1. Is it possible for an isobaric process to be isochoric at the same time? Why or why not?Explain.2. Given the PV diagram shown below:7₂P₂P₁Va. What are the pressure, volume, and temperature conditions of the gas in state a?b. Which of the four types of work process will the gas experience when its state changes from dto b? Will it expand contract, or retain its volume when it traces this path?c. In which path or paths does the system perform the least work?P

Answered: Image /qna-images/answer/3b3ddfea-1546-4023-a640-d303d1f90210.jpg

Answered: Is it possible for anisobanc process to…

Is it possible for anisobanc process to be isochoric at the same time? Why or why not? Explain. 2. Given the PV diagram shown below: 7₂ P P₁ T₁ V

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Specify whether the steam is -wet -dry saturated -superheated for the following conditions. Prove your answer by stating the properties of steam from the thermodynamic steam table. No Proof means No Points. 1. p = 3.0 MPa, t = 234 ºC 2. t = 250 ºC, v = 54.2 x10-3 m3/kg 3. p = 11.0 MPa, h= 2805 kJ/kg 4. p = 4.0 MPa, s = 5.897 kJ/kg-K 5. p = 15.0 MPa, t = 310 ºC 6. t = 205 ºC, u = 2597.5 kJ/kg 7. p = 1.42 MPa, u = 2500 kJ/kg
An empty greenhouse with a volume of 60m³ has cracks around doors and windows so that air can flow through and allowing the pressure inside to always remain equal to that of the surrounding environment. On a particular day when the atmospheric pressure is 100kPa, the air in the greenhouse changes temperature from 10℃ to 40℃ by means of radiative heating from the sun. Assume that the air can be modeled as an ideal gas with constant properties cᵥ=715.9J/kg*K and R?=286J/kg*K. (1) What is the change in energy stored by the system? (2) Treating the greenhouse as an open system, determine the heat transfer necessary to produce this temperature change. (3) Is the process totally reversible? Justify your answer. If it is not totally reversible, identify the source(s) of irreversibility.
For all problems, draw p-v- and a T-s-diagrams indicating states and processes relative tosaturation lines.
Select the correct relation for the isentropic process of ideal gases_________ A. B. C. D.
Please answer correctly. 2) Is it possible to reduce the volume of an ideal gas in a closed reciprocating cylinder without mass inlet and outlet, keeping the temperature constant and without allowing heat exchange with the environment? Please explain.
An ideal gas with R=0.062 BTU/lbm-R and Cv=0.158 BTU/lbm-R undergoes a three-cycle in a closed system. From the initial state of 20 psia and 570 R, the gas is compressed at a constant temperature of 1/5 of its initial volume, process 1-2; it is then heated isochorically to state 3, process 2-3; and finally, expands polytropically with index n=1.5 back to its initial state, process 3-1. Determine the pressures, specific volumes and temperatures at cardinal points around the cycle and the cycle thermal efficiency.
Argon is confined in a frictionless piston-cylinder device surrounded by the atmosphere.Initially, the pressure of the gas is 800 kPa. Assume the processes connecting the end states areof the following types: (a) the pressure is constant, (b) the product PV is constant, and (c) the product PV2 constant. (d) Compare the processes by plotting the three paths on the same PVdiagram.
For each stage below, analyse the phase state and its properties: pressure, temperature, specific volume, and quality (if applicable). Then, sketch a T-v diagram with respect to saturation lines by indicating all the information obtained.(i) Water at T = 190°C and u = 2370 kJ/kg(ii) Water at P = 11 MPa and T = 450°C(iii) Water at P = 20 MPa and h = 1300 kJ/kg(iv) Refrigerant-134a at P = 1.891 MPa and s = 0.795 kJ/kg. K(v) Refrigerant-134a at T = 12°C with volume flow rate and mass flow rate of 0.0319 m3/s and 40 kg/s, respectively
Identify the working substance, specify the kind of system and sketch the system boundary. PLEASE ANSWER it in 1hr.
What is the internal energy of 2.2 kg of dry saturated steam at 11 bars ?
A 2.30-mol ideal diatomic gas, initially at temperature 123.0◦C, expands adiabatically to triple its volume. The same final state can be reached by an isothermal expansion followed by an isobaric cooling. What is the work done by the gas during the adiabatic expansion? (A) 6.73 kJ; (B) 6.43 kJ; (C) 6.13 kJ; (D) 5.83 kJ; (E) 5.53 kJ. What is the work done by the gas during the isothermal expansion? (A) 12.7 kJ; (B) 11.7 kJ; (C) 10.7 kJ; (D) 9.7 kJ; (E) 8.7 kJ. What is the heat removed from the gas during the isobaric cooling? (A) 9.73 kJ; (B) 9.43 kJ; (C) 9.13 kJ; (D) 8.83 kJ; (E) 8.53 kJ.
Consider a piston–cylinder assembly that initially contains 0.5 kg of steam at 400°C and 100 bar. For the isothermal expansion of the steam in this system to a final pressure of 1 bar, determine the following: (a) What is the maximum possible work (in [kJ]) that can be obtained during this process and the entropy change of the surroundings (in [kJ/K])? (b) Repeat part (a) using the ideal gas model for steam. Compare your answers.