Indicate whether an error occurred in the following scenario: the receiver gets “001011010” from the sender. The devices are using odd parity, 8-bit data, and 1-bit (LSB) for parity. What if the devices are using even parity?

Indicate whether an error occurred in the following scenario: the receiver gets “001011010” from the sender. The devices are using odd parity, 8-bit data, and 1-bit (LSB) for parity. What if the devices are using even parity?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 38VE

See similar textbooks

Related questions

Q: Q. Take two hosts, A and B, linked by a single R bps connection. Assume that both hosts are…

A: dprop=m/s seconds.

Q: s there an error in the codeword? If yes, which bit(s) is (are) in error?.

A: Hamming code is an error detection and error correction technique. In the hamming codeword sent by…

Q: Q11 (a) In a data link connection where Cyclic Redundancy Check (CRC) is used, an 8-bit information…

A: A crc(cyclic redundancy code) is used in networking to send messages and error checking .

Q: If the IP header length field has value 14 and data bytes are 3500. What will be the value of the…

A: The questions are on finding total length of IP data packet and sending bit pattern of CRC…

Q: In a two-dimensional decimal parity-check which uses check digits, if we receive the following…

A: Below i have answered:

Q: Q4] Fill in the blank round corner rectangulars accoring to the NAT table: 30 RI 126.119.40.182:25…

A: Given the IP addresses of the network is 192.168.1.1, 192.168.1.2, 192.168.1.3 router interface is…

Q: Visit the Queuing and Loss applet at the companion Web site. What is the maximum emission rate and…

A: The maximum emission rate =500 packets/sec The maximum transmission rate =350 packets/sec The…

Q: 1-Assume that you are using even parity equivalent to a 7-bit ASCII. How will the word IPv4 be…

A: Dear Student, as per our policy, in a single question we can answer its 3 sub-parts. So for the…

Q: Answer all three parts. No plagiarism. (a) What is the overhead of a standard even parity in terms…

A: The even parity is given in the question. in standard even parity a 57% increment in transmission…

Q: Consider a noiseless communication system over a transmission medium with transmission rate 10…

A: The answer is...

Q: Find the output port for packets with the following destination addresses: Packet 1: 7176Packet 2:…

A: Solution: Packet 1: 2 Packet 2: 3 Packet 3: 3 Packet 4: 2

Q: Question 22 Answer the following questions: 1. How does a station using CSMA protocol knows that a…

A: "Since you have asked multiple questions we are solving the first 2 for you . If you want an answer…

Q: re involved in the implementation of pure aloha protocol with the help of the following terms: T…

A: Elaborate the procedure involved in the implementation of pure aloha protocol with the help of…

Q: Describe the problem that APR helps to solve Why is the query message typically sent to the…

A: The question given is miss spell with APR which actually is ARP. Corrected this question. Answering…

Q: ndicate whether an error occurred in the following scenario: the receiver gets “001011010” from the…

A: Solution)The bits of parity depends on the total bit count of 1, and the parity bit is determined as…

Q: Which of the following are methods for error-detection within the link layer. OLogical Sequence…

A: When sender sends data to the receiver ,the data(bits) might get corrupted during the transmission.…

Q: (a) Find CRC code for message bits to be transmitted which is 11001110 with generator value 1011…

A: There are multiple questions. Here solving only the first question. If you want to solve the second…

Q: In asynchronous transmission, the gap time between bytes is variable why?

A: Asynchronous transmission, the gap time between bytes is "variable."

