Answered: Inductance, the same way as capacitance…

Inductance, the same way as capacitance and resistance in an AC domain are properties of a. none of the above b. geometry c. frequency

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 99PE: What inductance do you need to produce a resonant frequency of 60.0 Hz, when using a 2.00 F...

See similar textbooks

Related questions

Q: For an AC Generator, describe how an induced current is produced.

A: ways to induce current -1) by moving a coil in M.F.→current can be induced either by moving it in a…

Q: Chapter 31, Problem 065 Your answer is partially correct. Try again. n ac generator provides emf to…

Q: de can function as a clipper and clamper. Compare and ex erences of the output voltage waveform…

A: Clippers reduce the amplitude while clampers shift the DC level. 1 clipper limits the voltage while…

Q: An ac generator is connected to a device whose internal circuits are not known. We only know current…

A: Given data: AC current: I=0.5Acos120πt+π4 AC voltage: V=170Vcos120πt

Q: 1. Derive the expression for the frequency of a LC circuit.

Q: Directions: Solve the problem below using the equation in Faraday's Law of Induction. A small 10 mm…

Q: Capacitors have the opposite effect on AC circuits that inductors have. Explain this statement.

A: The difference in the effect of capacitor and inductors on AC circuits are given below. (a)…

Q: High-frequency noise in AC power can damage computers. Does the plug-in unit designed to prevent…

A: A high frequency noise in AC power can damage computers.

Q: Lesson: Alternating Current System A sinusoidal wave has a frequency of about 79.58 Hz. What is its…

Q: Resistor Inductor Сарасiог Symbol Impedance Table 1: Impedance Figure I: Parallel circuit a) Let A =…

Q: 13. A loud-speaker consists of a cone attached to a current-carrying coil located in a magnetic…

A: This question is based on Electromagnetic induction topic. An electromagnet is a magnet which gets…

Q: A Step-Down Transformer. A transformer connected to a 120-V (rms) ac line is to supply 12.0 V (rms)…

Q: Your friend overhears you talking about electromagnetic induction and says that it’s impossible…

A: What is electromagnetic induction?... Let's consider one conductor( say a coil) and magnet(say bar…

Q: 44) A step-up transformer is designed so that the output of its secondary winding is 2000 V (rms)…

Q: A "magnetic shield member" that wraps the inductance is used so that the magnetic field from the…

A: Discuss about the hard and soft magnetic materials. which are the best shield materials.

Q: AC circuit

Q: Radios use resonance in order to tune-in to a particular station. A physics student builds a simple…

A: Given that the value of capacitance and resistor and frequency and RMS value of current then we have…

Q: 5. In an electric circuit containing inductors, the largest induced voltage usually occurs is opened…

Q: [ maximum, split, fast, directly, minimum, slip, slow, inversely ] 17. At resonance the rms current…

Q: Two coils are placed close together in a physics lab to demonstrate Faraday's law of induction. A…

Q: What is the inductance of the circuit?

Q: Current as a function of time in an RLC circuit can be described by damped harmonic motion equation…

Q: Calculate the conversational voltage and current Voltage and current of the capacitive and draw a…

Q: Inductance• Calculate the inductance of an inductor.• Calculate the energy stored in an inductor.•…

Q: One leg of a radio-tuned circuit has a capacitance of 1x10^-9 farad. It is tuned at 200 kHz. What is…

Q: An inductor has a 51.2-A reactance when connected to a 60.0-Hz source. The inductor is removed and…

A: Given: The inductance of the instructor is 51.2 Ohm and the frequency of the source is 60 Hz. The…

Q: Define the term inductance.

Q: 5) An air conditioner connected to a 120 V AC line is equivalent to a 12.0 Q resistance and a 1.30 Q…

A: Given: Vrms = 120 VR = 12.0 ΩXL= 1.30 Ω To find: a Impedance of the air conditioner Zb Average rate…

Q: describe some of the differences between a motor and an AC generator, and discuss how each use the…

A: The differences in between motor and generator are enlisted as follows, Motor Alternate Current…

Q: 3. An AC circuit draw / 50 mA (ms) current from fixed voltage source. V-20 Vrms Calculate the…

Q: 2. A 60-Hz AC generator develops a peak voltage of 170-V. The generator is connected to a lightbulb…

A: Given, Peak voltage,V0=170 V Resistance,R=240Ω Frequency of AC,f=60 Hz

Q: 6. Give one condition for resonance to occur in a series RLC circuit.

