Answered: Is it possible for a fluid in a tube to…

Is it possible for a fluid in a tube to flow in the direction from low pressure to high pressure? If so, give an example. If not, why not?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 31PE: How tall must a water-filled manometer be to measure blood pressures as high as 300 mm Hg?

See similar textbooks

Related questions

Q: A constriction in a pipe reduces its diameter from 4.6 cm t 1.7 cm. Where the pipe is wuder the…

A: EQUATION OF THE CONTINUITY The continuity equation is defined as the product of…

Q: . A liquid is flowing through a horizontal pipe whose radius is 1.86 ×x10¯² m. The pipe bends…

A: To determine,the speed(v1) of the liquid in the lower horizontal pipe.given,radiur(r1) of lower…

Q: What is the absolute pressure at the bottom of a swimming pool that is 1.5 m deep? (Note that water…

A: Pressure can be calculated as,

Q: By what factor will the flow rate of a viscous fluid through a needle change if the needle radius is…

A: SOlution: Given that P1-P2 reduced 1/4th , New Pressure P'1-P'2 =( P1-P2)/4 needle radius is doubled…

Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Water flows through a circular pipe with a constant radius of 10 cm. The speed and pressure at point…

Q: The internal diameter of a garden hose is reduced from 2r1 = 2 cm to 2r2 = 1 cm at some point along…

Q: According to the Bernoulli equation, if the speed of a fluid moving parallel to a surface increases,…

A: The total Energy head will remain constant. Total energy head is the summation of potential head +…

Q: An incompressible fluid flows steadily through a pipe that has a change in diameter. The fluid speed…

Q: The pressure in the pressurized water tank is measured by a multi-fluid manometer with one end open…

Q: 8. A large container, 108 cm deep is filled with water. If a small hole is punched in its side 81.0…

A: Answer:- Given Acceleration due to gravity (g) = 9.8 m/s2 Height of small hole punched in its…

Q: What is the buoyancy force exerted on a cube with sides of length 61.0 cm if the block is fully…

A: Given data: The block is fully submerged in a fluid Side length of cube (s) = 61.0 cm = 0.610 m…

Q: why blood cannot be strictly analyzed as an ideal fluid ?

A: Viscosity is an intrinsic property of the fluid that relates, to the internal friction of adjacent…

Q: Which of the following statements is true about an incompressible fluid moving through a horizontal…

A: An incompressible fluid is moving through a horizontal pipe

Q: What is the difference between the pressure of the blood in your brain when you stand on your head…

Q: What should be the average velocity of water in a tube of radius 0.005m so that the flow is just…

A: The radius (r) of the tube is 0.005 m. Therefore, the diameter (d) of the tube will be 0.01 m.…

Q: describes the statement. A. The direction of the net force due to the fluid is downward B. The…

Q: If you halve the diameter of a hose what happens to the velocity of the water flowing through it?…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: An incompressible fluid flows steadily through a pipe that has a change in diameter. The fluid speed…

A: Radius of one end R1 = 4 cm = 0.04 m Velocity V1 = 1.28 m/s Radius of other end R2 = 2 cm = 0.02 m…

Q: Which of the following statements is true about an incompressible fluid moving through a horizontal…

Q: Given an open tank that contains different layers of fluid. Hoil Hw Hhg Determine the Absolute…

A: We know that the pressure increases as we move into the liquid

Q: Water enters a pipe of rectangular cross section of dimensions 6.5 cm by 8.0 cm at a velocity of 4.0…

A: Given, rectangular cross section of dimesions 6.5 cm by 8.0 cmvelocity, v1 = 4.0 cmsradius of…

Q: When the force P is applied to the plate shown in (Figure 1), the velocity profile for a Newtonian…

Q: (a) Using Bernoulli’s equation, show that the measured fluid speed v for a pitot tube, like the one…

Q: The statement, "In regions where fluid velocity is smaller, the pressure is higher, and vice versa",…

Q: An incompressible fluid with zero viscosity flows through a pipe of varying radit (shown in…

A: Solution:According to Bernoulli's principle for an incompressible and non-viscous fluid we get:P +…

Q: What is the pressure inside an alveolus having a radius of 2.5X10^-4 m if the surface tension of the…

A: To find the pressure

Q: A tank with a flat bottom of area A and vertical sides is filled to a depth h with water. The…

A: Given,

Q: When measuring blood pressure, why is the cuff placed at the level of the heart? Would the blood…

A: Required : When measuring blood pressure, why is the cuff placed at the level of the heart? The…

Q: Q 2) When two capillary tubes of the same radius are immersed in two containers, one containing…

A: The given question is based on the phenomenon of capillarity. Capillarity is the tendency of a…

Q: In a continuous pipe where the fluid is flowing, as the diameter of the pipe increases, the velocity…

A: In a continuous flow pipe the product of density, velocity and area of cross section is constant.…

Q: The method of capillary rise is based on the height to which the liquid in the capillary will rise…

A: It is force due to gravity F= mg m = mass g = gravitational constant

Q: A container filled with a fluid with density and height equal to p and h, respectively, is quickly…

A: Pressure is directly proportional to the height. It is measured in N/m2 P =…

Q: In our circulatory system, blood can find 4) obstructions in certain veins/arteries, to keep flowing…

