Answered: In the circuit shown in the figure…

In the circuit shown in the figure (Figure 1), E = 61.0 V, R = 35.0 . R2 = 24.0 N, and L = 0.295 H. Switch S is closed at t = 0. Figure 1 of 1 st. a R1 R, Provic 3.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 59P: For the circuit shown below, =50V , R1= 10 , and L= 2.0 mH. Find the values of l1and l2(a)...

See similar textbooks

Related questions

Q: In the circuit shown in (Figure 1), E = 56.0 V, R₁ = 36.0 , R₂ = 22.0 , and L= 0.290 H. Part A…

A: Givenε=56 VR1=36 ΩR2=22 ΩL=0.290 H

Q: Three inductors with inductances L1, L2, and L3 are connected in series. Assuming that they are…

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, have 470…

A: Given that: NA=470 NB=570iA=2.60 AϕA=300μWb=300×10-6 WbϕB=90μWb=90×10-6 Wbdidt=0.5 A/s

Q: switch as shown. The values for the resistors are: R1 = R2 = 39 0, R3 = 62 N and R4 = 126 N. The…

Q: In the circuit shown in the figure, switch S is closed at t = 0. a) What is the current in the…

A: Given: The inductance L2 and L3 are in series and thus, their resultant is L23=L2+L3=1 H +1 H=2 H…

Q: In Figure 5pR1 = 10 N, R2 = 12 N, L1 = 0.4 H, L2 = 0.1 H, and the ideal battery has ɛ = 10 V. (i)…

Q: Problem 2: A 1.7H inductor in an RL circuit (with resistance 1.95 0) is initially carrying a current…

Q: Two ideal inductors, L1 and L2, have zero internal resistance and are far apart, so their magnetic…

Q: (b) Calculate the total inductance at the terminals a-b, for the circuit shown in FigureQ2(b). 5mH…

Q: A long, cylindrical solenoid with 180 turns per centimeter has a radius of 3.5 cm. (a) Neglecting…

Q: A 521-turn solenoid has a radius of 7.00 mm and an overall length of 15.0 cm. (a) What is its…

A: Given: No. of Turns (N) = 521 Radius (r) = 7 mm = 0.007 m; Length (l) = 15 cm = 0.15 m

Q: The switch in the circuit shown in the figure has been open for a long time. The resistors in the…

Q: a L A current I is flowing through an inductor. At time t = 0, the current is zero and at time t 1s…

A: Answer option(c) point a

Q: An infinitely long and thin wire carrying 10 A current is places on the Z-axis away from a…

A: Given that I= 10 A We have to calculate mutual inductance

Q: The switch is initially at state 1, the capacitor is initially uncharged, and the circuit has an…

Q: Problem 2: A1.7 H inductor in an RL circuit (with resistance 1.95 Q) is initially carrying a current…

Q: Please choose the right answer for questions below: (a) What is the reactance of 2.5 Henry inductor…

A: Reactance of inductor is given as , XL=2πfLReactance of capacitorr is given as , XC=1XπfChere…

Q: In the figure, the battery is ideal and &= 12 V, R1 = 15 Q, R2 = 25 N, and L = 5.0 H. Switch S is…

Q: In Figure 5, R1 = 10 N, R2 = 12 N, L1 = 0.4 H, L2 = 0.1 H, and the ideal battery has e = 10 V. (i)…

Q: 3. A long, cylindrical solenoid with 100 turns per centimeter has a radius of 1.5 cm.(a) Neglecting…

A: Here given a long cylindrical solenoid 100 turns per cm of radius 1.5 cm. We have to calculate the…

Q: A battery of emf 30.0 V is connected to a switch, an inductor of inductance ? = 0.600 ? and two…

Q: A 10.00 μF capacitor C is initially charged to a voltage V of 10.00 (V). It is then connected in…

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, solenoid A…

A: Given:

Q: A long, cylindrical solenoid with 90 turns per centimeter has a radius of 4 cm. (a) Neglecting end…

A: Given we are given the number of turns = n = 90turns/cm 100*100 turns/m and its radius is = r = 4cm…

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, have 320…

A: Given: The number of turns are N=320. The number of turns are N'=550. The current is I=3 A. The…

Q: An inductor L = 0.025 H and a 40 Ω resistor are connected in series to a 5 volt battery and a…

A: Given data: L=0.025 H R=40 Ω V=5.0 Volt

Q: R, one inductor, one battery and a switch as shown. The values for the resistors are: R1 R239 Ω, R3…

Q: A 60.0-m length of insulated copper wire is wound to form a solenoid of radius 2.0 cm. The copper…

A: Since there are multiple sub-parts posted, we will answer the first three sub-parts for you. If you…

Q: 20) R22 13 R, L. %3D to a battery, a switch S, and two resistors, R, = 100 and R2 = 20 N as seen in…

