speed =…

A: Whole Coiled:- When we distribute the all coils over the whole armature periphery, then the armature…

Q: 5 + 3-j4 20/0⁰ 2 10 L90° 12 V + 15 20 + V V Za = 5 ohms Zb= 3-j4 ohms Zc= 2 ohms Zd= 12 ohms V1= 20…

Q: 4. A solar cell has an efficiency n of 27%. Calculate the fill factor if illumination with AM1.5…

Q: Determine inverse z-transform of the following equations: Please box the final answers.

Q: An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase…

A: This question requires knowledge about unbalanced 3 phase circuits

Q: 1. When a synchronous motor is at working condition, is there induced electromotive force in the…

A: This is belongs to synchronous motors

Q: Q2/ Suggest a LTI system to convert the input from r(t) = A cos(t), to output equal to c(t) = 2A…

Q: Q1/For a LTI system, drive the frequency response, if you know that the inpu is: r(t) = M cos(wt +…

A: Frequency Response Analysis: The reaction of a system may be classified into two types: transient…

Q: 2. A full-wave bridge rectifier is operated from a 50 Hz, 220 V rms line. It has a 100 µF filter…

A: In this question we need to find a ripple factor and average current in the load.

Q: The dc shunt generator given its rated voltage when the field resistance is higher than critical. O…

A: We know that the critical field resistance is the highest allowable shunt field winding resistance…

Q: 2. A two-pole three phase 50 Hz Y-connected AC generator has 9 slots per pole and 6 conductors per…

A: To find flux per pole if the voltage on open circuit is 1.1 kV Given: A 3- phase generator no. of…

Q: For the collector-feedback configuration of Fig. 4.129, determine: a. IB. b. Ic c. Vc. +16 V 270 kQ2…

A: given here a BJT transistor based circuit and asked to determine the value of IB , IC , VC .

Q: la W R4 202 V5 -4V X V4 Hill 6V Ib y R6 40 g R5 40 Ic Z V6 -2V

Q: 2. Determine the force exerted on Q₂ by Q₁ for charges Q₁ = 4x10-5C and Q₂ = -7x10-5C if Q₁ is…

Q: 1. Resistance Measurement Choose a 10% (or a 5% tolerance if you don't have a 10%) tolerance…

A: Standard resistance available in market in between 20 and 45 Ohm is 20R 22R 27R 33R 36R 39R 43R 47R

Q: Q1/ For a LTI system, drive the frequency response, if you know that the input is: r(t) = M cos(wt +…

A: Given,For a LTI system,The input signal is,rt = Mcosωt+θ

Q: For the equivalent circuit of lossless linear transformer shown, find the value of L₁, L2, M & K?…

A: Given The equivalent circuit diagram of lossless linear transformer. We need to find the values of…

Q: + R₁ 60 R₁ E₁ R2 R₂ 6 Ω R3 R4 5Ω | 4Ω a R₂ ↑ I C E₁ E₂ 9V 9 V b R3 I 4 A R4 E2 (+1)

A: We need to find out norton current for given circuit

Q: N (z - 2)²

Q: The following information is given in connection with an alternator slot = 144; poles = 8; speed=…

Q: 1. How many states are there in an 8-bit Johnson counter sequence?

A: A johnson counter can repersent 2N states where N is the number of bits. Here N = 8 Hence number of…

Q: -www- RB E VBB www RC RE Vcc

Q: A 1MVA, 11 KV, three phase wye-connected synchronous generator has a synchronous reactance of 5 ohms…

Q: a. Find the Fourier transform of the given function. -T f(t)= 2A -t+ A, 7sts≤0; ≤ t ≤ 0; T 2 T f(t)=…

Q: For figure 3, how do I find: Is The average power delivered to each element, the reactive power for…

A: KCL states that algebraic sum of currents at a node must be equal to zero. It is also called nodal…

Q: 2. Find the IN and RN of the circuit shown below as seen from the terminals A and B. 10V 212 63 72…

Q: Three resistors of 50 ohms, 100 ohms, and an unknown resistance R are connected in parallel and the…

Q: 60v I 15:1 WW SA лоч ww Ал ЧA т 12 л лита B

Q: نقطة واحدة The action of JFET in its equivalent circuit can be represented as which of the…

A: JFET is three terminal semiconductor device which current flow through one medium i.e electron or…

Q: To have two alternators in parallel,

Q: 1. Using Thevenin's theorem, find the current through load Resistor (RL=22002) for the circuit shown…

Q: Design a component values for RLC series circuit with center frequency of 4KHz and quality factor of…

Q: 2. Using Kirchhoff's Voltage Law, find the current through the R₂. 8V 3V R3 18 Ω R2 202 R1 302 www

Q: 2. Consider the circuit of diagram with C=100 nF, L=10 mH, R=1 k0, using only source E1=2 V p-pat 1…