A: According to Bernoulli principle, energy of fluid flowing is constant. And we define two kind of…

Q: A pipe made of two joined sections with different diameters of 1.0 and 4.0 inches, respectively. An…

A: Given data: Diameter of pipe 1 d1=1.0 inches Diameter of pipe 2, d2=4.0 inches

Q: A pipe of cross sectional area 2.34 m2 narrows while splitting into three pipes, each of…

Q: Water flows through a pipe as shown in the figure. The pressure at points 1 and 2 respectively is…

A: Write the expression for the Bernoulli's equation…

Q: A constriction in a pipe reduces its diameter from 4.0 cm to 2.0 cm. Where the pipe is narrow the…

A: Given: The diameter of the pipe reduced from 4 cm to 2 cm. The speed of the water flow in the narrow…

Q: A partially filled bucket of water sits on a scale and its weight is 3.8 N. A piece of metal is…

Q: calculate the force required to pull a copper ball of radius 2.00 cm upward through a fluid at the…

A: Given Data: The radius of a copper ball is, r=2.00 cm The constant speed of a copper ball is, v=9.00…

Q: How will you explain surface tension and capillary to an unschooled person?

A: To explain: Surface tension and capillary action.

Q: Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: True or False? The higher the velocity of the fluid the lower the pressure.

A: Given The higher the velcoity of the fluid the lower the pressure. True or False?

Q: With Bernoulli's principle, is there any other reason as to why the pressure of the fluid decreases…

A: Bernoulli’s principle: it states that the static pressure and the potential energy of the fluid…

Q: Why is a force exerted by a static fluid on a surface always perpendicular to the surface?

A: The Third Law of Newton states that "For every action, there is an equal and opposite reaction. We…

Q: Is gravity the most common source of pressure fluctuations in a fluid? (True or False)

A: Answer:- True Gravity the most common source of pressure fluctuations in a fluid. Fluid…

Question

Is it possible for a fluid in a tube to flow in the direction from low pressure to high pressure? If so, give an example. If not, why not?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Figure P15.52 shows a Venturi meter, which may be used to measure the speed of a fluid. It consists of a Venturi tube through which the fluid moves and a manometer used to measure the pressure difference between regions 1 and 2. The fluid of density tube moves from left to right in the Venturi tube. Its speed in region 1 is v1, and its speed in region 2 is v2. The necks cross-sectional area is A2, and the cross-sectional area of the rest of the tube is A1. The manometer contains a fluid of density mano. a. Do you expect the fluid to be higher on the left side or the right side of the manometer? b. The speed v2 of the fluid in the neck comes from measuring the difference between the heights (yR yL) of the fluid on the two sides of manometer. Derive an expression for v2 in terms of (yR yL), A1, A2, tube, and mano. FIGURE P15.52
An incompressible, nonviscous fluid is initially at rest in the vertical portion of the pipe shown in Figure P15.61a, where L = 2.00 m. When the valve is opened, the fluid flows into the horizontal section of the pipe. What is the fluids speed when all the fluid is in the horizontal section as shown in Figure P15.61b? Assume the cross-sectional area of the entire pipe is constant. Figure P15.61
A 1.00-kg beaker containing 2.00 kg of oil (density = 916.0 kg/m3) rests on a scale. A 2.00-kg block of iron suspended from a spring scale is completely submerged in the oil as shown in Figure P15.63. Determine the equilibrium readings of both scales. Figure P15.63 Problems 63 and 64.
Two thin-walled drinking glasses having equal base areas but different shapes, with very different cross-sectional areas above the base, are filled to the same level with water. According to the expression P = P0 + gh, the pressure is the same at the bottom of both glasses. In view of this equality, why does one weigh more than the other?
Suppose water is raised by capillary action to a height of 5.00 cm in a glass tube. (a) To what height will it be raised in a paraffin tube of the same radius? (b) In a silver tube of the same radius?
A large storage tank with an open top is filled to a height h0. The tank is punctured at a height h above the bottom of the tank (Fig. P15.39). Find an expression for how far from the tank the exiting stream lands. Figure P15.39
A beaker of mass mb containing oil of mass mo and density o rests on a scale. A block of iron of mass mFe suspended from a spring scale is completely submerged in the oil as shown in Figure P15.63. Determine the equilibrium readings of both scales. Figure P15.63 Problems 63 and 64.
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?
A 1.00-kg beaker containing 2.00 kg of oil (density = 916 kg/m3) rests on a scale. A 2.00-kg block of iron is suspended from a spring scale and is completely submerged in the oil (Fig. P9.31). Find the equilibrium readings of both scales. Figure P9.31
A 1.00-kg beaker containing 2.00 kg of oil (density = 916 kg/m3) rests on a scale. A 2.00-kg block of iron is suspended from a spring scale and is completely submerged in the oil (Fig. P9.31). Find the equilibrium readings of both scales. Figure P9.31
Does atmospheric pressure add to the gas pressure in a rigid tank? In a toy balloon? When, in general, does atmospheric pressure not affect the total pressure in a fluid?
What is the greatest average speed of blood flow at 37° C in an artery of radius 2.00 mm if the flow is to remain laminar? What is the corresponding flow rate? Take the density of blood to be 1025 kg/m3.