In what ways are gates different from circuits?

Q: Find the impulse response of the system with the following transfer function: Z z² + 3z + 2 Then…

A:

Q: Q4/ Reduce the system shown below by using Masson's method, then convert it to Block diagram. GI H2…

A: The signal flow graph is graphical representation of system.  The SFG is applied to linear system.…

Q: Find the highest sampling frequency fs so that if the signal v(t) = 12 cos(2π125t + π/3) + 18 cos…

A: v(t) = 12 cos(2π125t + π/3) + 18 cos (2π85t)

Q: A 220 V, 15 kW, 850 r.p.m. shunt motor draws 72.2 A when operating at rated condition. The…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: 3. A universal series motor has a resistance of 30 Q and inductance of 0.5 H. When connected to a…

A: An universal series motor is a type of electric motor that can run on both AC (alternating current)…

Q: What values of Lz, Ly, and L3 are required if the two networks in Fig. 13.66 are to be equivalent?

A: The required values of Lz, Ly, and L3 are if the two port networks in the figure given. The dots…

Q: QUESTION 5 Consider the feedback system illustrated: r(t) + s+3 and G(s) = s+10 Which of the…

A:

Q: Chapter 9 problem 1: Find Zeq at terminals a-b of Circuit 10 using Wye-Delta or Delta-Wye…

A: In this question We need to determine the equivalent impedance across the terminal a and b.  We are…

Q: For the sampled signal ws(n) = 12 + 8 cos((1/4)πn + 0.1) + 12 sin((3/4)πn − 0.2) generated by…

A: For the sampled signal ws(n)= 12 + 8 cos{(1/4)πn + 0.1} + 12 sin{(3/4)πn −0.2} generated by sampling…

Q: A dc test is performed on a 460-V A-connected 100-hp induction motor. If Vpc = 21 V and Ipc = 72 A,…

A: It is given that: VDC=21 VIDC=72 A

Q: 3.32 Find I, in the network in Fig. P3.32 using nodal analysis. + 1 ΚΩ Μ + Vr X 12V Figure P3.32 32…

A:

Q: Problem 4 Find the time-domain node voltages v1(t) and v2(t) in the circuit shown in Fig. P4 -j5 n…

A:

Q: = Q2/ Volume charge density is located in free space as pr 2e-1000r nC/m³ for 0 <r<1 mm, and pr = 0…

A:

Q: How many poles are in the right half-plane for the open-loop system of Figure P6.1? [Section: 6.3]…

A: The open loop system is,

Q: 615 The one-line diagram of an unloaded power system is shown in Fig. 6.31. Reactances of the two…

A: Base MVA=50 MVA Base KV=13.8 KV Expression to calculate the reactance on new base MVA &amp; KV,…

Q: A 440-V 50-Hz six-pole Y-connected induction motor is rated at 75 kW. The equivalent circuit…

A:

Q: Design an 8-bit magnitude comparator using 4-bit comparators and other gates.

A: Here, We have to design an 8-bit magnitude comparator using 4-bit comparators and other gates.

Q: Obtain the Thevenin equivalent circuit for the circuit in Fig. 13.83 at terminals a-b. j2 02

A: The given circuit diagram is shown below,

Q: Problem 1 - In the circuit below, apply source transformations and resistance reductions to simplify…

A: The given circuit diagram is shown below,

Q: a. Find I and VR1

A: For the given circuit the value of current I and the voltage across the resistor needs to be…

Q: (g) 2z² – 7z (2-1)(z-3)

A:

Q: The figure shows a common spacing for a 345 kV line using ACSR Drake conductors in bundles of two…

A: The given figure shows a common spacing for a 345 kV line using ACSR Drake conductors in bundles of…

Q: Calculate the peak-to-peak inductor current ripple (in amperes) of a Buck converter assuming it…

A: In this question we need to find the peak to peak inductor current ripple ( in ampere) for the given…

Q: For the Astable multivibrator shown in fig (1); given: R₁=10kQ, R₂-1k2, C-1uF, and the OP-AMP is…

A:

Q: I. USING KIRCHOFFS CURRENT LAW (KCL), FIND THE REQUIRED CURRENT IN THE FIGURE BELOW. a) Find 11 if…

A: In this question we need to find the current I1 shown in the given fig .

