Answered: Installations used to export electric…

Engineering

Electrical Engineering

Installations used to export electric power from vehicles to premises wiring or for?current flow are covered by the NEC

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter3: Determining The Required Number Of Branch Circuits, Lighting Outlets, And Receptacle Outlets

Section: Chapter Questions

Problem 16R

See similar textbooks

Related questions

Q: If the current in a conductor is constant at 2 mA, how much time is required for 6 mC to pass…

A: Given, Current, I=2 mA Charge, q=6 mC

Q: Describe circuit's every working procedure and describe all equipment and function according to the…

A: Working procedure,equipment and function of OP275 Low pass filter design circuit:

Q: A power line is to be run to an offshore facility where its 5 miles at sea and 2 miles along…

A: It is given that: a power line is to be run to an offshore facility where its 5 miles at sea and 2…

Q: Draw the circuit diagram for controlling a florescent lamp from two location and Air conditioner…

A: According to the question we have to draw the circuit diagram for controlling a fluorescent lamp…

Q: The device (or element) that used to protect electronic components which are vulnerable to reverse…

A: here we need to find the device ( or element ) that used to protect electronic componentswhich are…

Q: e) PV cell is indirect method of solar energy (true or false)?

Q: essential electrical system in health care facilities

A: Circuit classified essential electrical system in health care facilities is shown in below

Q: Fuses and circuit breakers are used in electrical circuits to prevent power overload that can cause…

Q: The coloring on individual conducting wires usually does not indicate a size or rating but rather…

A: The coloring on individual conducting wires usually does not indicate a size or rating but rather…

Q: How long does it take for the conductors to reach the threshold temperature in a short circuit?…

A: The maximum operating temperature for the given conductor is, T1=70 oC. The cross-sectional area of…

Q: ____ must not be installed beneath openings through which materials may be moved, such as openings…

A: From Article 230 of National Electric Code (NEC), the following information can be obtained: Service…

Q: Describe the circuit's every working procedure and describe all equipment and function according to…

A: Working procedure,equipment and function of Over Heat detection circuit:

Q: Describe the standard operating procedure (SOP) for Power Supply. including precautions too. Thank…

A: The standard operating procedures for the power supply are listed below: 1- Before the power supply…

Q: Assuming all terminals are rated 75 degrees C, what is the maximum size overcurrent protective…

A: From the NEC table 310.15(B)16, the following table is obtained: Size AWG or kcmil Temperature…

Q: Draw equivalent circuit of PV cell with explanation and labelling in details

A: PV cell: It stands for Photo voltaic cell . It is also called as solar cell. It is a device which…

Q: The 'skin effecť is a phenomenon experienced when current flows through a metal. Which two of the…

Q: Electric Powers System for Nonelectrical Professional can you describe effective preventive…

A: Electrical Preventive Maintenance (EPM) is the act of leading routine assessments, tests, and the…

Q: Draw the block diagram representation of a heating system.

A: Answer- Block diagram of heating system -

Q: Conductors other than service conductors must not be installed in the same____. A. Service raceway…

A: From Article 230 of National Electric Code (NEC), the following information can be…

Q: Describe in-depth the different types of power outlets located in the operative environment and the…

A: Different types of power outlets for use in the home are (1) 15A, 120V outlets It can be used for…

Q: Nec article 210 q.#1 the rating of a branch circuit shall bedetermined by the rating of the?

Q: What makes current flow in a circuit? When does current flow in a circuit? When there is a power…

Q: a) Electricity represents a huge danger to virtually every workplace, and those who are employed…

A: Since you have asked multiple questions so we will solve the first question for you. If you want any…

Q: A wiring job requires 7,645 feet of cable. If the cable comes in 250 ft. coils, how many coils of…

A: Given: The total length of the cable required is 7645 feet. The length of a cable coil is 250 feet.…

Q: What happens if you only touch one meter test probe to one terminal of power supply?

A: To describe what happens if any one meter probe touch to one terminal of Power supply

Q: Step 1: Draw a wiring diagram for the schematic shown above. Do not energize!

