. The current drawn by the series circuit is given by i = 12 sin (wt + 7n/6) + 4.5 sin (3wt n/6) + 2.8 sin (5wt - n/3) A consisting of resistance of 10 0, an inductance of 60 mH and a capacitor of 100 uF. Derive an expression for the applied voltage for the circuit. Find also the power dissipated in the circuit. Take w-314 rad/sec

Q: Cdcu late a(ID of the CR3) by using Thevenins fheorm

A: The thevenin's equivalent circuit is used to reduce the complex circuit into single voltage source…

Q: 8. What is the minimum conductor ampacity, overload protection, and dual-element fuse  rating for a…

A: Given information: The full load current of the motor according to the nameplate is 115 A.

Q: EX2: (Buck dc-dc converter. Evaluation of the output voltage ripple) A buck converter has the…

A: In this question we will find output voltage, maximum and minimum inductor current and output…

Q: What is transformer ?

A: Transformer A transformer is a device that transmits electric energy at a high frequency. AC is the…

Q: Explain the operation of an ideal diode

A: In this question we will explain operation of an ideal diode....

Q: A galvanometer is rated to have a sensitivity of 80mA/cm.What will be the change in reading when the…

A: Given a galvanometer is rated to have a, Sensitivity = 80 mA/cm Current reading = 500 mA

Q: Q2: A PMMC(Galvanometer instrument) has a resistance of 1002 and FSD for a current of 400Aµ. A shunt…

A:

Q: In a PCM system, 128 levels are present in the uniform quantizer. How many bits per sample are

A: Given information: In a PCM system, the number of levels present in the quantizer is 128.  The…

Q: 1. Determine Vo I, for the networks below.

A:

Q: 1.Methods of generating SSB (include the block diagram) Filter method Phase shift method Weaver…

A: 1. NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: A) Design with drawing an Op-Amp series voltage regulator to give a regulated O/P voltage of 12V for…

A: Condition for Op-Amp series voltage regulator design The rating of Zener should be less than the…

Q: PSPICE The switch in the circuit in Fig. P8.460 has been in position a for a long time. At MULTISIM…

A:

Q: Given the multistage cascaded amplifier system below. L2 A2 P. P L1 P; = 35 mW, L, = 7.1 ft., L2 =…

A: The solution is given below

Q: The data points on a constellation are at (2,0) and (6,0). Draw the constellation diagram.Show the…

A: According to the question, the data points on a constellation are at (2,0) and (6,0). Draw the…

Q: (b) Referring to block diagram model shown in Fig. Q1(b), obtain the transfer function C(s)/R(s) by…

A:

Q: O Derive the state table and draw the state graph for the following logic circuit : DA Q A DB B A…

A: Please find the detailed solution in below images

Q: can you please xplain how 2/8*20 is part of the answer  can you go over the process A again Iam…

A: In part (a), the total current delivered by the voltage source is calculated. From the figure, it is…

Q: Consider a pn junction in forward-bias at room temperature. To obtain a current of 1mA with a…

A: Given: A p-n junction under forward bias condition is having ID=1 mAVD=750 mVVT=26 mV

Q: 1. For the voltage-divider bias configuration, using the approximate approach determine: a. IBQ b.…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Calculate the power dissipated in a 560 Q resistor if the resistor is applied to a network, which…

A: Given: Resistor, R=560 Ω Voltage supplied, V=15 V

Q: circuit comprises of a coil (resistance of 20W, inductance of 400mH), and a capacitor of 2.0mF…

A:

Q: Q2 An AM modulator has 50% modulation index ,if the message signal was m(t)=3 sin(wmt) – 2…

A:

Q: What resistance value for resistor Ro would maximize the power it dissipates? 10 k2 Ro 3 V +1

A: Given circuit:

Q: (b) The input waveform for the clamper circuit configuration in Figure 3(b) is shown in Figure 3(a).…

A: The solution is given below

Q: (a) The BJT and FET are the types of transistor that were used as switches and amplifier in…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What is the mass of a proton?

