100 lbIn the fig. shown, compute the minimumWeight W to prevent impending motion of theblock up the incline. The weight of the block is100 lb as shown and the coefficient of frictionbetween the block and the incline u = 0.45.Assume frictionless pulley.450

To determine the minimum value of weight W while maintaining static equilibrium. Given, Weight of…

In the fig. shown, compute the minimum Weight W to prevent impending motion of the block up the incline. The weight of the block is 100 Ib as shown and the coefficient of friction between the block and the incline u = 0.45. Assume frictionless pulley.

In the fig. shown, compute the minimum Weight W to prevent impending motion of the block up the incline. The weight of the block is 100 Ib as shown and the coefficient of friction between the block and the incline u = 0.45. Assume frictionless pulley.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter15: Slope Stability

Section: Chapter Questions

Problem 15.28P

See similar textbooks

Related questions

Q: The uniform 20-pound ladder is balanced in the rough floor with ms = 0.8 static friction coefficient…

A: We have to determine the value of horizintal force P that the man needs to apply to the ladder to…

Q: SHOW NEAT AND COMPLETE SOLUTION In the mass-pulley assembly shown, determine the velocity of block B…

Q: 6. The block shown in figure below is acted upon its weight W = 350kN, a horizontal force F = 900KN,…

Q: Determine the minimum weight, W, of the hanging block B to maintain equilibrium of the system given…

A: Given- wt of block A = 100 N Coefficient of friction between block A and the incline =…

Q: Determine the value of a so that the slope at A is equal to zero. Use P = 10KN, L = 10 meters, and…

Q: The uniform 20-pound ladder is balanced on the rough floor with ms = 0.8 static friction coefficient…

Q: A homogeneous block of weight W rests upon the incline shown. If the coefficient of friction is…

A: We have to determine the value of greatest height h at which a force P parallel to the inclined may…

Q: H.W Determine the distance s to which the 90-kg painter can climb without causing the 4-m ladder to…

A: Given:- The mass of the painter = 90 kg The length of the ladder = 4 m The mass of the ladder = 15…

Q: 5. Determine the distance s to which the 70 kg painter can climb without causing the 4 m ladder to…

Q: Q1-The W=2500-N block shownin Fig. below is in contact with 30° incline. The coefficient of static…

A: (a) Draw the free body diagram.

Q: A 6.5-m ladder AB leans against a wall as shown. Assuming that the coefficient of static friction u,…

Q: 20 B A

Q: If the motor exerts a constant force of 340 N on the cable, determine the speed in m/s of the…

A: Using work energy principle

Q: Note: Replace all zero digits of your ID number by number "2" Problem #4: Use X = Last 3 digits of…

Q: The coefficient of static friction between the 62lb box and the inclined surface is 0.12. The…

A: To determine the force that the woman must exert to cause the box to start moving up the incline.…

Q: The 20-lb block A and the 30-lb block B are supported by an incline that is held in the position…

A: Use Newton 2 law

Q: Two blocks with masses ma = 20 kg and mB = 80 kg are connected with a flexible cable that passes…

Q: Determine The Acceleration Of The Block.

Q: A spring is used to stop a 50 kg package which is sliding on a horizontal surface. The spring has a…

A: The coefficient of kinetic friction is the ratio of the frictional force to the normal force while…

Q: 100 lb In the fig. shown, compute the minimum Weight W to prevent impending motion of the block up…

Q: Determine the angle Φ at which the applied force P should act on the pipe so that the magnitude of P…

Q: 7. Blocks A and B have a mass of 100 kg and 150 kg, respectively, If the coefficient of static…

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

Q: Determine the velocity of the 75-lb block A if the two blocks are released from rest and the 35-lb…

Q: A given frame is subjected to loads as shown and analysed using Modified Slope Deflection Method.…

A: Given A frame Required (a)what is the moment KNm at D? (b)what is the maximum positive moment KNm…

Q: A 2.5-lb slider is propelled upward at A along the fixed curved bar which lies in a vertical plane.…

A: Determine (a) the magnitude N of the force exerted by the fixed rod on the slider (b) the rate at…

Q: A cantilever of 3 metres length and of uniform rectangular cross section 150 mm wide and 300 mm deep…

Q: The force P is applied to the 34-kg block when it is at rest. Determine the magnitude and direction…

Q: (a) Draw the FBD of A and B when the wedge B impends to slide to the left. Friction is negligible…

Q: The force P is applied to the 31-kg block when it is at rest. Determine the magnitude and direction…

A: For the given block,

Q: The 180-lb man climbs up the ladder and stops at the position shown after he senses that the ladder…

Q: The 20-lb block A and the 30-lb block B are supported by an incline that is held in the position…

Q: G 10 ft - 3 ft The 180-lb man climbs up the ladder and stops at the position shown after he senses…

A: To determine Coefficient of static friction between the friction pad at A and ground.

