Answered: In the shown circuit if the currents…

In the shown circuit if the currents i,(t) = 15 cos (20t-45°) mA and iz(t) = 8 sin (200t +30) mA, the total energy stored in system at t = 0 is : %3D %3D

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 2PP: Assume that the current flow through the resistor, IR, is 15 A; the current flow through the...

See similar textbooks

Related questions

Q: In an electrostatic voltmeter the full scale deflection is obtained when the moving plate turns…

Q: An uncharged 0.2 μF capacitor is driven by a triangular current pulse. The current pulse is…

A: Write the expression for the current at different intervals.

Q: A circuit whose resistance is 20 Ω and inductance of 10 H has a steady voltage of 100 V suddenly…

Q: A resistance of 100 Ω, an inductance of 0.1 H, and a capacitance of 5(10 −5 ) F are connected in…

A: Explanation: The resistor, inductor, and capacitor are connected in series Given that, ω = 377 So…

Q: 1,3 ka my 7k2 マエL 3Vc 9mH 1,1 k-2 Ve 18 1,7K2

A: Given the circuit is in steady state

Q: The current source in the circuit shown generates the current pulse i(t) = 0, i(t) = 8e-300t t 0…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: Given L1 6µH, L2 6µH and the equivalent inductance of the circuit Leg = 9.6000µH, then L = μΗ Note:…

Q: For the circuit of figure below, determine i(f), v¿(t), v(f), the energy stored in the capacitance,…

A: Write the expression for the current in the circuit.…

Q: Figure Q2(b) shows the time domain circuit with the voltage source, v,(t) is 25 cos 100t V. The…

A: The solution is given below

Q: In a single graph, sketch v=100 cos(ωt+ϕ) versus ωt for ϕ=−60∘, −30∘, 0∘, 30∘, and 60∘.1. State…

A: (a) Referring to the given signal, the graph of the function with respect to the frequency component…

Q: The voltage across a 10-μ H inductance is given by v( t )=5 sin( 10 6 t ) V. The initial current is…

A: The current through the inductor is expressed as:

Q: Ri Re The circuit is at steady state. R1 = 2 ko, R2 = 3 kQ , L = 30 H, C = 15 µF, and V1=50 Volts…

A: The circuit as mentioned is in a steady state hence we can conclude that 1. The inductor acts as a…

Q: 4. If the current flowing through a 75 mH inductor has the waveform shown in figure 3, (a)sketch the…

Q: 3. Write the equation for capacitor voltage, v(t)=V0e−t/τ, for t≥0

A: Consider the RC charging circuit as shown in the figure below: The figure shows the RC circuit…

Q: (c) From Figure Q2(c), calculate the time domain steady state expression for v, i,, and iz when i, =…

Q: df Find the expression for the voltage and current of both the capacitor and the inductor as a…

Q: Please answer (b)-(d) NOT A

A: The maximum energy stored in the capacitor, the time interval of power transferred to the capacitor,…

Q: 8.3.3 For the RLC circuit shown in the image below, if R1 = 7 2 and R2 = 7 2, C = 0.36 F, and the…

A: We need to find out voltage across resistor in given circuit.

Q: If the current flowing through a 75 mH inductor has the waveform shown in figure 3, (a)sketch the…

A: In this question, We need to determine the voltage waveform if current waveform is given in the…

Q: If the current flowing through a 8 H inductor is given by i(t) = 4cos() A, 709 How much energy is…

Q: Problem 3 Determine the steady-state voltage v(t) when it is subjected to a waveform shown below.…

Q: . The current drawn by the series circuit is given by i = 12 sin (wt + 7n/6) + 4.5 sin (3wt n/6) +…

Q: Problem 8.3-4 4 Ohms 15 Ohms 72 V i(t) |3 2 H i 2 at This circuit is at steady state when the switch…

A: Here inductor current is given and we have to find E,F a solve it as below

Q: Compute the equivalent capacitance of the network

Q: An inductance of 1 H, a resistance of 400 S2 and capacitance of 5 x 10º F are connected in series…

A: First we will find out total impedance in polar form then we will find out the current we

Q: From Figure Q2(c), calculate the time domain steady state expression for v, i,, and iz when i, = 10…

Q: If the voltage across a 28 F capacitor is 13 te3t v, calculate the power at t = 11 ms .Write your…

Q: The relaxation time of mica (o = 101 mho/m, &, = 4) is 7.36 hrs 4.912 hrs 9.82 hrs 2.456 hrs

A: Given Data: conductivity = 10-15 relative permiability = er = 4

Q: t in an 8 µH inductor is given by i(t) = 3t + 2 A. What is the value of the inductors voltage at t =…

A: In this question we need to find a value of the inductors voltage at t = 2 sec.

