Answered: In the figure below, what is the moment…

In the figure below, what is the moment of inertia of the system about the y-axis if m = 2.0 kg and a = 1.0 m? Assume that the connecting sticks are massless. * a a a a

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter10: Fixed-axis Rotation

Section: Chapter Questions

Problem 70P: Calculate the moment of inertia by direct integration of a thin rod of mass M and length L about an...

See similar textbooks

Related questions

Q: Copper has one conduction electron per atom. Its density is 8.89 g/cm' and its atomic mass is 63.54…

Q: A 12,000 lb truck with a speed of 50 mph is heading due east has a head-on collision with a 4000 lb…

Q: A piece of stone thrown vertically upwards. It reaches the maximum height in 9 seconds. If the…

A: Given data : Acceleration due to gravity = g Final velocity of stone = V Time = t…

Q: The voltage in circuit is 18 V and resistance is 6 ohms, Find the current ?

A: Given data : Resistance = R Voltage = V To find : Current

Q: Two pellets, each with a charge of one microcoulomb (10 C), are located 3 cm (0.03 m) apart. Show…

Q: The drawing shows a crown glass (n = 1.523) slab with a rectangular cross section. As illustrated, a…

Q: Two window washers, Bob and Joe, are on a 3.00-m-long, 315-N scaffold supported by two cables…

Q: Practice for Multiple choice 1. How much heat Q, in Joules, is required to warm up 1.0 kg of water…

A: As per our guidelines we can solve the first 3 multiple choice questions. Please post again unsolved…

Q: Answer the following Problems: 1. An 800 mA current is passing through a resistor. The voltage…

A: The resistance of a household water heater is 25 ohm. Current is 4.40A.

Q: • Knowing the fact that the flow of electric charges causes heat, what ways can you minimize the…

A: Knowing the fact that the flow of electric charges causes heat, what ways can you minimize the heat…

Q: 13 Which is INCORRECT among the following statements? The counterpart of torque in translational…

A: There is a strong analogy between dynamics for rotational motion and dynamics for translational…

Q: In the figure, if 01 = 02 = 0, then 02 T1 T2 W Ο ΤΙ -W W O T1 = 2 sin 0 O T1 = T2 = W O T2 = W

Q: (a) Convert 41.0° to radians, using the appropriate conversion ratio. rad (b) Convert 2.46 rad to…

A: Given Data, Degree=41.00 Radian=2.46 Rad radius of the circle (r)=1.60 m Subtended Angle (θ)=41.00

Q: pressure How to find mass when you are given Pressure = 101.612 KPa Area = 0.069 m^2 Gravity = 9.81…

A: Given data: Pressure (P) = 101.612 kPa Area (A) = 0.069 m2 Gravity (g) = 9.81 m/s2 Required: Mass…

Q: The 22-cm-diameter disk pictured can rotate on an axle through its center. What is the net torque…

Q: 2Ω a ww 12 0 6Ω: 4Ω 3. What is the equivalent resistance between points a and b in the figure? 10 Ω…

Q: A 25.0-kg box of textbooks rests on a ramp that makes an angle with the horizontal. The coefficient…

Q: The 100 kg sphere A is released from rest at an angle of α from the vertical, and hits the 10 kg…

Q: (a) Calculate the angular momentum of Earth that arises from its spinning motion on its axis,…

A: We have to apply angular momentum concept here

Q: Horizontal rays of red light (A = 660 nm, in vacuum) and violet light (A = 410 nm, in vacuum) are…

Q: Which of the following is NOT an electromotive force (emf) E source for direct current?…

A: Batteries are a source of EMF, as their chemical energy provides potential energy for electricity. A…

Q: -lzy -lxz -lyz N.m.s? -lzy 30 ху -10 20 30 and angular velocity w = 10i + 10j + 10k rad/s

Q: A space capsule of mass 505 kg is at rest 8.00 x 10 m from the center of the Earth. When it has…

