In the derivation of expression for peak percent overshoot, Mp exp - TE x100%, Which one %3D of the following conditions is NOT required? (a) System is linear and time invariant (b) The system transfer function has a pair of complex conjugate poles and no zeroes. (c) There is no transportation delay in the system. (d) The system has zero initial conditions

In the derivation of expression for peak percent overshoot, Mp exp - TE x100%, Which one %3D of the following conditions is NOT required? (a) System is linear and time invariant (b) The system transfer function has a pair of complex conjugate poles and no zeroes. (c) There is no transportation delay in the system. (d) The system has zero initial conditions

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter11: Transient Stability

Section: Chapter Questions

Problem 11.17P

See similar textbooks

Similar questions

Which row represent the most stable system and why? nyquist and root locus plot attached.
Consider a stable LTI system with input x(n) and output y(n). The zero-pole pattern of y(n)consists of a double zero at the origin of the z-plane and the poles 3 ± 3j. The zero-pole pattern ofx(n) consists of a double zero at the origin of the z-plane. Find the system function and the systemimpulse response.
Q1. Consider the following characteristic equations. Determine the values of K that corresponds to a stable system. Use the Routh-Hurwitz criterion.
Is the Maximum Power Transfer Theorem verified experimentally? Explain.
a) Sketch the root locusb) Using Routh-Hurwitz, determine the maximum gain Kp before system goesunstable
By plotting the root locus of the system given as the open loop function : G(s)= K/(s*(s+2)); a) When K=4, show the locations of the closed loop poles on the root locus. Determine the Damping Ratio and Natural Frequency values in this gain value. b) Calculate the unit step response of this closed-loop system by calculating the Percent Overshoot, Peak, and Settlement Time values and plot them to scale. c) Scan the region on the root locus where the pairs of conjugate poles must be in order for this inspected system to work at least in the success criteria (greater than the calculated damping rate and natural frequency) in (a).
a) Complete the incomplete root locus below.b) For which value range of K is the system stable?
Given the electrical system below, Determine the transfer function ??(?)/?(?). Express your answer as a single fraction and arrange the degree of variables in descending order
Select the forward path gain (M ktop) for the system for the SFG diagram given below
Derive the follow
The following problems refer to grounding requirements. Give the source of yourresponses. 1. If they are present, what items are required to be bonded together to form a groundingelectrode system?
Consider the rotational translational mechanical system as shown in Figure Q1(a): Derive the transfer function as mentioned in the picture