In the transformer shown in the figure below, the load resistor on the right-hand side, RL , is 50 Ω. The turns ratio N1 :N2 is 5:2, and the average source voltage on the left-hand side, Vs , is 80 V. If the average voltage across the load resistor RL is 25 V, what is the source resistance, Rs , on the left-hand side?

Q: The ratio of the number of turns in the primary to the number of turns in the secondary of a…

A: The primary winding and the secondary winding are the two windings found in transformers. The coil…

Q: A 1.75 μF capacitor is connected as in the figure to an ac generator with εm = 40.0 V. What is the…

A: Given Capacitor  = 1.75  μF εm = 40.0 V To find out  Amplitude of the resulting alternating current…

Q: An ideal transformer has N1 windings in the primary and N2 windings in its secondary. If you double…

A: Let the ideal transformer from given conditions, having The number of winding in the primary coil is…

Q: A step-down transformer operates on a 2.5-kV line and supplies a load with 80 A. The ratio of the…

A: secondary voltage

Q: An AC source (Vrms = 88.3 V, frequency f = 46.9 Hz) is connected to the primary coil of a…

A:

Q: ★★ To reduce the 120. V AC voltage to 12.0 V AC to operate a standard doorbell, a step-down…

A:

Q: The 380-turn primary coil of a step-down transformer is connected to an ac line that is 120 V (rms).…

A: Given  Numbers of Turn in primary coil  Np=380 turn Primary voltage Vp=120 V Secondary coil Voltage…

Q: what will be the voltage output of the secondary? what current flows in the secondary circuit? now…

A: Given: Number of turns in the primary  Np= 100           Number of turns in the secondary  Ns = 1000…

Q: R, AV, N RL. 00

A:

Q: Following graph is obtained when AC passes through Voltage Current 7/2 3n/2 wt O a. resistor and…

A:

Q: A transformer on a pole near a factory steps the voltage downfrom 3 600 V (rms) to 120 V (rms). The…

A: (a) The power delivered to the primary coil is

Q: A transformer is rated at 803W and transforms a higher AC V rms to 316V-AC. the number of turns in…

A:

Q: A 57.00 resistor is connected as in the figure to an ac generator with Em = 25.0 V. What is the…

A:

Q: An ideal transformer is connected to Vi=220 Volts AC source and also supplies V2=11 Volts on a…

A: Given  For ideal transformer,  V1 = 220 Volts  ( source voltage) V2 = 11 Volts  ( device voltage)…

Q: The 3.2-MV AC electricity from a power transmission line is fed into the primary coil of a…

A:

Q: A 50.0ohm resistor is connected  to an ac generator with e= 30.0 V.What is the amplitude of the…

A:

Q: An ideal transformer has N1 windings in the primary and N2 windings in its secondary. If you double…

A: Given data The number of winding in the primary coil is N1 = N. The number of winding in the…

Q: A 100 kVA/50HZ single phase transformer has 400 turns on the primary and 40 turns on the secondary.…

A: Solution:

Q: A 45.1 mH inductor is connected as in the figure to an ac generator with εm = 30.0 V. What is the…

A: (a) Write the expression for the amplitude of the resulting alternating current .

Q: Consider a transformer where the secondary winding is connected in series to a resistor with…

A:

Q: An AC source (Vrms = 55.2 V, frequency f = 43.7 Hz) is connected to the primary coil of a…

A:

Q: A transformer has a primary coil with 500 turns of wire and a secondary coil with 2,000 turns. An AC…

A:

Q: What is the impedance of a 1.50@kΩ resistor, a 135-mH inductor, and a 22.8@mF capacitor connected in…

A: Given: Resistance = 1.50 kilo ohm inductance = 135 mH capacitance =22.8 mF frequency of the ac…

Q: A 100-mH inductor is connected to a 110-Vmax ac source at a frequency of 30 kHz. The max current in…

A:

Q: An inductor is connected to an ideal ac power supply. The phase angle between the current and…

A: For a pure Inductive circuit: The phase angle of an inductor's resistance to current is 90°,…

Q: Consider a transformer with a turn ratio of 2:5 that is connected to a 50-V AC source at its primary…

A:

Q: A 63.0 Q resistor is connected as in the figure to an ac generator with cn= 45.0 V. What is the…

A: (a) Calculate the maximum current. Imax = em/R        = 45/63        = 0.7143 A Hence, the amplitude…

Q: A transformer has a primary coil with 325 turns of wire and a secondary coil with 650 turns. An AC…

A:

Q: A person is working near the secondary of a transformer, as shown in the figure below. The primary…

A:

Q: An AC transformer in Okahandja operates at input voltage of eight-and-a-half kilo-volts to suppy 120…

A:

Q: State two ways to produce a higher emf in an ac generator?

A: The two ways to produce a higher electromotive force (emf) in a ac (alternating current) generator…

Q: An ideal transformer is used to either increase or decrease the voltage in an AC circuit. When the…

A: Scenario - An ideal transformer uses mutual induction principle to induce voltage on secondary coil…

Q: A neon sign achieves high voltage with a transformer with 300 primary coil turns. The rms voltage…

A:

Q: What relationship exists between a coil's inductance value and the amount of emf or voltage it…

A:

Q: Consider the circuit shown in the figure.  If the peak voltage of the AC source is VAC max = 100 V,…

A: Given:- vAC max = 100 v N1 = 80 turns N2 =120 turns R = 40 ohm

Q: A 47.2 mH inductor is connected as in the figure to an ac generator with Em = 30.0V. What is the…

A: in this question we determine  current by using  I = V / XL where,  V = voltage  XL = ωd​L= 2πfd​L…

Q: The drawing shows three ac circuits, as shown below, each connected to entical generators Suddenly,…

A: When the frequency is doubled but its maximum voltage remains the same, the voltage across the…

Q: A transmission line that has a resistance per unit length of 4.30 x 104 n /m is to be used to…

A:

Q: What is the amplitude of the resulting alternating current if the frequency of the emf is (a)0.889…

A: We know the  Alternating Current in the circuit, I=ξmxc =ξm1wc=wcξm where, Xc=capacitive reactance…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.