In the circuit shown in the figure, using superposition theorem, find the R1 following:- 1- The magnitude and the R2 R3 direction of the current through ЗА 24V R3. 2- The voltage across R1. F. E

Q: 3) Point charge of 6x10-6C and 9x10-6C are located at points M(1, 2, 3) and N(2, 4, 6),…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: Q/ Using Kirchhoff's law, find the voltages ? 150 T 5V 300

A:

Q: Solve the current using superposition theorem and solve for the individual currents of each…

A:

Q: Sketch the final waveform of below circuit. * V1 D2 9V R1 25V

A:

Q: Two balanced Y – connected loads A and B are connected across a threephase 3-wire balanced system.…

A: In this question,  We need to determine the current in the load A.  If two loads are connected in…

Q: -15 V to +15 V, if the slew rate is 0.5 V /μs

A:

Q: 5 minutes 3. The reactance offered by a capacitor to alternating current of frequency 50 Hz is 10…

A:

Q: 1 G(s) 3 +3s2 + 2s +1 10 C(s) s+3

A:

Q: In a transformer, the core loss is found to be 60 watts at 30 Hz and 90 watts at 40 Hz measured at…

A:

Q: The following information is given to two transformers connected in parallel: Transformer 1: 75 Kva…

A: In this question,  We need to load sharing by the transformer 1 if. Total sharing of load is 125KVA…

Q: Find t.f simply and do not abbreviate any step Controller Missile dynamics 100(s + 1) Desired 0.1 +-…

A: In this question we need to find a transfer function of the given system.

Q: What is the voltage output for each alternation (Vpp)? * R2 A D1 R1 35V V1 ww

A: In this question,  Diode circuit is given. Assume diode is ideal. So VD = 0V   Find the peak to peak…

Q: = 15 V, V = 6 V termine the minimum voltage. -11 V -15 V -21 V 0-9V

A:

Q: The AC motor M of figure shown in the next slide has 2300 Volts, balanced three phase voltage…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power.

Q: A copper bar of rectangular cross section 2 cm by 8 cm and length 200 cm has a voltage drop of 50…

A:

Q: e) For the amplifiers shown in the figure below, write and explain the formula for the V1 and Vout…

A: In this question,  We need to determine the relation between input voltage and output voltage V1 and…

Q: 2. Consider a A-A configuration balanced three-phase system where the phase sequence is abc .…

A:

Q: 1. Based on the circuit, where v,(t) is the input, and v, (t) is the output. Answer the following…

A:

Q: Find the Re(z) and Im(z) of the following complex numbers. 1) z = (1+ j)5 2) z = cosh[(3 +j2)(1 +…

A: The solution is given below

Q: Calculate the percent voltage regulation for a three-phase wye-connected 2500 kVA 6600-V…

A: The solution is given below

Q: A current transformer with bar primary has 300 turns in its secondary winding. The resistance and…

A: A bar type current transformer utilizes the real cable or bus-bar of the main transformer as the…

Q: Explain in detail Kelvin’s double bridge and D- Arsonaval galvanometer

A:

Q: Solve the given ac network below by using superposition theotem.

A: There are four sources in circuit. we have to find response by each source first. Voltage source is…

Q: Find the input resistance, voltage gain, current gain, and power gain for the amplifier. Bpc= 250.…

A: We need to find out input impedance , current, voltage and power gain for given circuit

Q: 4 ΚΩ 6 kQ 6 ΚΩ Do 2 mA (↑ $2 kQ 5V( +

A:

Q: It is desired to construct uniform transmission lines using polyethylene (εr = 2.25) as the…

A:

Q: P3.12 An overheating monitoring system uses three digital temperature sensors operating in ON/OFF…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: Figure 4 for #13 to #15. 1KO Rs BE 5.1V RL 12V- Vout in out (a) (Б) Figure 4 ww

A: We need to find output voltage for given circuit

Q: 1KO V BE Rs 5.1V Vout 1W 12V out (b) (a) Figure 4 www

A: We need to find out voltage for given circuit

Q: What is the output voltage(R1) on the 1st half cycle? C1 Y 01 R1 12V

A:

Q: Q2: A three-phase Transmission line with 1,956 cm diameter conductor, the corona takes place if the…

A: Given data : Disruptive Voltage, Vc=210 kV= 210000 VDiameter,d= 1956 cm =19.56 mr= d2=19562=978…

Q: Consider the block diagram shown below. At a certain point in the s-plane G (s) H (s) = 5Z180°, what…

A: The solution is given below

Q: Which of the following is a Load and Resistance Design Concept? Service load Rn/2 Factored load O…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: For the amplifier shown, determine V, in mv. 1 ka BJT VV 12 mV -4 mV R2 0.51k transistor amplifier…

A: We need to find out output voltage for given amplifier

Q: Problem 223: EE Board March 1998 A load of 20 + j35 ohms is connected across a 220 volts source.…

A:

Q: sing Given that D = 2pcosp a, az, in cylindrical coordinates, find the flux crossing 2p %3D the…

A: We need to find out flux crossing the given surface

Q: Find the net charge enclosed in a cube 4 m on an edge, pa

A: given cube length=4m charge density=50x^2 sin(pi/2Z)mc/m2

Q: (8)Using the method that applies the Laplace Transform to the circuit below. Find v(t) for t20. Find…

A:

Q: 2. Draw, in the spaces provided, rough sketches shov ing the following: a) A current which lags the…

A:

Q: A - jjo00 -jioco -j250 L-j250 jioco З РHASE 0.5+j2 M B. 0.5+j2 -jiooo SOURCE AC -joo0 мотOR -j2so C…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power.

Q: Question 2 4 kQ 10 kΩ 1 12 k2 iz a C ) 2 mA Uo + In the above circuit, please determine: 1) The…

A: This question belongs to analog electronics . It is based on the concept of virtual ground in ideal…

Q: 5. Using the circuit below, determine the power taken by Rs. R 150 2 500 2 R2 1 k2 R, C450 2 11 V 6.…

A: As per company guidelines we can solve only first question kindly post another question separately

Q: 10. What are the range of values for IL(Load Current) for the given circuit below? 1ko 21. RL 25V…

A: Here it has been solved using the properties of zener diode. Here the zener voltage is 12v which is…

Q: 3. The signal to noise ratio initially measured at the transmitter was 33 dB. The signal power was…

A: We need to find out signal to noise ratio

Q: Example 1: Calculate the percent voltage regulation for a three-phase wye-connected 2500 kVA 6600-V…

A:

Q: The following voltages and line currents were measured to a 3-phase, 3-wire feeder serving a…

A: In this question,  We need to calculate the total power in the system?  We know power P= VI cos(V^I)…

Q: For the following circuit, determine the level of the input voltage in mv. Rce 600 2 Z, = 1.2 ka 10…

A: The solution is given below

Q: current of 0.25 A exists in a 60-ohm lamp. The applied potential difference is * A. 15 V B. 30 V C.…

A: We need to find potential difference for given current and resistance

Q: Vm = 20 V, V = 8 V Determine the maximum output voltage. O ov O -20 V O 28 V O 12 V

A:

Q: For the function f(a,b,c,d)=Em(0,1,3,5,6,7,8,10,14,15), find all minimum sum-of-products solution,…

A: According to the question, for the given function fa, b, c, d=∑m0, 1, 3, 5, 6, 7, 8, 10, 14, 15 We…