Q: A 296-lb block is resting on a rough horizontal surface for which the coefficient of friction is…

Q: BLOCK A WITH WEIGHT EQUAL TO 100 N, RESTS ON BLOCK B OF NEGLIGIBLE WEIGHT. THE COEFFICIENT OF STATIC…

Q: PROBLEM 12.20 The flat-bed trailer carries two 1500-kg beams with the upper beam secured by a cable.…

A: Solution

Q: A 400 kN block is resting on a rough horizontal surface for which the coefficient of friction is…

Q: 8-6. The 180-lb man climbs up the ladder and stops at the position shown after he senses that the…

Q: Determine the distance s to which the 90-kg painter can climb without causing the 4-m ladder to slip…

Q: The 200-lb man walks up the inclined plank of negligible weight. The coefficients of static friction…

Q: A wagon weighing 500 kN starts from rest, runs 30 m down and strikes the bumper post. If the rolling…

A: Given Data:Weight=500kNRuns=30mTanθ=1100K=15kN/mm=15×106N/mRolling Resistance= 5N/kN

Q: 1. Solve for the Deflection at the internal pin (POINT B) 2. SOLVE for the SLOPES at POINT B

A: Free body diagram - Force in the vertical direction - ∑FY = 0⇒RA - 12×5 - 25 + RC = 0⇒RA + RC =…

Q: 3. Determine if the tractor which has a weight of 8000 lb with center of gravity at G, can push the…

Q: The 20-lb block A and the 30-lb block B are supported by an incline that is held in the position…

A: For Bock-AConsider equilibrium about y:∑ Fy=0N1-20cosθ=0.......1Consider equilibrium about x:∑…

Q: a simply supported beam with a hinge on one end and a roller support at the other end is to carry a…

Q: Block A weighs 16 N and block B weighs 8 N. If B is moving downward with a velocity (vB)1 = 5 m/sec…

Q: Example 3.11. A sliding gate 3 m wide and 1.5 m high lies on a vertical plane and has a co-…

Q: . Determine the maximum weight, W, of the hanging block B to maintain equilibrium of the system…

Q: Determine the magnitude of Pfor which slipping impends, provided h is within the range where it does…

A: A) For slipping to impends- P=Ff=μwFf=0.45×600P=Ff=270 lbTherefore the magnitude ofP=270 lb Hence…

Question

100 lb
In the fig. shown, compute the minimum
Weight W to prevent impending motion of the
block up the incline. The weight of the block is
100 lb as shown and the coefficient of friction
between the block and the incline u = 0.45.
Assume frictionless pulley.
450

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

VIEW

Step 2: Free body of diagram of weight W

VIEW

Step 3: Free body of diagram of the block

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two blocks A and B have a weight of 11 lb and 5 lb , respectively. They are resting on the incline for which the coefficients of static friction are μA = 0.16 and μB = 0.25. Determine the angle θ which will cause motion of one of the blocks. What is the friction force under each of the blocks when this occurs? The spring has a stiffness of k = 2 lb/ft and is originally unstretched. Determine the smallest angle and determine the friction force under block A and B under this angle.
Determine the greatest angle θ so that the ladder does not slip when it supports the 75-kg man in the position shown. The surface is rather slippery, where the coefficient of static friction at A and B is μs = 0.3.
If mu = 0.30 under both blocks and A weighs 400 lb, find the maximum weight of B that can be started up the incline by applying to A a rightward force P of 500 lb.
Draw the bending moment diagram of the system under the influence of external loads below. Calculate the vertical displacement value at the intersection of the horizontal beam and vertical column member? (EI= 50000kNm2)
The man picks up the 52-ft chain and holds it just high enough so it is completely off the ground. The chain has points of attachment A and B that are 50 ft apart. If the chain has a weight of 3 lb/ft, and the man weighs 150 lb,determine the force he exerts on the ground. Also, how high h must he lift the chain? Hint: The slopes at A and B are zero.
The maximum force that holds the 4-m-width gate in Figure Q2 (b) close is 50 kN. If oil is being added steadily, determine the maximum h before the gate starts to open. SGoil = 0.86.
For the beam and loading shown below (L = 2.4 m, E = 200 GPa, I = 1000 mm4 and w = 30 kN/m), find (a) TThe slope at point D.(b) The reaction force at end A
The 180-lb man climbs up the ladder and stops at the position shown after he senses that the ladder is on the verge of slipping. Determine the inclination θ of the ladder if the coefficient of static friction between the friction pad A and the ground is μs = 0.4. Assume the wall at B is smooth. The center of gravity for the man is at G. Neglect the weight of the ladder.
.Determine the minimum force P that will cause impending motion of the block shown in Figure P7–12. Will the block tip or slide? (If tipping occurs about point A, both the normal force N and the friction force F will be acting through point A.)
The 100-lb boy at A is suspended from the cable that passes over the quarter circular cliff rock. What horizontal force must the woman at A exert on the cable in order to let the boy descend at constant velocity? The coefficients of static and kinetic friction between the cable and the rock are μs = 0.4 and μk = 0.35, respectively.
The shaft-disk-belt arrangement shown is used to transmit 3 hp from point A to point D. (a) Using an allowable shearing stress of 9500 psi, determine the required speed of shaft AB. (b) Solve part (a), assuming that the diameters of shafts AB and CD are, respectively, 0.75 in. and 0.625 in
Knowing that L = 4 m, Concentrated load P = 15 kN and uniform distributed load w = 12 kN/m, determine the slope at C by Castigliano’s Theorem.(E= 200 GPa, I = 40x106 mm4)