In the experiment, a gas-phase, elementary reaction A → B + 2C is carried out in an isothermal flow reactor without pressure change. In the operation, pure A enters the reactor at 1010.2 kPa and 400 K with a molar flow rate of 2.5 mol/min. From literature, it was found that the specific reaction rate at 323 K is 0.0001 min-1 and the activation energy is 85 kJ/mol. Calculate yA0, δ, ε and then the volume to achieve 80% conversion in 1. a plug-flow reactor and 2. a continuous-stirred tank reactor. Gas constant: R = 8.314 J/(K∙mol) = 8.314 kPa • dm3/mol/k. Equation for integration use: (see photo)

Q: A cube of osmium metal 1.500cm on a side has a mass of 76.31 g at 25celcius. What is the density in ...

A: Given data: Side of a cube = 1.5 cm Mass of the cube = 76.31 g

Q: Compute the mean energy at 298 K of a two-level system of energy separation equivalent to 500 cm−1.

A: The amount of mean energy for a system of two-level energy separation is to be computed.

Q: During an experiment, a subject breathes in normally from the atmospherebut breathes out into a spec...

A: The number of breaths taken by the subject during the experiment is to be mentioned along with the a...

Q: 6.6

A:

Q: A furnace burns a petroleum coke containing 90% C, 2% H, 3% ash and 5% moisture. Excess air for comb...

A: Coke analysis: 90% carbon (C), 2% hydrogen (H), 3% ash, 5% moisture (M). The percentage of excess ox...

Q: 6.33 Calculate the fugacity of methane gas at 322 K and 55 bar, given that the critical constants ar...

A: given that, temperature T = 322 K pressure P = 55 bar the critical temperature of methane gas Tc = 1...

Q: A sulfur burner, burning sulfur of 98% purity with dry air, discharged gas at 1300°F containing 16% ...

A:

Q: Water in the bottom of a narrow metal tube is held at constant temperature of 20 ° C. The total pres...

A: Given that: Temperature T = 20⁰C = 293 K=68⁰F Converted to ⁰R = 460 +68⁰F = 528⁰R Ptotal =P= 1 atm a...

Q: Liquid benzene and liquid n-hexane are blended to form a stream flowing at a rate of 1700 lbm/h. An ...

A:

Q: The ground state of the Co2+ ion in CoSO4⋅7H2O may be regarded as 4T9/2. The entropy of the solid at...

A: The molar entropy of the solid at the given temperature is to be calculated.

Q: In the reaction: As2O3 + H2O + I2 = As2O5 + HI, 300 g of As2O3 is added to 400 g of I2 and 50 g of H...

A: given that, amount of As2O3 = 300 g amount of I2 = 400 g amount of H2O = 50 g reaction: As2O3 + H2O ...

Q: Formaldehyde (CH2O) is made by the catalytic oxidation of pure methanol vapor and air in a reactor. ...

A: The reactions taking place are:

Q: A filter cake of calcium carbonate contained in a tray is to be dried by cross-circulation from the ...

A:

Q: Concept problem:The reactionA⎯⎯→ Bis carried out in a differential packed-bed reactor at different t...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: A stream of hydrocarbon (Cp= 2.2 kJ/kg.K) is cooled at a rate of 720 kg/hr from 150°C to 40°C in the...

A: Hi and thanks for the question, but you have posted multiple subparts, so we will answer the first 3...

Q: 1. What are the specific ways through which water pollutants enter the environment and how are pollu...

A: The different ways by which water pollutants can enter the environment are to be mentioned. The proc...

Q: Calculate ΔS°rxn for the balanced chemical equation: 4 NH3(g) + 5 O2(g)¡4 NO(g) + 6 H2O(g)

A: The change in the entropy for the given reaction is to be mentioned.

Q: For your feasibility study, your adviser assigned you to a power plant that makes use of coal as its...

A:

Q: A boiler you make use of has coal, which is low in sulfur and nitrogen, as fuel. The coal contains 4...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: Sarah mentions that burning the sludge as fuel is effective. To burn this, fuel oil is mixed with it...

A: Given that, Weight % of carbon in sludge = 40% = 0.4 Weight % of sulphur in sludge = 32% = 0.32 Weig...

Q: Show that for any gas whose volume varies linearly with temperature at a given pressure, the Joule–T...

A:

Q: Water used as working fluid in an ideal reheating Rankin Cycle, 15MPa in the boiler at 2MPa condense...

A:

Q: Air at a dry bulb temperature of 20C and relative humidity of80% is to be heated and humidifi ed to...

A: The initial state of air:   The final state of air:

Q: I need help on d.

A: The cylindrical blending tank is 2.5 m high and has a diameter of 2 m. It contains 2 inlet streams a...

Q: A burner used Pittsburgh coal analyzing 14.1% ash, 2.1% N, 4.3% S. Excess air is supplied dry at 22⁰...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: Ans 59.65 J/mol K

A:

Q: For  each of the cases below, determine if the heat engine satisfies the first law and if it violate...

A: First law of thermodynamics: First law of thermodynamics represents the law of conservation of energ...

Q: Illustrate and discuss the process flow for the manufacture of porcelain

A:

Q: Butane gas is stored in a cylinder at a pressure of 100 psig and at a temperature of 250C. Some of t...

A: Consider a butane gas cylinder at initial pressure of 100 psig and initial temperature of 25°C. the ...

Q: Whenever a substance is heated, its enthalpy increases, as suggested by the relation, ∆?=Cp∆?. Howev...

A:

Q: a) Ts=21.111°C b)Ts=440.168°C C)Ts=47.77°C Solve d), e), f) g), h) and i)

A: Hello. Since your question has multiple sub-parts, we will solve the first three of the requested su...

Q: What is the oven dry weight of a 100g soil that contains 16% water?

A:

Q: Liza is a chemical engineer working for a wastewater treatment facility. One of thebyproducts of sew...

A: Given that, Weight % of carbon in sludge = 40% = 0.4 Weight % of sulphur in sludge = 32% = 0.32 Weig...

Q: Using Figure, determine the following properties of the magnetic material: remanance, saturation mag...

A: The remanence (Br)  is calculated as the measure of remaining magnetization if the driving field is ...

Q: What physical concept forms the premise of VSEPR theory?

A:

Q: Forty-five kg of a solution of 30 wt% ethylene glycol in water is to be extracted with furfural. Usi...

A: Mass fraction of water= 100-30% ethylene glycol =70% Draw a line from C(0,1) to Feed to 70% mass fra...

Q: An environmentally toxic radioactive chemical is continually released at a constant rate of 1 (mg pe...

A: We know that Conservation law is as follows                                       ….1 In our system ...

Q: Please answer question 3.

A:

Q: Kayla began a science experiment with 18 grams of an unknown solid. During the experiment, the chang...

A: Given data: Initial mass of unknown solid = 18 g Change in the mass of the solid during the experime...

Q: Process flow scheme on how to make tempered glass

A: There are two types of commercial glass based on the process of their manufacture. These are: anneal...

Q: K.V. narayanan book of cet-II Chapter 6  unsolved problem 6.41 on page no.272

A:  

Q: A typical high-grade semi-bituminous coal has been found to contain 16.8% volatile matter and 83.2% ...

A: Composition of the given semi-bituminous coal: 16.8%VCM (Volatile combustible matter), 83.2% FC (Fix...