Initially, the switch is open, and the capacitor in Figure above is uncharged. At t=0, the capacitor is closed. Calculate the current flowing through the capacitor at t=0.1 second!

Q: e) A student from the future is pulling the same toboggan up a sand dune on Mars that has the same…

A:

Q: This question has 4 questions: A) the acceleration B) The force on B due to A C) The net force on…

A:

Q: 1. Calculate a: 8 cm U a 5 cm

A:

Q: An object that is sliding down on a ramp. Why is its normal force zero?

A: Given normal force on an object that is sliding down a ramp is zero.I have to find the reason.

Q: An object is 23 cm in front of a diverging lens that has a focal length of -17 cm. How far in front…

A:

Q: Part A How much work must you do to push a 12.0 kg block of steel across a steel table (k = 0.60) at…

A: Mass of block =12 kgSpeed = 1.20 m/sTime = 1.90 secstatic friction coefficient To determine (a)how…

Q: By accident, a large plate is dropped and breaks into three pieces. The pieces fly apart parallel to…

A:

Q: ock B has a mass of 4.8 kg. They are in contact and sli

A: Image: A small box of mass m1 is sitting on a board of mass m2 and length L. The coefficient of…

Q: Consider a simple electroscope consisting of two insulating, massless strings of length L with small…

A:

Q: Consider a bow and arrow. Suppose the bow is held vertically, and the string is drawn back from its…

A: At equillibrium, net horizontal force is zero.Also, net vertical force is zero.

Q: A 4500 resistor is connected across a charged 0.810 nF capacitor. The initial current through the…

A:

Q: The switch in the circuit shown in (Figure 1) has been closed for a long time, and the current…

A: So we have given a circuit in which there are two resistances, a voltage or battery and a…

Q: Justin, with a mass of 50 kg, is going down an 8.0-m-high water slide. He starts at rest, and his…

A: Given Justin mass=50kg Height=8m Speed=12m/s Asked thermal energy=?

Q: A rock is dropped from a very tall tower. If it takes 5.9 s for the rock to reach the ground, what…

A: Time taken for rock to reach the ground, t = 5.9sInitial velocity of rock, u = 0 m/s (As rock is…

Q: a) A 15.0 kg block is released from rest at point A in the figure below. The track is frictionless…

A:

Q: 1. Two vectors A and B have fixed magnitudes but their ori A+B B

A: The magnitude of the sum of two vectors is given by the formula,                          where,…

Q: You are swinging a sling shot, which is basically a string tied to a rock, vertically as shown.…

A:

Q: Observe the following vectors: 28° D-50 60° A-15 B-10 C=25

A:

Q: Suppose you first walk 12 m in a direction 20° west of north (A) and then 20 m in a direction 40°…

A:

Q: An electron is to be accelerated in a uniform electric field having a strength of 2.64x 10⁰V m What…

A:

Q: While you are accelerating at a constant rate from rest to 28 m/s in 5.1 s, what angle 8 does the…

A:

Q: Consider a pure 4.0g sample of radioactive gallium-67. If the half-life is 78 h, how much time is…

A:

Q: 251.In Fig 85, the dielectric wedge of mass "M" and height H=1 m rests in the smooth horizontal…

A:

Q: In the diagram below, each division on the horizontal axis is 0.20 m while each division on the…

A: For region 0.0m to 0.30 m

Q: 3. When starting a race, a 680 kg vehicle runs the first 1000 m in 3 minutes, starting from rest and…

A: Mass of vehicle =680 kg Displacement travelled in 3 min =1000 m Intial velocity of vehicle =0 m/s

Q: Given vectors A and B, which is A-2B?

A:

Q: Three resistors are made out of three different materials and have different (but uniform) cross…

A:

Q: 1. The components of a vector A are (-5,6). (a) In which quadrant does this vector lie? First…

A:

Q: What equilibrium temperature is reached when 2lbs of ice at 0F is dropped into a 3lb aluminum cup…

A:

Q: Which resistors are in parallel with resistor 1? Which resistors are in parallel with resistor…

A:

Q: Part A An object at rest cannot remain at rest unless which of the following holds? ► View Available…

A: part b - object moving left with constant velocity

Q: 11. A practice exercise for athletes on a track team is to sprint 100 m along a straight section of…

A: (a) To find the average speed of the athlete over one full repetition of this exercise, we need to…

Q: Part C A block of mass 2 kg is acted upon by two forces: 3 N (directed to the left) and 4 N…

A: Given

Q: Why would batteries with high current capacity have a lower internal resistance than batteries with…

A: Explain the reason behind batteries with high current capacities have a lower internal resistance…

Q: A 91.9 pound body is being hoisted by a winch the tension in the hoisting cable being kept constant…

A:

Q: car is traveling with a speed of 21.0 m/s along a straight horizontal road. The wheels have a radius…

A: Speed of car v = 21 m/s.Radius of wheel R = 0.290 meterLinear acceleration a = 1.40m/s2

Q: In an experiment using Young's slits, the distance between the center of the interference pattern…

A: Distance b/w the centre of interference and 10th bright fringe(y)=3.44 cm=3.44*10-2 mand…

Q: How long L is a tungsten wire if it has a diameter of 0.199 × 10-³ m and a resistance of 3.85 kQ?…

A:

Q: Rank the pitches heard from the siren of a fire engine from highest to lowest, when the fire engine…

A:

Q: Drag words or phrases from each group into the blanks to create a true statement. Match the words in…

A: Constant force experienced by an object.The acceleration is Find:Acceleration when force is doubled…

Q: A small box of mass m1 is sitting on a board of mass m2 and length L. The coefficient of kinetic…

A: Mass of box  Mass of board Length of board LCoefficient of kinetic friction μkCoefficient of static…

Q: estimate how much the earth would move if everybody on earth jumped at the same time

A: Earthquakes, if they are large enough, can affect the speed of earth's spin. In 2011, the massive…

Q: The velocity of an object plotted as a function of time is shown below. ([s] s/w) A 50 40 30 20 10 0…

A:

Q: A horizontal pull P pulls two wagons over a horizontal frictionless floor, as shown in the figure.…

A:

Q: An idealized p (1) graph for a programmable fan cart on a low-friction surface is shown below. (What…

A:

Q: A plate glass window (n = 1.5) has a thickness of 3.1 mm. How long does it take light to pass…

A:

Q: As shown in the figure, a 0.480 kg package is pushed against a horizontal spring of negligible mass…

A:

Q: The 4.00 kg block in the figure is attached to a vertical rod by means of two strings. When the…

A:

Q: 68. The graph shows the velocity (in m/s) of an electric autonomous vehicle moving along a straight…

A: Velocity is defined as rate of change of displacement with respect to time.…

Q: What is the force? And what is SI unit of force?

A: Force is a fundamental concept in physics that represents the interaction between two objects. It…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.