Q: The voltage at the terminals of the 0.6 µF capacitor shown in the figure is 0 for t <0 and 40e…

Q: Given: Vs The circuit below is under steady DC conditions. 100 mF 2Ω 4Ω Vs V( 4Ω 2 H; Find the…

Q: a functioh of time? 1 102 Q.31: For the electric circuit shown in the figure beside, the switch has…

Q: The current source in the circuit shown gener- ates the current pulse 6.1 v34 mH iç(t) = 0, t < 0,…

Q: One of the three elements shown below is a resistor, one is a capacitor and one is an inductor.…

A: If v(t) is the voltage applied across a resistor and if i(t) is the current flowing through it, then…

Q: At time t = 0+, the circuit on the right has i,(0+) = 6.5A ic iL and vc(0+) = 260V. Determine the…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: circuit with an inductance of 0.1 henry, a f 10 ohms, and a capacitance of 250(10 d the steady-state…

Q: Q.3 (a) Figure Q.3a illustrates a circuit for representing an electrical system consisting of…

A: Brief description: From the given question it is very clear that here we have an electrical…

Q: The circuit Figure QI(b) have an initial voltage, Vo = 0 V and initial current, I. 1A. (b) (i)…

Q: For the circuit shown below (a) Determine the Norton equivalent circuit excluding the inductor. (b)…

Q: 1 A series RL circuit has a voltage E = 100V applied at t 0 by closing of a switch. %3D %3D If R =…

Q: 1. For the circuit shown in Figure 1; a) Find the steady-state expression for vo(t) if i,(t) = 25…

Q: The voltage v(t) = 12 cos(377t + 20°) is applied to 20 mH inductor as %3D shown in figure. The…

A: Given values are - vt=12cos377t+20oV=12∠20oVL=20mHω=377 Given circuit is -

Q: Q.42: For the circuit shown, the switch is i(t) opened at t=0. Detemine i(t) & v(t) for 45V t20 if…

A: In d.c. analysis, under steady state condition a capacitor will behave as OPEN CIRCUIT. The voltage…

Q: Figure Q1(a) shows the voltage across a 10 µF capacitor applied across the terminals, v(t). Predict…

A: In this question, We need to determine the current across the capacitor Ic = C dv/dt Plot the…

Q: For the circuit shown in the following figure, if L= 28 H, Vo=13 V, and R= 28 Q, answer the…

A: In the circuit given data is- L=28 HV∘=13 VR=28 Ω In Laplace domain-…

Q: H.W: Two currents i, and iz are given by the expressions i = 10 sin(314t + t/4) amp. and iz = 8…

A: Given expressions of the currents, i1=10sin314t+π4 ampi2=8sin314t+π3 amp

Q: 3. The circuit is at steady state before the switch opens at time t = 0. The current v(t) is given…

Q: 1. In a circuit with impressed voltage &(1) and inductance L, Kirchhoff's first law gives the…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: For the circuit shown in the following figure, if L= 20 H, Va-28 V, and Re 20 0, answer the…

Question

In the shown circuit if the currents i,(t) = 15 cos (20t-45°) mA and iz(t) = 8 sin (200t +30)
mA, the total energy stored in system at t = 0 is :
%3D
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

H5. An RCL circuit connected in series has R = 180 ohms, C = 1/280 farad, L = 20 henries, and an applied voltage E(t) = 10 sin t. Assuming no initial charge on the capacitor, but an initial current of 1 ampere at t = 0 when the voltage is first applied, find the subsequent charge on the capacitor at t=0.5. Use 4 decimal places.
A 0.010 H inductor is connected to a voltage source whose expression is e=311sin (377t+ pi/2) V. Write the expression for current.
Which statement best describes creating a circle? A. A place slices a double-napped cone parallel to the side (generator)B. A plane slices a double-napped cone parallel to the axis of symmetryC. A plane slices a double-napped cone paralell to the baseD. A plane slices a double napped cone neither parallel to the base nor perpendicular to the axis of symmetry
The voltage across a 10-μ H inductance is given by v( t )=5 sin( 10 6 t ) V. The initial current is i( 0 )=−0.5 A. Find expressions for the current, power, and stored energy for t>0. Sketch the waveforms to scale versus time
Find the numerical value of the capacitance per unit length of two long parallel wires (both parallel to the x axis in the xy plane), each with radius 1 mm, with their centers separated by 4 mm. Express your answer in picofarads per meter. You may assume the wires are perfect conductors.
Find the impedance theoretically of a wire if it carries the frequency 10 kHz have a voltage is 8v, the current is 2mA, resistance is 12 kΩ , inductance 27 mH and capacitance 0.2 µf
A resistance of 100 Ω, an inductance of 0.1 H, and a capacitance of 5(10−5) F are connected in series.If the total electromotive force is given by 110 sin 377t, such that at t = 0,Q = 0, and i = 0, find thecurrent for t > 0.
3. Write the equation for capacitor voltage, v(t)=V0e−t/τ, for t≥0
The voltage and current at the terminals of the circuit element are zero for t<0. For t≥0 they are v=(1500t+1)e−750t V,t≥0;i=40e−750t mA,t≥0. Find the total energy delivered to the circuit element inmicrojoules.
In a single graph, sketch v=100 cos(ωt+ϕ) versus ωt for ϕ=−60∘, −30∘, 0∘, 30∘, and 60∘.1. State whether the voltage function is shifting to the right or left as ϕbecomes more positive.2. What is the direction of shift if ϕ changes from 0 to −30∘?
COURSE: Electrical EngineeringSUBJECT: Electrical ApparatusINSTRUCTIONS:• Write the GIVEN with their respective symbols and units.• Do not skip the SOLUTIONS, do it step-by-step with their respective symbols and units• Round up to 3 three decimal places the FINAL ANSWERS and BOX it. PROBLEM:A capacitor in series with a 66 Ω resistor is connected to a 120 V, 60 Hz source. If the impedance of the circuit is 116 Ω, determine the size of the capacitor.
Question 6 Given a formula for i(t)=10sin(200pit+pi/8) across a capacitor (C=5microfarads). Find the expression of the voltage v(t) across the capcitor. Where Im confused is after integrating the Current and dividing it by C=5microfarads do we need to add +K at the end of the expression? Full explainthe this question very fast solution sent me step by step Don't ignore any part all part work u Text typing work only not allow paper work ......