A: It is given that: C=100 nFL=10mHR=1kΩE1=2Vp-pf=1kHzR1=50Ω

Q: 4.4ΚΩ Μ Vin 800mv 30kΩ Μ => Rx Μ 55ΚΩ + +12V -12V -Vout δε 140

Q: determine the inverse Fourier transforms of: (a) X₁ (jw) = 2T 8(w) + π 8(w-47) + π8(w + 4π)

Q: The switch in the circuit shown in figure beside has been in position "a" for a long time, and then…

A: In this question we need to find a voltage VC(t)

Q: Q1. Clearly draw the small signal low-frequency model (with the Hybrid-π) and derive an equation…

A: A small-signal model is an AC equivalent circuit in which nonlinear circuit parts are substituted by…

Q: Decide the stability of the system, whose characteristic equation is given by S5 +254 +5S³ + 10s² +…

Q: Consider the system shown in the single-line diagram of Figure (3). All reactances are shown in per…

A: Three phase fault is symmetrical fault, hence fault study can be done on per phase basis. All the…

Q: transformer has its maximum efficiency of 98% at 20kVA and unity power factor. During the day, it is…

A: In this question we need to find a all day efficiency of the given transformer

Q: six-pole, 30-slot dc commutator generator has a lap wound Armature winding. The armature constant,…

A: In this question , we will find back emfb, required armature current and voltage supply to this…

Q: Usung K-map technique = E (0,2,5, 8, 10, 14) simplify the function F(A, B, C. + d (1, 3, 4, 6, 7, 9,…

Q: Question 39 Solve the collector saturation current voltage of a fixed-bias circuit with Vcc = 10V,…

A: We need to find out saturation collector current .

Q: Q1: Distinguish between Short jump and Long Jump of 8051 Micro Controller. For 8051 system of…

A: Given We need to distinguish between short and long jump in 8051 microcontroller and we need to…

Q: 1. When a synchronous motor is at working condition, is there induced electromotive force in the…

A: This question is belongs to synchronous motors

Question

Find: a) I1; b) I2 The frequency is 60Hz. Provide a step by step solution as well as the illustration.

A 3.5-ohm resistor is in series with a 25 micro-Farad capacitor. The combination is in
parallel with a coil which has an impedance of 13L 59 ohms. The total current flowing to
the circuit is 7L-30 A. Find the values of the two currents 11 and 12 flowing in each
branch circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
In an R-L parallel circuit, ET=240 volts, R=560 R = 560 2, and XL=330. Find reactive power.
An Impedance Coil has a resistance of 7.5 ohms and an inductive reactance of 18 ohms (connected in series). a) What is the voltage equation for a voltage that produces a current i = 11.3sinwt, b) Solve for the values of E, I, voltage across the resistor and voltage across the inductor.
A series circuit consists of a resistor, a coil, and a capacitorconnected across a 300V, 60Hz AC source. The current drawn is 20A.The voltage across the resistor is 60V, that across the coil is 260V andthat across the capacitor is 100V. The resultant voltage across the coiland the capacitor is 254.56V. Determine (a) the resistance of theresistor, (b) the resistance and inductance of the coil, and (c) theresistance and capacitance of the capacitor.
A 30-ohm resistor and a 0.1 H inductor are in series with a voltage source thatproduces a voltage of 120 sin (377t + 10°) V. Find the components for thecorresponding phasor domain current source transformation. Note: Please write and answer neatly with solutions, thank you!
In an L-R-C series circuit, the source has a voltage amplitude of 121 V , R = 75.0 Ω , and the reactance of the capacitor is 475 Ω . The voltage amplitude across the capacitor is 358 V A) What is the current amplitude in the circuit? B)What is the impedance? C)What two values can the reactance of the inductor have?
Consider the circuit diagram below. Compute a single equivalent impedance for this circuit for a source frequency of ? =60 Hz. Express your final answer as a phasor with polar coordinates. You must show your all your work for the complex math. Include a diagram of the equivalent circuit as part of your solution.
Three components are connected in parallel. The first component is a 5-ohm resistor, the second component is an inductor with 200mHinductance and the third component has a capacitance of 80 microfarad.If the parallel combination is connected to a source with e=240 sin (400t+30˚), find the equations of the current flowing on each component.
A resistor of R= 90 ohms and an unknown capacitance are in series. The voltage across the resitor is VR = 50 sin (1000t + 10degree) volts. If the current leads the applied voltage by 40degree, find the value of C in microfarad.
A series resistance - capacitance ( R-C ) circuit is connected to a 230V, 60 - cycle source. If the power taken by the circuit is 4, 800W and the voltage drop across the resistor is 115V.Calculate the capacitance of the capacitor. 600.36 microfarad 1,500.05 microfarad 556.096 microfarad 250.94 microfarad
A series RC with R = 91-Ω and C =7-F connected across a 100 VDC source for a LONG TIME, what is the voltage across the capacitor? Write the values only (round to four decimal places).