In this question, make Karnoff maps and draw the electrical circuit

Q: B) Draw the External characteristics of different self-excited d.c generators

A: Different types of self-excited DC generators: 1) Shunt generator 2) Series generator 3) Compound…

Q: α. be W 1Ω 1.22 Μ M 4ΩΣ 4Ω 8Ω 6Ω M M 4Ω 80, 4Ω M M ΕΩ

A: Resistance: It is a property of a material that resists the flow of the current in it. It is denoted…

Q: What is the potential difference (voltage) across capacitor C3 in the circuit below?

A: In parallel circuit the voltage across the components are same.

Q: Maximum end-end throughput. Consider the scenario shown below, with 10 different servers (four…

A: Throughput is measure the send data through a network. Delay depends the number of host and…

Q: B. Find the receiving impedance

A:

Q: Sketch DC and ac equivalent circuits and theoretically Analyze DC and ac analysis of a Single Stage…

A: The given circuit is as shown below,

Q: The cutoff wavelength of a step index fiber is quoted as λ = 1.20 µm. If the fiber is operated at…

A:

Q: e block diagram shown

A: Transfer Function-It is the ratio of output to input of a system in the Laplace form of the system…

Q: In the single-phase, three- winding, transformer, the primary current is equal to lo at the…

A: In this question we need to choose a correct option

Q: To modeling separated excited DC motor by transfer function, you need to the math operation library…

A: The individual blocks in a block diagram representation of a system is known as gain blocks. The…

Q: 21) Determine the input and output impedances for the amplifier circuit below. Assume that…

A: Amplifier: Amplifier increases the current, power or voltage of a signal. this is a electronic…

Q: Given the magnetic field vector potential: A=2r cose ar-3r sine a0 (A/m), find at point P (1,5,7):…

A: Current density J: When a current is passing through the cross-sectional area of a material. Then…

Q: 6. Find the characteristic impedance expression in terms of the inductance and capacitance…

A: In this question,  We need to choose the correct options What is characteristics impedance of the…

Q: Review Questions: 1- Design a 4x1 Mux. Using enable Pin line at low active?

A: As per the guidelines of bartleyby I need to answer first question only ¹so kindly repost other…

Q: A- for the function below, the domain and the range is respectively y = |x|-2

A: Given: Domain and range of y=x-2

Q: Q2) show that: a) ſªx(t)dt ↔ X(f) + X(0)8(ƒ) 2πJf 2 b) if x(t) = x(-t) (even symmetery) then all the…

A: For the above given equations we need to derive them by the help of fourier transform and fourier…

Q: VI I₁ = 1 AZ0° IB Y₂ Y₁ IA Y3 Y₁ = 0.5 S Y₂ = -10.5 S Y3 = +1 0.25 S FIGURE 19-22 Now, substituting…

A: As per Kirchoff's current law,  the net current incoming at any junction will be equal to the net…

Q: a. Determine RTH,VTH and maximum power absorbed by RL in the Figure 1 and Figure b. Draw the…

A:

Q: 1. Determine whether or not each of the following signals is periodic. In a signal is periodic,…

A: In this question , we will find time period of given signal if they are periodic.

Q: 1 A short circuited transmission line of Zo 50 S2 is fed with a 250 V generator. Internal impedance…

A: By using the concept of transmission lines we need to calculate the value of current at the short…

Q: 10 Given the potential V = sin cos p. 2 (a) Find the electric flux density D at (2, 7/2, 0). (b)…

A:

Q: Find V R3 using superposition method, and mesh current analysis method

A: The solution is provided in the following section.

