Instructions: a. Gather all the materials needed. b. Put the rice in a bowl then add ½ liter of water. c. Wash the rice with your hands. Leave the water to settle for 1 minute. What did you observe? d. Slightly tilt the bowl to pour out some water e. Observe then answer the following question in your activity notebook: 1. Describe your mixture? 2. How did you separate the impurities from the rice before cooking? 3. What happened to the rice? Why?

Instructions: a. Gather all the materials needed. b. Put the rice in a bowl then add ½ liter of water. c. Wash the rice with your hands. Leave the water to settle for 1 minute. What did you observe? d. Slightly tilt the bowl to pour out some water e. Observe then answer the following question in your activity notebook: 1. Describe your mixture? 2. How did you separate the impurities from the rice before cooking? 3. What happened to the rice? Why?

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter1: Matter, Measurements, And Calculations

Section: Chapter Questions

Problem 1.89E

See similar textbooks

Similar questions

Your goal is to separate two solids by adding water and then filtering the mixture. What are the final steps of ending up with two separate solids? (select one) a) Use water to wash the solid off the filter paper into the filtrate and evaporate the water from the filtrate. b) Use water to further rinse the solid on the filter paper and collect the filtrate into a new container. c) Scrape the solid off the filter paper into one container and collect the filtrate into a new container. d) Scrape the solid off the filter paper into one container and evaporate the water from the filtrate to isolate the other solid.
What is a chemical reason that a sample could have more than 100% purity? A) Impurity was an acid B) Impurity were not acids C) Sample was wet
When purifying a sample of aspirin that was produced in the lab, the impure aspirin sample should be dissolved in a very cold solvent, so that solid impurities can be filtered and analyzed the next day or the next week. True or False?
Jack measured the mass of an empty evaporating dish and watch glass, and weighed approximately 0.5 g of an unknown solid into the evaporating dish. He then followed the procedure for Lab Exercise 5, and collected the rest of the data in the table below. Please note that row letters correspond to those found on the data sheet that you will use in lab. You will need to refer to this data to answer Questions 13 through 20: A Mass of empty evaporating dish + watch glass 65.362 g B Mass of dish + watch glass + initial solid 65.864 g C Mass of dish + watch glass + carbonate 65.705 g D Mass of dish + watch glass + chloride 65.716 g What was the mass (in grams) of the unknown solid that Jack used in his experiment. Type the numerical answer only in the box below (no units!). Report your answer to the correct number of significant figures.
Weigh out 5g of table salt. Dissolve it in 50mL of distilled water in a container using a stirrer and label appropriately. Calculate the concentration in terms of percent mass per volume.
Example: A distillation model containing a certain percentage of water was taken from the model 25 ml and the amount of water that was discarded after the separation process was 2 ml Calculate the percentage of water that was isolated from the model
How should goggles be worn in a chemistry lab? A. Over your eyes during the entire lab work is going on B. Over your eyes during only when you are doing lab work C. Both
a) Why should a fixed-volume pipette be more accurate than a graduated pipette? b) Why would returning chemicals to a reagent bottle introduce contaminant?
33.) When getting glassware equipment for an experiment you should? a. clean any glassware that looks dirty b. read all directions carefully to know what equipment is needed c. examine all glassware to check for chips or crack d. do all of the above
if you use tap water to dissolve a solid you can contaminate data true or false?
what is a chemical reason that a sample could have less than 100% purity? A) Impurity was an acid B) Impurity were not acids C) Overshot end point
When performing the water displacement method , this observation will increase the volume of the specimen a. bubbles are produced b. the specimen floats c. mass was not accurately taken