A: We are given a schematic diagram shown below: We have to draw the wiring diagram for the above…

Q: What are the different onboard sources of electrical power in a modern commercial passenger…

Q: What ampacity must all branch-circuit conductors used for wiring a ceiling outlet box be de-rated…

A: Dear student as per our guidelines we are supposed to solve only one question .kindly repost other…

Q: 20- The protection element used in the method based on the current flowing from this weak point to…

A: Arc Extinguishing Coil: In a circuit breaker, the current carrying contacts when moved apart create…

Q: Which is a non permanent way of building a circuit? O stripboard О РСВ O Thick-film O Breadboard

A: The strip board is the board that are used to make the permanent circuits, the board is used where a…

Q: What is the NEC code for receptacle near a pool

A: NEC stands for National Electric code. It is standard for safe installation of Electrical wiring and…

Q: An outlet intended for direct connection to a lighting fixture.

A: The different types of outlets are: 1) Convenience Outlet 2) Lighting Outlet 3) Receptacle Outlet

Q: Draw the primary protection zones for each element of the system in the figure shown.

A: We have to draw the primary protection zones for the given power system shown below:

Q: Calculate the minimum copper conductor size needed for 120/240 V electric range branch circuit the…

A: Given data: Voltage rating=120/240 VPower rating P=12kWMinimum voltage rating…

Q: Explain how geothermal system is employed in HVAC application with a neat diagram.

Q: 1._____ must not be installed beneath openings through which materials may be moved, such as…

A: Article NEC 225.19 (D) (3) shows ‘Building Openings’ states that, the overhead branch-circuit and…

Q: Determine the power provided by the 20-volt source in the circuit below. Indicate if the 20-volt…

A: The given circuit is:

Q: For high-voltage protection, fuses are generally preferable to circuit breakers for all of the…

A: Fuse have following advantage over circuit breaker 1. Initial cost of fuse is lower 2. Fuse is…

Q: = power system s

Q: Question 4. Explain why grounding is important for the electrical safety of medical devices and how…

A: The obstruction that a current faces in its flow is called the impedance of that path. The currents…

Q: Couses EEP Draw a WIRING DIAGRAM for wiring Two Way - One Gang Switches (51 and S2) to control…

Q: Answer the question Electrical circuit

A: So from the given question we need the voltage expression for capacitor.

Q: A ____ situation occurs when an ohmmeter reads resistance through circuit components even after the…

A: Fill the blank, about the power situation occurs when an ohmmeter reads resistance through circuit…

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

Installations used to export electric power from vehicles to premises wiring or for?current flow are covered by the NEC

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How long does it take for the conductors to reach the threshold temperature in a short circuit? Data: 95 mm² PVC/70 conductor, 6 kA presumptive short circuit current.
What code set standard for electrical installation work
What type of circuits must be provided for receptacle outlets in the kitchen, pantry, dining room, and breakfast room? See NEC 210.11(C)(1). __________
NEC 210.12(A) requires AFCI protection for the branch-circuit wiring that supplies all electrical outlets in specific rooms in dwellings. The branch circuits serving which areas, locations, or rooms in dwellings are not required to have AFCI protection?
The NEC requires that a ____________ means be provided for standby power systems. In the case of portable gen sets, this might be as simple as pulling out the plug on the extension cord that is plugged into the receptacle on the gen set. For permanently installed standby power generators, this might be on the gen set and/or separately provided inside or outside of the home.
In a single-family dwelling, how is overcurrent protection for branch circuits required to be provided? See NEC 210.20. __________
It is permissible for an electrician to connect aluminum, copper, or copper-clad aluminium conductors together in the same connector. (True) (False) (Circle the correct answer.)
The branch circuit supplying a fixed electric space heater must be sized to at least ___________ percent of the heaters rating according to NEC ________________.
To what extent does electrical grids represent both a natural monopoly and an essential facility?
1._____ must not be installed beneath openings through which materials may be moved, such as openings in farm and commercial buildings, and must not be installed where they will obstruct entrance to these buildings. A. Overcurrent protection devices. B. Overhead-service conductors C. Grounding conductors D. Wiring systems
When a set of electrical drawings is needed to get a permit, the drawings must include A. switch locations.B. brand names for each part.C. estimated cost of the project. D. fuse locations.
Describe circuit's every working procedure and describe all equipment and function according to the circuit.