Q: 4)A capacitor C-0.65 pF and unknown resistance R are connected in series to an ac power supply of…

Q: AC An AC current passes through a capacitor as shown. How does the phase of the voltage across the…

A: Let the voltage produced by the AC source is given by : V(t) = Vo Sin(ωt) Where Vo is the maximum…

Q: Electrosurgical units (ESUS) supply high-frequency electricity from resonant RLC circuits to cut,…

A: (a) Calculate the resonant frequency. f = (1/2*π)(1/sqrt(LC)) = (1/2*π)(1/sqrt(1.75*10-6*44*10-9))…

Q: Capacitance is much more difficult to measure than resistance. This problem shows one crude way to…

A: The resistance of the resistor is R = 15Ω. The voltage of rms signal is Vrms = 20V. The frequency f…

Q: Explain RLC circuit?

A: To be very basic, an RLC circuit primarily consists of 3 components that are, a resistor, an…

Q: 2. The plot below shows the voltage (solid line) and current (dashed line) in a device that is…

A: Given, Vmax = 30 mV , Imax = 90 mA a) from graph, T = 0.020 s n = 1/T = 50 ω =…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Inductance, the same way as capacitance and resistance in an AC domain are properties of

a. none of the above

b. geometry

c. frequency

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 2.0-F capacitor is charged to a potential difference of 12.0 V and then connected across a 0.40-mH inductor. What is the current in the circuit when the potential difference across the capacitor is 6.0 V?
Construct Your Own Problem Consider the use of an inductor in series with a computer operating on 60 Hz electricity. Construct a problem in which you calculate the relative reduction in voltage of incoming high frequency noise compared to 60 Hz voltage. Among the things to consider are the acceptable series reactance of the inductor for 60 Hz power and the likely frequencies of noise coming through the power lines.
The power rating of a resistor used in ac circuits refers to the maximum average power dissipated in the resistor. How does this compare with the maximum instantaneous power dissipated in the resistor?
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
Electrosurgical units (ESUs) supply high-frequency electricity from resonant RLC circuits to cut. coagulate, or otherwise modify biological tissue. (a) Find the resonant frequency of an ESU with an inductance of L = 1.25 H and a capacitance of 47.0 nF. (b) Calculate the capacitance required for a resonant frequency of 1.33 MHz.
An AC generator with an output rms voltage of 36.0 V at a frequency of 60.0 Hz is connected across a 12.0-F capacitor. Find the (a) capacitive reactance, (b) rms current, and (c) maximum current in the circuit. (d) Does the capacitor have its maximum charge when the current takes its maximum value? Explain.
Neon signs require 12-kV for their operation. A transformer is to be used to change the voltage from 220-V (rms) ac to 12-kV (rms) ac. What must the ratio be of turns in the secondary winding to the turns in the primary winding? (b) What is the maximum rms current the neon lamps can draw if the fuse in the primary winding goes off at 0.5 A? (C) How much power is used by the neon sign when it is drawing the maximum current allowed by the fuse in the primary winding?
Does the resonant frequency of an AC circuit depend on the peak voltage of the AC source? Explain why or why not.
The capacitor in Figure 23.55(a) is designed to filter low—frequency signals, impeding their transmission between circuits. (a) What capacitance is needed to produce a 100 k reactance at a frequency of 120 Hz? (b) What would its reactance be at 1.00 MHz? (c) Discuss the implications of your answers to (a) and (b).
High-frequency noise in AC power can damage computers. Does the plug-in unit designed to prevent this damage use a large inductance or a large capacitance (in series with the computer) to filter out such high frequencies? Explain.
An ac generator is connected to a device whose internal circuits are not known. We only know current and voltage outside the device, as shown below. Based on the information given, whit can you infer about the electrical nature of the device and its power usage?
An RLC series circuit consists of a 10 resistor, an 8.0F capacitor, and a 50-mH inductor. A 110-V (rms) source of variable frequency is connected across the combination. What is the power output of the source when its frequency is set to one-half the resonant frequency of the circuit?