615 The one-line diagram of an unloaded power system is shown in Fig. 6.31. Reactances of the two sections of transmission line are shown on the diagram. The generators and transformers are rated as follows: Generator 1: Generator 2: Generator 3: Transformer T₁: 20 MVA, 13.8 kV, X" = 0.20 per unit 30 MVA, 18 kV, X" = 0.20 per unit 30 MVA, 20 kV, X" = 0.20 per unit 25 MVA, 220Y/13.8A kV, X = 10% Transformer T₂: Single-phase units each rated 10 MVA, 127/18 kV, X = 10% Transformer T₁: 35 MVA, 220Y/22Y kV, X = 10% Draw the impedance diagram with all reactances marked in per unit and with letters to indicate, points corresponding to the one-line diagram. Choose a base of 50 MVA, 13.8 kV in the circuit of generator 1. T₁ ¹000 AY LY B j80Q 3 fany Figure 6.31 One-line diagram for Prob. 6.15. T3 j100 Ω T₂ ²00²0² FYD E
Load flow analysis
Load flow analysis is a study or numerical calculation of the power flow of power in steady-state conditions in any electrical system. It is used to determine the flow of power (real and reactive), voltage, or current in a system under any load conditions.
Nodal Matrix
The nodal matrix or simply known as admittance matrix, generally in engineering term it is called Y Matrix or Y bus, since it involve matrices so it is also referred as a n into n order matrix that represents a power system with n number of buses. It shows the buses' nodal admittance in a power system. The Y matrix is rather sparse in actual systems with thousands of buses. In the power system the transmission cables connect each bus to only a few other buses. Also the important data that one needs for have a power flow study is the Y Matrix.
Types of Buses
A bus is a type of system of communication that transfers data between the components inside a computer or between two or more computers. With multiple hardware connections, the earlier buses were parallel electrical wires but the term "bus" is now used for any type of physical arrangement which provides the same type of logical functions similar to the parallel electrical bus. Both parallel and bit connections are used by modern buses. They can be wired either electrical parallel or daisy chain topology or are connected by hubs which are switched same as in the case of Universal Serial Bus or USB.
Trending now
This is a popular solution!
Step by step
Solved in 4 steps with 1 images