Q: The circuit diagram below shows a Boost converter. Vdc A O di dt di L L dt di L Which expression…

A: Here boost converter is given we need to calculate the inductor current expression When neither…

Q: 5.26 Simplify the following expression. T(A, B, C) = (A + B) [Ā(B+C)] + [A(B+C)] + AB + AC

A: TA,B,C=A+BA¯ B¯+C¯¯+A¯.B¯+A¯.C¯

Q: Q5. Find the Laplace Transform of the following: (d) y(t) = 10+5t+ビームピ (e) y(t) = { 54 t ostal tzl

A:

Q: For the circuit shown in Fig Q2, determine the cupfent (lo) and the voltage (Vo) using the basic…

A: Given: A network, To find: The current I0 and voltage V0 using any of the method.

Q: Design a 3 Band Equalizer based on the following requirements. Use standard component values on your…

A: Design a 3 Band Equalizer based on the following requirements. Use standard component values on your…

Q: An LR circuit can be used as a "phase shifter." Assume that an "input" source voltage V = V₁…

A: Output voltage Vo=34 V. Frequency f = 125 Hz. Inductance L = 52 mH. Phase angle ϕ=270.

Q: Find the impulse response of the system with the following transfer function: Z z² + 3z +2 Then…

A: A transfer function of a unit steps input is given G(Z)= Z/(Z2+2Z+2) We need to find the impulse…

Q: The capacitor voltage of the RC circuit depicted in Fig Q3 is denoted by V.(t). Vin R Vc(s) = 1(t) 7…

A: Given Data: An RC series circuit with, Input voltage Vint=t-e-4t Output capacitor voltage = Vct…

Q: c) Find 12 if 13 = 3A, 11 = 5A, 14 = 6A, 15 = -4A & 16 = 3

A:

Q: Q1: Calculate Io in the circuit of Fig. (1) 24 V + Μ Μ 20 Ω 40 Ω Μ 10 Ω 20 Ω Μ Figure (1) Μ Μ 60 Ω…

A: The circuit diagram,

Q: For the signal v(t) = 15 cos(2π225t + π/3) + 10 cos(2π475t + π/2) + 2 sin(2π650t + π/7), if you…

A: Given: v(t) = 15 cos(2π225t + π/3) + 10 cos(2π475t + π/2) + 2 sin(2π650t + π/7) Sampling frequency…

Q: 2. For the linear transformer as shown in figure P-2, a. The mutual reactance (XM)! b. The currents…

A: In this question We need to determine the mutual Reactance, current I1  , I2  and I3  as shown the…

Q: Find the ABCD matrix of the following laser set-up. The plane mirrors centers are equisdant from…

A:

Q: (ii) With no input signal applied to the amplifier, the voltage between the collector and emitter of…

A: According to the question,we need to find the voltage across collector resistor, collector…

Q: Problem 3 - For each of the seven devices in the circuit below, determine whether the device is a…

A: here we have identify which device is supplies power and which device is recipient and voltages.

Q: Consider 100 Ω· = a voltage amplifier with an input resistance, R₁ = 110 , an output resistance, R i…

A:

Q: 1- What can we say about the electric field in a region of space that has a constant potential…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Determine the simplest expression for the system function H(z), given 2®ս[ո] — LTI — u[n] + 2^u[n] +…

A:

Q: the positive , negative and zero sequence reactance of a 20mva,13.8kv synchrounous generator are…

A:

Q: Q4/A) A 3phase 6600V, 6-pole, 50Hz, star connected SM has Zs=0+j3002/phase at rated load la100A at…

A: Given Data: A three-phase, star-connected synchronous motor with, Line voltage VL=6600 V Number of…

Q: A low-pass filter is built of one resistor in series with one capacitor and it produces a 3.3-volt…

A: given here LPF circuit and asked to find the value of C in nF

Q: At cut-off, what statement below correctly describes the operation of a BJT transistor? Select one:…

A: The above question is based on the regions of operation in a BJT. Since nothing else is specified,…

Q: Consider the networks shown in below figure 13 с чие a -120 b Z₁ The ratio between the Z and Z is Zo

A: It is given that:

Q: Probleml1. (a) Design a Lead-Lag Compensator whose general expression is given below for the…

A: The transfer function of a lead-lag compensator is  Gs=Ks+1T1s+γT1s+1T2s+1γT2, its parameters are…

Q: 3. For the network shown in the following figure, find V0 using the following analysis techniques:…

A: here we have to find the voltage V0 by using mesh analysis and superposition theorem