A: Given: Proton

Q: 3Draw the state table and state graph for the following logic cirail A CLK

A:

Q: Explain the effect of increasing the armature voltage on the behavior of the shunt wound machine…

A: The shunt machine (generator) circuit can be represented as: The EMF equation will be,…

Q: Evaluate the first and second derivatives of the function z=2x4+3x3+2x-5 when x = 4. ii, Find the…

A:

Q: D11.2. Let H, = (21-40 a, - 3/20 a,)e-/0.07 A/m for a uniform plane wave traveling in free space.…

A: Solution- Given, Hs = 2∠-40°ax-3∠20°aye-j0.07z A/m Solution- a) ω -     It is given that uniform…

Q: Which NEC table is used to determine the full-load current of a torque motor?

A: Different types of motor have different NEC tables to determine full load current.

Q: A PMMC instrument gives 27 mA at full scale reading when a potential difference across its terminals…

A: Given: For PMMC Im=27 mAVm=38 mV So, meter resistance Rm=VmIm=38 mV27 mA=1.407 Ω

Q: The effective primary and secondary resistances of a 500 kVA, 12000/2400 volt 60 cycle transformer…

A: First calculate effective resistance resistance at secondary side and then find cupper loss of the…

Q: 2 Draw the state table and state graph for the followineg logic Cirast X- TA A B Dy cLK

A: The solution is given below

Q: 18V Cga = 2 pF Cas = 4 pF Cas = 0.5 pF Gwi = 5 pF Cwo = 6 pF 1.8kA 0.47UF-POL vo Ipss = 12 mA V, =…

A: Given

Q: 8.57 Use nodal analysis to find I, in the circuit in Fig. P8.57. 6/0 v 10 12/0 V

A: Solution-    KCL at 2 supernode and then,     Va-Vc =6 V ...............................1Vd-Vc =12…

Q: Q5- If x = [3 2 1] and h u(n- 1)-u(n-4) Evaluate y[n] = x[n] * h[n] by the 2 %3D ways.

A: We are supposed to be answer of first question as per guidelines.

Q: 49. Use a Karnaugh map to simplify cach expression to minimum POS form: (a) (A + B+ C+ D)(A + B+C+…

A:

Q: A piece of silicon doped with Boron experiences an electric field equal to 0.1 V/um. Calculate the…

A: Given, Electric field, E=0.1 Vμm Mobility of electron, μn=1000 cm2V.s Mobility of holes, μp=300…

Q: 6. For the circuit shown, use source transformations to obtain an equivalent circuit as seen by the…

A:

Q: . A 480/120 V, 5kVA two winding transformer is to be used as an autotransformer to supply power at…

A:

Q: 5- Determine an alternative method for implement the full-adder. Hint: Write the expressions of the…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: 10A i1 V i2 A0 i2 13 14 20/0° V : :-2.5A 21, At node 2: i2+i4 =i3 V1-V2 + 2i, =V2 ...(3) j4 j2 but i…

A: The solution is given below

Q: The standard unit to measure luminous intensity is called and the symbol is given by Degree…

A: Luminous intensity:  It is defined as the ratio of Luminous flux emitted by a source to the per unit…

Q: The eddy-current loss in a 6.9 kV, 50 Hz transformer is 220 W. What will be the eddy-current loss of…

A:

Q: The gain of an inverting active bandpass filter is given by : -R2/R1. What should be done for the…

A:

Q: 8.72 Using loop analysis, find I, in the network in Fig. P8.72. 12/6'v 2/0 A jin

A:

Q: For the following Equation (A+B) (A+C) = A+BC 1-Prove that the L.H.S equal to R.H.S via the truth…

A: Given (A+B)(A+C) = A+BC

Q: no load current of a transformer

A:

Q: 52. Convert each of the following POS expressions to minimum SOP expressions using a Kamaugh map:…

A:

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.