Q: Assume the sender is aware of a constant round-trip delay between the sender and recipient. Given…

A: Timers are essential for the protocol. In this case, the total delay caused by the roundtrip journey…

Q: Please let us know if any errors occurred in the following scenario. "001011010" is sent to the…

A: The given data bits send by sender is: 001011010 this is total : 9 bits( 8 bit data and 1 bit for…

Q: Asynchronous transmission protocol is configured to use 5 data bits, 1 start bit, 2 stop bit, and 1…

A: Applications: 1. Synchronous Transmission :Used in High speed Transmissions 2. Asynchronous…

Q: A protocol architecture is being used to send a payload of 1,310 bytes over a network. The overhead…

A: protocol overhead = overhead / total bytes sent

Q: Calculate the transmission time of a packet, which is transmitted by a station where the length of…

A: Here in this question we have given a packet which has to transmit by a station.length of the…

Q: Show all the steps to find value of CRC for dataword 10110101 and the divisor (polynomial value) is…

A: A cyclic redundancy check (CRC) is an error-detecting code commonly used in digital networks and…

Q: Consider a message 11100011 and a divisor 110011, then use mod 2 binary division method to…

A: Cyclic redundancy check:- CRC is an error detection algorithm which appends the remainder in the…

Q: UDP and TCP use one’s complement for the checksum. Suppose you have the flowing four 8-bit data in a…

A: Given: we have given Four 8-bit data in a datagram: 1. 1 0 0 1 1 0 1 1 2. 0 1 0 1 1 1 0 0 3. 1 1 0 0…

Q: 4) Suppose we have to transmit a list of five 4 bit numbers that we need to send to a destination.…

Q: uppose that the sender wants to send 4 frames each of 8 bits, where the frames are 11001100,…

A: Checksum at the sender's end:

Q: decimal, and the last 7 digits of your student ID are repeated to form the words of data to be sent…

A: Answer is in given below:-

Q: Q1. (i) Differentiate between Go-Back-N ARQ and Selective Repeat ARQ methods. Explain with example.…

A: Introduction Q1. (i) Differentiate between Go-Back-N ARQ and Selective Repeat ARQ methods. Explain…

Q: iefly explain your answer to each of the following questions. When the window widths of both the…

A: Introduction: Below briefly explain When the window widths of both the transmitter and receiver are…

Q: If your protocol will be a sliding window protocol, how many bits do you need to represent the…

A: Bits for representing sequence numbers The first step is to determine the window size. The round…

Q: UDP and TCP use 1s complement for their checksums. Suppose the receive received two 3-bits payload…

A: According to the question , we have to find UDP and TCP use 1s complement for their checksums by two…

Q: he following questions are true or false, and you should explain your answer to them in a few words:…

A: Ans:- True First, we will see what is SR Protocol? SR Protocol is a selective repetition technique…

Q: Suppose we want to transmit the message 1011 0010 0100 1011 and protect it from errors using the…

Q: Suppose the information content of a packet is the bit pattern 1110 0110 1001 1101 and an even…

A: Given: Bit pattern:1110 0110 1001 1101 Solution: Firstly the given bit pattern is represented as…

Q: a. Fill up the below figure with information about sending packet from sender to receiver and ACK…

A: Solution a) In selective repeat multiple frames can send multiple packets and also receive multiple.…

Q: Two hosts X and Y are connected by a single link. The propagation speed is 3 x 108 meters/sec. Host…

A: Below i have answered:

Q: Kindly give proper explanation Following shows the destination and source address of receiving…

A: Source IP address the IP packet field containing the IP address of the workstation from which it…

Q: Consider a reliable data transfer protocol that uses only negative acknowledgements (NAKS). (a)…

A: A protocol that exclusively employs NAKs is not superior to a protocol that uses ACKs, mainly when…

Q: Any errors in the following scenario would be greatly appreciated. The sender sends "001011010" to…

A: Introduction: A bit of parity, or check bit, is added to a binary code string. Parity bits are a…

Q: If an error happened in the following scenario, please mention whether it occurred. The sender sends…

A: Introduction: In vehicle-to-vehicle (VANET) applications, authentication is a crucial security need.…

Q: Q2/ The following data stream (10011011 11001110 11110000 10001000 11100000 11011010 11111111…

Q: Why does Ethernet put a constraint on the minimum frame length of data payload?

