It would take one machine 4 hours to complete a production. The same task another machine can do in 2 hours. If both the machines work together, then how much time will it take to complete the task?

Q: Imagine you are driving a car up Pike’s Peak in Colorado. To raise a car weighing 1000 kilograms a…

A: Given:  The terms of efficiency, what factors may keep you from realizing your ideal energy use on…

Q: ) The force used to do work is the resisting force of an object. (use )

A: Force used to do work

Q: A certain factory machine uses 600 cal/s to operate. If there are 2 identical machines running at…

A:

Q: A 4.8 Hp machine runs for 10 hours. If the cost of electricity is $0.5/kWh, then estimate the…

A: Given data: The power rating of the machine is P=4.8 Hp The machine runs for T=10 hours The cost of…

Q: which of the following best describes renewable energy ? a. energy from fossil fuels b. energy…

A: Renewable Energy: It is derived from renewable resources that are replenished naturally on a human…

Q: (b) A circuit is connected as shown in Figure Q1(b). If a voltmeter is used to measure the voltage…

A: In this question,  We need to calculate the value of internal resistance of voltmeter R  If relative…

Q: 4   What type of conversion is happening in a DC Generator.   a. DC electrical energy to…

A: A DC generator is an electrical machine.  Which convert mechanical energy into electricity.

Q: Why it is fun to compute problems about ohms law I need personal answer

A:

Q: 1000 1000 turns turns w = 5 cm d =5 cm x-1 mm 1500 N AAAAA 4444

A:

Q: What is Energy Audit?Please explain about the energy audit and home energy audit?Give a introduction…

A: ENERGY AUDIT:An energy audit is an inspection survey and an analysis of energy flows for energy…

Q: Find source Vs is delivering power or absorbing and how much power.

A: Given circuit is -

Q: Wire drawing is a metalworking process used to reduce the cross-section of a wire by increasing its…

A: The resistance of the material can be found using the formula R=ρlA where R is the resistance ,rho…

Q: When a stone is falling from a hill, its, energy is converted in to energy. Kinetic; Potential…

A: According to the question, the stone is at the hill then it is falling means initially the stone is…

Q: 2. Wire drawing is a metalworking process used to reduce the cross-section of a wire by increasing…

A: The solution can be achieved as follows.

Q: 3. Wind mill with 2m diameter works on the principle of converting kinetic energy of the wind in to…

A: Given: Diameter of wind mill is 2m. Air density, ρ=1.225 kg/m3 Wind Speed, v=20 m/s

Q: A PV module produces 334 W at 18 °C and 245 W at 45 °C. a) What is the nameplate power? Give your…

A: Given information, A PV module produces P1=334 W power at T1=18°C and P2=245 W power T2=45°C. We…

Q: A thermistor is placed in a 200°C environment and its resistance measured as 30000Q. The material…

A: Given values are -

Q: A mechanical system takes 1 minute to expend 120,000 joules of energy to do work, what is the power…

A: a) Time = 1 minute = 60 secondsEnergy = 120,000 JoulesPower = EnergyTimeP = 120,00060P = 2000 W or…

Q: Whale and Kanmuro are two islands located at the Chimera archipelago. These two are separated by a…

A: To find current at full power capacity when a power link is to be established between the two…

Q: A student claims when they use their space heater and hairdryer at the same time, the power for the…

A: given data: A student claims when they use their space heater and hairdryer at the same time, the…

Q: State the Mathematical relationship between the sides of the power triangle.

A: Power triangle can be represented as below Where         S= Apparent power of the circuitP=Real…

Q: How do you measure a current between two points in a circuit? (draw a diagram) How do you measure…

A: An instrument called ammeter measures electric current in a circuit. It is always connected in…

Q: a. List and state the uses of ten major components in the power system b. State three importance of…

A:

Q: Please answer the question by showing step by step and explaining each step with details, please?…

A:

Q: Explain the concept of 1x1 convolutions and how it can be used?

