Part AIn the circuit shown in (Figure 1) both batteries haveinsignificant internal resistance and the idealizedammeter reads 2.00 A in the direction shown.Find the emf E of the battery.Express your answer in volts.V AZOE = 58.46VFigure1 of 1<>SubmitPrevious Answers Request AnswerX Incorrect; Try Again; 6 attempts remaining12.0 NPart BE=?48.075.0 VΩ15.0Is the polarity shown correct?ΩAyesnoSubmitPrevious Answers

(A) Since 2A is flowing in the given direction the voltage at upper node connecting 48Ω is given by…

insignificant internal resistance and the idealized ammeter reads 2.00 A in the direction shown. Find the emf E of the battery. Express your answer in volts. VO AEO E = 58.46 V Figure < 1 of 1 Previous Answers Request Answer Submit X Incorrect; Try Again; 6 attempts remaining 12.0 N Part B E=? 48.0 15.0 Is the polarity shown correct? 75.0 V| Ω yes no

insignificant internal resistance and the idealized ammeter reads 2.00 A in the direction shown. Find the emf E of the battery. Express your answer in volts. VO AEO E = 58.46 V Figure < 1 of 1 Previous Answers Request Answer Submit X Incorrect; Try Again; 6 attempts remaining 12.0 N Part B E=? 48.0 15.0 Is the polarity shown correct? 75.0 V| Ω yes no

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Whale and Kanmuro are two islands located at the Chimera archipelago. These two are separated by a distance of 16 miles. A power link is to be established between them. The power link delivers a maximum power of 584 megawatts at full capacity with an operating voltage of 580 kilovolts. Note that 1 mile is 1.6 kilometers. Solve for the resistivity (in ohm-micrometers) of the cable asusming a conductor diameter of 1.55 centimeters.
a) A 380V, 7.5kW electric water pump of power factor 0.8 lagging and efficiency of 85% will be wired by an armoured XLPE insulated copper cable. The circuit will be run on cable tray with three other similar circuits at an ambient temperature of 40℃. MCCB will be used as the overcurrent protective device for the circuit. The estimated length of the circuit for the machine is 50m. i) Determine the minimum rating of MCCB for the circuit, available MCCB rating are 25A, 30A, 40A, 50A ii) Determine the minimum cable size of the circuit if the allowable voltage drop of the circuit is 1.5% of the nominal supply voltage?
Voltage Drop! Assume that you were tasked to install a microwave oven using 12 AWG copper. When you look at the spec plate for the oven, you discover that the oven is rated for 240V, 60HZ, and takes a current of 25A. The location for the oven is 785.7 Ft, away from the breaker panel. Calculate the expected VD if any. Assume temperature to be 75 ̊ C. what is the Voltage Drop ? Answer?
Please show a complete step-by-step solution. Thank youGive your final answers in at least 2 decimal places - make it 3 or 4 decimal places whenever required in the problem. If you are doing a step by step calculation, maintain 6 decimal places in your in-between calculations to hit good accuracy in your final answers. Use 1 hp = 746 Watts in your conversion whenever necessary. A 110-hp, three-phase, wye-connected, 50-Hz, 450-V, four-pole, cylindrical-rotor synchronous motor is operating at rated conditions and 85 percent power-factor leading. The efficiency, excluding field and stator losses, is 95 percent, and the synchronous reactance is 3.82 Ohms/phase. Determine the magnitude of the excitation voltage in volts. Give your final answer in 2 decimal places. Correct Answer: 672.23 ± 0.01
Please show a complete step-by-step solution. Thank youGive your final answers in at least 2 decimal places - make it 3 or 4 decimal places whenever required in the problem. If you are doing a step by step calculation, maintain 6 decimal places in your in-between calculations to hit good accuracy in your final answers. Use 1 hp = 746 Watts in your conversion whenever necessary. A 110-hp, three-phase, wye-connected, 50-Hz, 460-V, four-pole, cylindrical-rotor synchronous motor is operating at rated conditions and 88 percent power-factor leading. The efficiency, excluding field and stator losses, is 95 percent, and the synchronous reactance is 2.81 Ohms/phase. Determine the developed torque in lb-ft. Give your final answer in 2 decimal places. Correct Answer: 405.42 ± 0.01
Q5. The battery is built by connecting several unit cells in series. Each unit cell has the voltage V1=1.35 V and the internal resistance Ri = 2.4 Ohm;(1) How many unit cells in series must the battery use to have the open-circuit voltage Vo.c. = 8.1 V? (2) Using the battery as per question 1, what is the power delivered to the load resistance RL=17.5 Ohm connected to the battery (Unit: W)?
Please show a complete step-by-step solution. Thank youGive your final answers in at least 2 decimal places - make it 3 or 4 decimal places whenever required in the problem. If you are doing a step by step calculation, maintain 6 decimal places in your in-between calculations to hit good accuracy in your final answers. Use 1 hp = 746 Watts in your conversion whenever necessary. A 130-hp, three-phase, wye-connected, 50-Hz, 440-V, four-pole, cylindrical-rotor synchronous motor is operating at rated conditions and 86 percent power-factor leading. The efficiency, excluding field and stator losses, is 90 percent, and the synchronous reactance is 2.13 Ohms/phase. Determine the pull-out torque of the motor in lb-ft. Give your final answer in 2 decimal places. Correct Answer: 885.36 ± 0.01
A house has the following electrical appliance usage: - One 32 Watt fluorescent lamp with electronic ballast used 6 hours per day. - One 75 Watt fan used for 3 hours per day. - One 100 Watt refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours. - The system will be powered by 12 Vdc, 110 Wp PV module. e) What is the Total Ampere-hours required for the battery in Ah for 3-day autonomy? (Round off your answer to three decimal places. Do not put comma in numerals)
A 2-wire d.c. distributor AB is 600meters long is loaded as under: Distance from A (meters) 150 300 350 450 Load in Amps 100 200 250 300 The feeding point A is maintained at 440V and that of B at 430V. If each conductor has a resistance of 0.01Ω per 100meters, calculate the current supplied from A & the power dissipated in the distributor.
Determine the following for solar PV power system referred to the data given below. (Assume the efficiency of the solar system =15%) No of PV Modules = 8 Area of each solar cell is =0.3 m2 No of cells in one module = 20 Insolation value =1050 W/m2 Connection scheme = all Modules are connected in Paralel. a. Total output voltage and output power of system. b. Total output current of the system. c. Calculate the output power of the system if any one of the module gets damaged.
Design a 25V solar PV panel system that can power a home that requires two 30-Watt lamps and four 15-Watt fans for 6 hours daily if the factors for the solar panel generation and the total energy losses respectively are2.92 and 1.3. Take the rating of the available solar PV cell as 5V, 5W
Solve the following Numerical problems a. What is the Output Voltage of a battery that expends 7.2J of energy in moving 1C of charge? b. A 50-ohm load dissipates 200W of power. How much is the voltage and current across the load? c. If one branch of a 120-V power line is protected by a fuse of 20-A. Will the fuse carry 10-Ohm load? d. If total resistance of a series circuit is 280-Ohm. If one of the resistance is 160-Ohm. What is the sum of other two resistances?