A: We know that the potential energy is given as P.E = mgh where m is the mass and g is the…

Q: what circuit is this? parallel series series parallel parallel series

A: what circuit is this? parallel series series parallel parallel series

Q: What is the amount of work that a Carnot engine can perform per kilocalorie of heat input if it…

A: Given: The source Temperature (T1) = 450 ⁰C = 723.15 K The sink Temperature (T2) = 182 ⁰C…

Q: A cylinder with moment of inertia I, rotates with angular velocity w, about a frictionless vertical…

A: The angular moment of the system before, i.e when upper cylinder is at rest Jb…

Q: 28. a. AND AND NOT OR NOT AND NOT b. OR Q-INOT

Q: uring an all-night cram session, a student heats up a 0.604 liter (0.604 x 10- 3 m3) glass (Pyrex)…

Q: A uniform steel beam of length L and mass m1 is attached via a hinge to the side of a building. The…

Q: A proton moves through a uniform magnetic field of magnitude 2.5 x 10-3 T at a speed of 3.50 x 104…

Q: Part (b) Calculate the angular frequency, w, in radians per second. Part (c) Express the charge, Q,…

Q: Based on slide 16 from the lecture note, as the student continues to skate from the lowest point to…

A: Given A student skate as shown in the figure Left side friction free and right side surface has…

Q: Two particles with charges q1 = 4.1 uC and q2 = - 5.03 uC are initially separated by a distance of 4…

Q: If an object is elevated at a certain height and then be released, which of the following may be…

A: Given data: Object elevated a height and then released Required: How potential energy and kinetic…

Q: The planet Saturn orbits the Sun at an average distance of 888 million miles. Use Kepler’s 3rd law…

Q: An electric iron connected to a 110 V source draws 9 A of current. Show that the amount of heat it…

Q: A crate of mass 78 kg is pushed along a floor with a force of 30 N for a distance of 9 m . Calculate…

A: Given data: Force (F) = 30 N Displacement (d) = 9 m Required: Work (W)

Q: Consider a fruit hanging on a twig with potential energy of 150 J. If the fruit suddenly falls to…

A: Given data: Initial potential energy = 150 J Fruit falls towards the ground Required: The kinetic…

Q: In Ramsden's eyepiece a coaxial lens system is used. There are two lenses in air and are of equal…

Q: In the figure below, what is the work done by the non-constant force from x = 0 m to x = 12 m? * F,…

Q: A value of electric potential in a particular point in space is 1200 J/C. If the magnitude of the…

A: Given : V = 1200 J/C q = 8 nC = 8 × 10-9 C

Q: A 470 μf capacitor, with a plate separation of 1mm (with air as the insulator) is fully charged…

Q: Problem-Solving: Calorimetry with Phase Changes 1. Six kg of ice at –7.00°C is added to a cooler…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: A 4.30-kg object is attached to a vertical rod by two strings as shown in the figure below. The…

Q: Compare the effect on the acceleration of object A whose change in velocity is twice that of object…

A: Given Change in Velocity of object A = 2 × change in velocity of object B I.e. (∆vA/∆vB) = 2 Time…

Q: A dentist's drill starts from rest. After 3.40 s of constant angular acceleration it turns at a rate…

Q: Which of the following statements is true about potential energy for the given figure? point A point…

Q: path with velocity equation v(t)=0.06t^2 + 0.15t, starting from rest. it took him 3.25 seconds to…

A: We know that We have given that the equation of the velocity is given as v(t) = 0.06t2+0.15 t it…

Q: From the picture below of a roller coaster, at which point is potential energy at its maximum? a.…

Q: A tungsten filament has a temperature of 20.50 degrees Celsius and a resistance of 500 ohms when…

A: Given: The resistance of the tungsten is 500 Ohms at 20.5oC. The RTC for the tungson is 0.00501 /oC.…