A: An 1×1 filter in a convolution layer can be used at any point of the network in order to control the…

Q: 22) What type of conversion is happening in a DC Motor.   a. DC electrical energy to mechanical…

A: A (DC) motor is a type of electric machine. It converts dc electrical energy into mechanical energy.…

Q: Find the amount of electrical energy expended in raising the temperature of 50 litres of water by…

A:

Q: Roofing nails, staples, and brads are sized by __________. Select one: A. DIAMETER B. PENNY SIZE C.…

A: We can sized it by their diameter .

Q: Give one source of energy and describe how electrical energy can be generated

A: Most human energy requirements are met by generating electrical energy. Once electrical energy is…

Q: 1. Refer to the graphics appendix. What resistance is most near the total resistance of the circuit?

A: This question belongs to circuit theory . It is based on the concept of calculation of total…

Q: How much power in kW can a machine do with 600 kWh of work in 12 hours?

A: kWh is the units of Energy  Energy is the product of power and time. Power expressed in kW and time…

Q: What is the thermal efficiency of an energy conversion machine if it requires 1130 joules of energy…

A: Input energy= 1130J Output energy= 790J Efficiency?

Q: Chassis resistance has an Ohm limit for patient safety, what is the Ohm limit

A: Chassis resistance has an Ohm limit for patient safety.

Q: What is the thermal efficiency of an energy conversion machine if it requires 1140 joules of energy…

A: Given parameter:- Input energy=1140 jules output or produce energy=840 jules   Thermal efficiency is…

Q: how did it came up with 2.5? can I see the process on how it was solved step by step? thank you! i…

A: The given circuit is shown below:

Q: Which of the following materials are used in PV cells ? a. Paper b. None of these c. Semiconductors…

A: PV cell is used to convert solar energy into electricity.

Q: A de motor draws a current of 40A at 220V. If 800 W is dissipated in the form of heat in the motor,…

A: Given: The current drawn by dc motor, I=40 A Voltage, V=220 V Power dissipated in form of heat,…

Q: measurements , describe how to read the values given on the measurement tools and to write about…

A: Extension rod- extension rod is used for extensive objects having large diameters, it is used along…

Q: At what load the efficiency of the  dc machines are the maximum

A: If the load current is such that the variable loss is the same as the constant loss, the dc…

Q: What is geothermal energy? With the aid of a schematic diagram, describe how we can generate…

A: We need define what is geothermal energy and with the help of  schematic diagram we need to explain…

Q: What is the Theory of the Thermal power plant and writes is step of functioning.

A: In power station, the component used to generate the electricity is alternator and in case of the…

Q: Whale and Kanmuro are two islands located at the Chimera archipelago. These two are separated by a…

A: Given,At full capacity,the delivered maximum power is,Pmax = 601 MWThe operating voltage is,V=527 kV

Q: What is the thermal efficiency of an energy conversion machine if it requires 1320 joules of energy…

A:

Q: An energy meter is designed to make 100 revolutions of the disk for one unite of energy consumption.…

A:

Q: How much time will be required to perform 520 J of work at the rate of 20 W? *

A: we know that Energy = power * time so from the given question Energy is 520 J P 20 W

Q: Explain how ASK operates according to the given figure.

A: First of all what you have mentioned here is about ASK its abreviation is A- amplitude, S- shift ,…

Q: 4. a) Describe briefly the basic parts of power conversion in wind energy systems

A: Principle of conversion wind energy- Nature of wind-               In the atmosphere there is…

Q: (a) Explain how the electrical power is obtained and how it is converted into other types of energy…

A: Electric car/vehicle  is run on electric supply .

Q: A soldering iron is rated at 50 watts when connected to a 250 V supply. If the soldering iron takes…

A: We have an soldering iron having, Power (P) = 50 W Supply voltage (V) = 250 V Time taken = 5 minutes…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.