-) In the mcasurement of surface reughness, the height of 10 successive peaks and valleys over datum line were found to be 45, 30, 42, 25, 40,25, 35, 24, 35 and 18 pum. If these measurements were obtained on 10 mar Tength, determine the values of surface roughness by center line average ELA), root mean square (RMS) and ten point height (Rz) methods. th thickness? DesCribe any

-) In the mcasurement of surface reughness, the height of 10 successive peaks and valleys over datum line were found to be 45, 30, 42, 25, 40,25, 35, 24, 35 and 18 pum. If these measurements were obtained on 10 mar Tength, determine the values of surface roughness by center line average ELA), root mean square (RMS) and ten point height (Rz) methods. th thickness? DesCribe any

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

As8 Assuming that this is the FIRST onland discovery on island (meaning: we do not have a similar reserve discovered and developed earlier in the neigbouring areas), out of the general 4 methods of evaluating the OOIP, which method should be directly eliminated?Why?
When calculating the youth's modulus, don't we need to calculate from the slope? E = (0.285949012 - 0.067655044) / (0.01219802 - 0.001861386) Shouldn't it be this way? Or is it calculated based on a single point as you did?
The thermal conductivity of a fluid is 0.09 BTU/ft-h-F having a kinematic viscosity of 0.0215 ft2/h. If the density and specific heat at constant pressure are 53 lbm/ft3 and 0.43 BTU/lb-F, respectively, determine the Prandtl number. Correct Answer: 5.44 ± 0.1
1.A cylindrical shaft of radius 5 cm is rotating at a speed of 50 rad/s in a cylindrical bearing . Shaft and bearing are concentric . The lubricant of viscosity 0,6 Pa s and SG= 0,9 completely fills the clearance between shaft and bearing surface. Take clearance as 0,5 cm and length of shaft as 10 cm . The lubricant flow is laminar steady and uniform .The lubricant flow rate in kg/s is ? ANSWER: 1,767 kg/s 2.A cylindrical shaft of radius 5 cm is rotating at a speed of 50 rad/s in a cylindrical bearing . Shaft and bearing are concentric . The lubricant of viscosity 0,6 Pa s and SG= 0,9 completely fills the clearance between shaft and bearing surface. Take clearance as 0,5 cm and length of shaft as 10 cm . The lubricant flow is laminar steady and uniform . Frictional force on shaft surface is ? ANSWER: 9,42 N 3.)A cylindrical shaft of radius 5 cm is rotating at a speed of 50 rad/s in a cylindrical bearing . Shaft and bearing are concentric . The lubricant of viscosity 0,6 Pa s and SG=…
1.A.)A cylindrical shaft of radius 5 cm is rotating at a speed of 50 rad/s in a cylindrical bearing . Shaft and bearing are concentric . The lubricant of viscosity 0,6 Pa s and SG= 0,9 completely fills the clearance between shaft and bearing surface. Take clearance as 0,5 cm and length of shaft as 10 cm . The lubricant flow is laminar steady and uniform .The lubricant flow rate in kg/s is ? ANSWER: 1,767 kg/s
For the given question and solution, Why is taux'y' after the 25 degree rotation = positive Rsin(phi) = 1.05MA instead of negative Rsin(phi) ? how can i determine the sign convention after rotation? i get mixed up with the sign convention of the shear stress after rotation.
DIRECTION: Identify the following term. 1. It can be applied to a body as distributed or concentrated surface loadings, or as body forces that act throughout the volume of the body.
A tentative rule was given about tipping in Testing Experiment Table 8.4, where if a vertical line passing through the object's center of mass is within the object's area of support the object does not tip. According to the rule, the full box of crackers in the following experiment, which has a width of 13 cm and a height of 20 cm, was seen to tip at an angle of: θc=tan−1(13 cm/20 cm)=33∘θ According to the rule, at what angle will a box with the left half filled with crackers begin to tip? Assume the box is light-weight and that the contents remain in the configuration in
Select the letter of the correct statement. Write the answer with calculations, drawing, rules or explanation 2-) A scientist suggests the following correlation be used for square tubes in a liquid cross-flow situation (Nu = 0.102 Re0.675 Ppl/3). Water (k = 0.61 W/m.K, Pr= 6) flows across a 1-cmsquare tube with a Reynolds number of 10,000. The convection heat transfer coefficient is:(A-) 5.7 kW/m?.K(B-) 8.3 kW/m?.K(C- ) 11.2 kW/m?.K(D-) 18.1 kW/m?.K.
Q4(1).State the salient features of the Pakistan Environmental Protection Act (PEPA) 1997.
The city of Minneapolis, Minnesota is trying to assess the hydrologic impact of the conversion of a 2 acre grass field to a parking lot on surface runoff from a 10 year return period 4-hr duration storm event. (a) Determine the difference in surface runoff volume in inches for these two land types. Assume an antecedent moisture condition II and a hydrologic soil group B for a lawn in good condition with greater than 75% cover. (b) If the city wanted to collect all this excess surface runoff in a settling basin (i.e. the additional water generated from the parking lot). determine the capacity of this settling basin in cubic feet
Please evaluate the shape factor and answer part c)