Question

In the figure below, what is the moment of inertia of the system about the
y-axis if m = 2.0 kg and a = 1.0 m? Assume that the connecting sticks are
massless. *
a
a
a
a
4.0 kg-m^2.
4.8 kg-m^2.
9.6 kg-m^2.
10.3 kg-m^2.
12.0 kg-m^2.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Calculate the moment of inertia of a skater given the following information. (a) The 60.0-kg skater is approximated as a cylinder that has a 0.110-m radius. b) The skater with arms extended is approximated by a cylinder that is 52.5 kg, has a 0.110-m radius, and has two 0.900-m-long arms which are 3.75 kg each and extend straight out from the cylinder like rods rotated about their ends.
The moment of inertia of a long rod spun around an axis through one end perpendicular to its length is ML2/3 Why is this moment of inertia greater than it would be if you spun a point mass M at the location of the center of mass of the rod (at L/2)? (That would be ML2/4.)
Calculate the moment of inertia by direct integration of a thin rod of mass M and length L about an axis through the rod L/3 , as shown below. Check your answer with the parallel-axis theorem.
While punting a football, a kicker rotates his leg about the hip joint. The moment of inertia of the leg is 3.75kgm2 and its rotational kinetic energy is 175 J. (a) What is the angular velocity of the leg? (b) What is the velocity of tip of the punter’s shoe if it is 1.05 m from the hip joint?
Four objects are held in position at the corners of a rectangle by light rods as shown in Figure P8.37. Find the moment of inertia of the system about (a) the x-axis, (b) they-axis, and (c) an axis through O and perpendicular to the page.
Review. As shown in Figure P10.77, two blocks are connected by a string of negligible mass passing over a pulley of radius r= 0.250 m and moment of inertia I. The block on the frictionless incline is moving with a constant acceleration of magnitude a = 2.00 m/s2. From this information, we wish to find the moment of inertia of the pulley. (a) What analysis model is appropriate for the blocks? (b) What analysis model is appropriate for the pulley? (c) From the analysis model in part (a), find the tension T1(d) Similarly, find the tension T2. (e) From the analysis model in part (b), find a symbolic expression for the moment of inertia of the pulley in terms of the tensions T1 and T2. the pulley radius r, and the acceleration a. (f) Find the numerical value of the moment of inertia of the pulley.
A cylinder with moment of inertia I1 rotates with angular velocity 0 about a frictionless vertical axle. A second cylinder, with moment of inertia I2, initially not. rotating, drops onto the first cylinder (Fig. P8.73). Because the surfaces are rough, the two cylinders eventually reach the same angular speed . (a) Calculate . (b) Show that kinetic energy is lost in this situation, and calculate the ratio of the final lo the initial kinetic energy. Figure P8.73
Why is the moment of inertia of a hoop that has a mass M and a radius R greater than the moment of inertia of a disk that has the same mass and radius? Why is the moment of inertia of a spherical shell that has a mass M and a radius R greater than that of a solid sphere that has the same mass and radius?
A disk of mass m , radius R , and area A has a surface mass density =mrAR (see the following figure). What is the moment of inertia of the disk about an axis through the center?
Four objects are held in position at the corners of a rectangle by light rods as shown in Figure P8.37. Find the moment of inertia of the system about (a) the x-axis, (b) they-axis, and (c) an axis through O and perpendicular to the page.
Figure P10.41 shows a side view of a car tire before it is mounted on a wheel. Model it as having two side-walls of uniform thickness 0.635 cm and a tread wall of uniform thickness 2.50 cm and width 20.0 cm. Assume the rubber has uniform density 1.10 103 kg/m3. Find its moment of inertia about an axis perpendicular to the page through its center. Figure P10.41
Figure OQ10.6 shows a system of four particles joined by light, rigid rods. Assume a = b and M is larger than m. About which of the coordinate axes does the system have (i) the smallest and (ii) the largest moment of inertia? (a) the x axis (b) the y axis (c) the z axis, (d) The moment of inertia is the same small value for two axes, (e) The moment of inertia is the same for all three axes.