A: We need to explain why does Ethernet put a constraint on the minimum frame length of data payload.…

Q: Please indicate if an error occurred in the following scenario. The sender sends the receiver the…

A: Introduction: Vehicle-to-vehicle (VANET) applications need authentication, which is a critical…

Q: suppose that the information to be sent by a host is 01010101. Which of the following is correct…

A: We have an information bit 01010101. We need to tell that which statements are correct if we use…

Q: Tele-traffic models are usually stochastic. (True / False)

A: Note: Answering the first question as per the guidelines. Tele-traffic models are the models that…

Q: Handling the retransmitted packet for estimation timeout interval. Play with WireShark.

A: Answer of the two lines is below step

Q: What are the propagation time and the ransmission time for a 4.5-kbyte message (an e- nail) if the…

A: Propagation time = distance / velocity = 12000km/2.4*108 = 12*106/2.4*108 = 5/100 = 0.05 sec Or 50…

Question

100%

What communication protocols are used in TESLA cars? Insert the diagram of the one(s) you find.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

If an error happened in the following scenario, please mention whether it occurred. The sender sends the number “001011010” to the recipient. The devices make use of odd parity, 8-bit data, and a 1-bit (LSB) parity for each bit of information. What happens if the devices are utilizing even parity instead than odd? What are the communication protocols that are utilized in TESLA automobiles? Insert the schematic of the one(s) that you have discovered.
In the following situation, kindly mention whether or not there was a mistake made. The number "001011010" is sent to the receiver by the sender. The devices make use of an odd parity, an eight-bit data, and a one-bit (LSB) parity for each bit of data respectively. What results may we anticipate if the devices make use of even parity as opposed to odd parity? What kinds of communication protocols are used by TESLA automobiles? Provide the schematic for the one or ones that you have discovered.
Please say if there was a mistake in the following situation. The number "001011010" is sent to the receiver by the sender. Each bit of data in the devices has a one-bit (LSB) parity and an odd parity. Each bit of data has eight bits. What happens if even parity is used instead of odd parity? What kinds of communication protocols do TESLA cars use? Include the plans for the one or ones you found.
Please indicate if an error occurred in the following scenario. The sender sends the receiver the number "001011010". The devices use odd parity, eight-bit data, and a one-bit (LSB) parity for each bit of data. What happens if the devices use even parity rather than odd parity? What communication protocols are used in TESLA vehicles? Include the schematic for the one(s) you found.
ndicate whether an error occurred in the following scenario: the receiver gets “001011010” from the sender. The devices are using odd parity, 8-bit data, and 1-bit (LSB) for parity. What if the devices are using even parity? What communication protocols are used in TESLA cars? Insert the diagram of the one(s) you find.
Any errors in the following scenario would be greatly appreciated. The sender sends "001011010" to the recipient. For each piece of information, it utilizes 8-bit data with odd parity and 1-bit (LSB) parity. If devices utilize even parity, why don't they use odd parity as well? The communication protocols used in Tesla vehicles may be found on the company's website. Provide a schematic if you have one.
If you see a mistake in the following situation, please mark it. The sender includes the number "001011010" in their transmission. Each bit of data in the devices is encoded with odd parity, an eight-bit data length, and a one-bit (LSB) parity. What would occur if the gadgets used even parity rather than odd parity?Can you tell me about the TESLA vehicle's communication protocols? Please include a diagram of the one(s) you have located.
Tell us if you think the following statements are true or incorrect and provide a short explanation for your vote. When both the sender's and receiver's window widths are 1, the alternating-bit protocol and the SR protocol are equivalent.
True or untrue, and briefly explain why your answer is correct, please answer the following: The alternating-bit protocol is the same as the SR protocol when both the transmitter and receiver windows are set to 1.
Choose "true" or "false" and provide a short explanation for your answer to each of the following: The alternating-bit protocol is equivalent to the SR protocol when the transmitter and receiver windows are both 1.
Choose whether the following statements are true or incorrect and provide a short explanation for your choice. Sender and receiver windows of size 1 are equivalent in the alternating-bit protocol, making it identical to the SR protocol.
Parity bits can identify how many message mistakes at once?