v8g87wty g87wy08g7y0w89y98w7y f89yhswu89gh08qw7erh098h90as8dfgy0as789d60879asdg In the figure, a stone is projected at a cliff of height h with an initial speed of 45.0 m/s directed at an angle 6o = 66.0° above thehorizontal. The stone strikes at A, 5.51 s after launching. Find (a) the height h of the cliff, (b) the speed of the stone just before impact atA, and (c) the maximum height Hreached above the ground.HARA PA(a) NumberUnits(b) NumberiUnits(c) NumberUnits

Answered: Image /qna-images/answer/ade22409-d81f-4b00-9ef0-1c9c6e32bafa.jpg

In the figure, a stone is projected at a cliff of height h with an initial speed of 45.0 m/s directed at an angle e = 66.0° above the horizontal. The stone strikes at A, 5.51safter launching. Find (a) the height h of the cliff, (b) the speed of the stone just before impact at A and (c) the maximum height Hreached above the ground. (a) Number i Units (b) Number i Units (c) Number Units i

In the figure, a stone is projected at a cliff of height h with an initial speed of 45.0 m/s directed at an angle e = 66.0° above the horizontal. The stone strikes at A, 5.51safter launching. Find (a) the height h of the cliff, (b) the speed of the stone just before impact at A and (c) the maximum height Hreached above the ground. (a) Number i Units (b) Number i Units (c) Number Units i

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the velocity of a ball (in m/s) as it hits the bottom of the cliff if it is thrown vertically upward over a height of 10.60m and a velocity of 3.60 m/s.
1. Determine the equations of slope and deflection. 2. Determine the slope and deflection at point 3m from point A. E =210 GPa. 100 | Cross section 6KN.m 2m B8KN 2 kN/m 2m T ) B8KN 2m
If the e = 45°, and the bar 0Q is rotating in the counterclockwise direction at 1.6 rad/s, which of the following is the velocity of the slider P?.
6. Determine the magnitude of the resultant R, if P2 = 978, P3 = 780.
As shown in Figure, astone is thrown vertically into theair from the top oftower 100 ft.high. At the same instant, a second stone is thrown upward from the ground. The initialvelocity of first stone is 50 ft/secand that of second stone is 75 ft/sec.When and where will the stones be at the same height from the ground?
As shown, a round viewing window of diameter D = 0.8 m is situated in a large tank of seawater(S = 1.03). The top of the window is 1.2 m below the water surface, and the window is angled at 60° withrespect to the horizontal. Find the hydrostatic force acting on the window and locate the corresponding CP.
22 A 220-kg block is resting on a 56 deg inclined plane with a coefficient of friction = 0.76. Find the required horizontal force P (kN) that is necessary to prevent motion DOWN the incline. ROUND OFF TO TWO DECIMAL PLACES.
A round viewing point window of diameter D= 0.9 m is situated in a large tank of sea water with sg= 1.03. The top of the window is h= 1.5 m below the water surface, and the window is angled at 60 degrees with respect to the horizontal. (1) Why is the hydrostatic force acting on the window? (2) Locate the corresponding center of pressure measured vertically from the water surface.
Find the following: - Righting Moment - Overturning Moment - Factor of Safety Against Sliding - Factor of Safety Again Overturning Given: μ = 0.6 γ = 23.50 kN/m^3 b1 = 1.60 m b2 = 4.00 m h1 = 10.00 m h2 = 8.00 m
Use moment area method to calculate the deflection at “A” and “D” and the maximum deflection of beam between “B” and “C” E I = 40000 kN.m2.
A rectangular plate was immersed in water such that two of its edges were vertical. If such is 3.5m long. a. How far below the water surface should its upper edge be submerged so that the center of pressure will be 20 cm from the center of gravity? b. What is the distance of the center of pressure from the surface? c. Find the width of the plate so that the total hydrostatic force on one side of it will be 1022.31 kN
There is X=5m high water on the left side of a 3.5 m wide vertical cover sitting on the hinge shown in the figure. On the right, a water jet with a cross-sectional area of A=1100 cm2 hits the cover. a) Determine the horizontal hydrostatic pressure force acting on the cover and the vertical distance of the impact point to the hinge. b) What should be the Q flow rate of the water jet so that the lid remains vertical? (gravity forces will be neglected)