Q: Q2/ A separately excited DC motor with an armature resistance of 2 2 is powered by a chopper from a…

A: In this question we have given  separately excited dc motor supplied by chopper....We have to find…

Q: 8- Auto transformer is used in tuned amplifier to (transform low impedance of transistor input,…

A: 8.) In amplifier transformer is connected instead of collector load which serves as inter stage…

Q: Circuit Diagram Computed Values Compute the expected power factor of the circuit given the different…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power.…

Q: 200 +21. If maximum torque of an induction motor is kg-m at a slip of 12%, the torque at 6% slip…

A: Given: The torque is 200 kg-m The maximum torque slip is sm=12% The objective is to determine torque…

Q: 5. A 240-V rms 60-Hz source supplies a parallel combination of a 5-kW heater and a 30-kVA induction…

A: In this question , parallel connected load is given....We have to find out system apparent power ,…

Q: (1) A 100MHz carrier is deviated 50kHz by a 4-kHz signal. The modulation index is

A: In this question we need to find the modulation index

Q: If A = ax + 3az and B = 5ax + 2ay - 6az, find the angle between A & B 123.65 O 121.65 O 122.65 O…

A: By using concepts of vectors in electromagnetic theory we need to calculate angle between the given…

Q: Q3\Find the response of the current in the circuit using Laplace? 1H i(t) 1F 10V

A: This is the problem of DC transients. Here R, L an C are connected in series. To solve this problem…

Q: A circular ring of radius (a) carries a uniform charge pL C/m and is placed on the zy-plane .the…

A: The electric filed is always perpendicular to the magnetic filed. The electric field from a uniform…

Q: 9. In air, a lossless transmission line of length 50 cm with L=10µH/m, 40PF/m is operated at 25 MHz.…

A:

Q: 1. The circuit below shows a three-phase system with two loads. The delta-connected generator has a…

A: Power factor: It tells how much active power is utilised by the circuit from the apparent power. It…

Q: Explain why higher the load factor of the power station, lesser will be the cost per unit generated

A: Load factor is the ratio of average load to the peak load during a certain period of time. For a…

Q: The electric field at the origin due to electric potential V=(x-2)+(y+2)+(2-1)³ is (4ax-4ay+ 3az) O…

A: We need to find out the electric field for given potential at given point

Q: For static (time-independent) fields, which of the following current densities are possible? (a) J =…

A:

Q: 3. Research on the Thevenin's and Norton's theorem and their relations. Write those findings.

A: Note: As per the policy of company I can solve the first question mentioned in the problem and if…

Q: Q1 a) Find y(t) if x(t)= 1+cos(t) for 0<t<2 and h(t)=u(t-1).

A: In this question,  We need to find the output signal y(t) if input and impulse signal is given.  We…

Q: Consider the given circuit where vs(t) = 12[1+u(t)]V. a) Find the initial conditions i(0-) and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: in the shunt connected DC motor, the equation that calculate field current If is Vf/(Ra+Rf) Va/Ra…

A:

Q: ) A dc shunt machine while running as generator develops a voltage of 240 V at 1000 rpm. on no-los…

A: In this question we will find speed and efficiency of dc motor....

Q: is connected. Determine Foil current and output of transform

A: Transformer is a static device, which transfers electrical energy from one circuit to other circuit…

Q: To modeling separated excited DC motor by transfer function, you need to Trus Fuc block to get the…

A: The separately excited DC motors are types of motors with speed regulation availability. To achieve…

Q: Draw symbols 1.Electric cell 2.key 3.Ammeter 4.volmeter

A: Draw symbols

Q: Question: 2. Using mesh analysis, find vo in the circuit below. 5Α 1Ω 40 V Mw+1) Μ ΖΩ + 10 1 www 4Ω…

A: We need to find out the voltage for given circuit by using of mesh analysis

Q: Make a comparison between the bath and state functions in the following points: 1) relation to path.…

A: The comparison between the path and state functions are given below, 1. Relation to path - State…

Q: Determine the following: a) Design the value of the capacitor C such that it is critically damped at…

A: For the given circuit , the value of capacitor is calculated and expressions For Vc and ic are…

Q: Q2) Draw the output waveforms on top of the input waveforms for the circuits below. For all circuits…

A: In this question,  We need to draw the output voltage waveform of the given op amplifier.  We are…

Q: one of these vectors is an impossible electrostatic

A:

Q: )magnetic flux density (B).(2)magnetic field intensity (H),(3)current density (J).

A: Magnetic field - This line which shows the interaction between the movement of electric charges and…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.