Q: A 510-turn solenoid has a radius of 7.95 mm and an overall length of 13.2 cm. (a) What is its…

A: Given : Number of turns, N = 510 radius, r = 7.95 mm Length, l = 13.2 cm = 132 mm Area , A = πr2…

Q: At t = 0, the open switch in Figure P31.46 is thrown closed. We wish to find a symbolic expression…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts (a, b,…

Q: A 510-turn solenoid has a radius of 8.00 mm and an overall length of 14.0 cm. (a) What is its…

Q: Problem 2: A1.7 H inductor in an RL circuit (with resistance 1.95 2) is initially carrying a current…

Q: Two inductors are placed in a circuit in series with each other. Inductor 1 has an inductance of…

A: Basic Details The amount of the energy stored in the inductor depends on the inductance of the…

Q: The current follows in a charging inductor I(t) at time t seconds is given by: i(t) = 1,(1– e) mA…

Q: A long, cylindrical solenoid with 180 turns per centimeter has a radius of 2.5 cm. (a) Neglecting…

Q: At the instant when the current in an inductor is increasing with a rate of 640 x 10-4 A/s, the…

Q: A resistor and inductor are connected to a 9.0 V battery by a switch as shown. The moment the switch…

A: Given information: The symbols used are the same as given in the question.

Q: The switch S in the circuit has just been closed. Right after (at t 0) the current shown is measured…

Q: Two solenoids A and B, spaced close to each other and sharing the same cylindrical axis, have 380…

A: Na = 380 Nb = 680 Ia = 2 A Φa = 300×10-⁶ Wb Φb = 90 × 10-⁶ Wb

Q: . Which of the following electrical components takes a current that is in phase with the voltage…

A: 1. Current that is in phase with the voltage: It means current and voltage vary together in time. If…

Q: R1 In the circuit shown in the figure the emf of the battery & = 24 V. All the inductors %3D R. are…

A: Given : Emf of battery, E = 24 VRo = 2 Ω R1 = 1 Ω R2 = 4 ΩR3 = 5 ΩR4 = 3 ΩR5 = 2 Ω

Q: A solenoid having an inductance of 6.30 mH is connected in series with a 1.20 k resistor. (a) If a…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Just after the switch is closed, what is the magnitude of the potential difference vabvab across the resistor R1?

What is the magnitude of the potential difference vcdvcd across the inductor L?

The switch is left closed a long time and then opened. Just after the switch is opened, what is the magnitude of the potential difference vabvab across the resistor R1?

What is the magnitude of the potential difference vcdvcd across the inductor L?

In the circuit shown in the figure (Figure 1), E = 61.0 V,
R = 35.0 . R2 = 24.0 N, and L = 0.295 H. Switch S is
closed at t = 0.
Figure
1 of 1
st.
a
R1
R,
Provic
3.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

How long after switch S1 is thrown does it take the current in the circuit shown to reach half its maximum value? Express your answer in terms of the time constant of the circuit.
Figure shows a circuit and a conducting rod. A conducting rod moves with a constant velocity vperpendicular to a circuit with a current I=2.82sin(??)
Due to the nature of this problem, do not use rounded intermediate values in your calculations—including answers submitted in WebAssign.Find the currents flowing in the circuit in the figure below. (Assume the resistances are R1 = 6 Ω, R2 = 10 Ω, R3 = 20 Ω, R4 = 15 Ω, r1 = 0.75 Ω, r2 = 0.5 Ω, r3 = 0.75 Ω, and r4 = 0.25 Ω.)
Derive the basic S.I units, then write the basic dimension for thisexpression RLC where R: resistance L: inductance C: capacitance
Consider the circuit diagram in the figure. 1. If the current through the middle part of the loop is I1 = 4.75 amps, what is the current through the top loop, I2, in amps?
calculate the self GMD of a wire with radius of 0.001 inch., with the following strands. A) 4 strands B) 5 strands ,,,,,,, please make a clear hand written or readable answer and explanation
Find the equations of 4 junction and 7 loops for the figure given Given that: R1=25,R2=45,R3=10,R4=15,R5=20,R6=40,E1=10,E2= 35
If current I1 goes to the right through R1, current I2 goes to the right through R2, and current I3 goes to the right through R3, what is the equation resulting from applying Kirchhoff’s loop rule for traveling clockwise around the lower loop of the circuit (see figure below)?
In the figure below, find I1, I2, and I3 if the switch S is a.) open and b.) closed.
Find the current in each branch ofthe circuit shown to the right,along with the power dissipatedby the resistor R3.
Convert 50°R to °F. (Instruction: Type only number without any unit) Answer:
A wire carries current I into the junction shown in the figure (Figure 1). What is the magnetic field strength at the dot?