Jimin applies a coating on a piece of glass to reduce its reflectivity when light with a frequency of 5.75 x 10¹4 Hz shines on it. If the material has an index of refraction of 1.375 and the glass has an index of refraction of 1.537, what is the minimum thickness the coating should have? (c = 3.00 x 108 m/s) 60.0 nm 145 nm 94.9 nm 65.2 nm

Jimin applies a coating on a piece of glass to reduce its reflectivity when light with a frequency of 5.75 x 10¹4 Hz shines on it. If the material has an index of refraction of 1.375 and the glass has an index of refraction of 1.537, what is the minimum thickness the coating should have? (c = 3.00 x 108 m/s) 60.0 nm 145 nm 94.9 nm 65.2 nm

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter38: Refraction And Images Formed By Refraction

Section: Chapter Questions

Problem 26PQ

See similar textbooks

Similar questions

A horizontal laser beam of wavelength 632.8 nm has a circular cross section 2.00 nun in diameter. A rectangular aperture is to lie placed in the center of the beam so that when the light falls perpendicularly on a wall 4.50 m away, the central maximum fills a rectangle 110 mm wide and 6.00 mm high. The dimensions are measured between the minima bracketing the central maximum. Find the required (a) width and (b) height of the aperture. (c) Is the longer dimension of the central bright patch in the diffraction pattern horizontal or vertical? (d) Is the longer dimension of the aperture horizontal or vertical? (e) Explain the relationship between these two rectangles, using a diagram.
A source emits monochromatic light of wavelength 495 nm in air. When the light passes through a liquid, its wavelength reduces to 434 nm. What is the liquid's index of refraction? (a) 1.26 (b) 1.49 (c) 1.14 (d) 1.33 (e) 2.03
A beam of 580-nm light passes through two closely spaced glass plates at close to normal incidence as shown in Figure P27.23. For what minimum nonzero value of the plate separation d is the transmitted light bright?
Astronomers observe the chromosphere of the Sun with a filter that passes the red hydrogen spectral line of wavelength 656.3 nm, called the H line. The filter consists of a transparent dielectric of thickness d held between two partially aluminized glass plates. The filter is held at a constant temperature. (a) Find the minimum value of d that produces maximum transmission of perpendicular H light if the dielectric has an index of refraction of 1.378. (b) What If? If the temperature of the filter increases above the normal value, increasing its thickness, what happens to the transmitted wavelength? (c) The dielectric will also pass what near-visible wavelength? One of the glass plates is colored red to absorb this light.
Both sides of a uniform film that has index of refraction n and thickness d are in contact with air. For normal incidence of light, an intensity minimum is observed in the reflected light at λ2 and an intensity maximum is observed at λ1, where λ1 > λ2. (a) Assuming no intensity minima are observed between λ1 and λ2, find an expression for the integer m in Equations 27.13 and 27.14 in terms of the wavelengths λ1 and λ2. (b) Assuming n = 1.40, λ1 = 500 nm, and λ2 = 370 nm, determine the best estimate for the thickness of the film.
A thin layer of a transparent material that has an index of refraction of 1.25 is used as a nonreflective coating on the surface of glass that has an index of refraction of 1.50. What should the minimum thickness of the material be for the material to be nonreflecting for light that has a wavelength of 578 nm?
The light from a krypton laser has a wavelength of 647.1 nm in air. As the light travels from air into acrylic glass (n =1.491), calculate (a) its speed in acrylic glass, (b) its wavelength in acrylic glass, (c) its critical angle in acrylic glass surrounded by air, and (d) its frequency.
A soap film, 4.5 x 10-7 m thick, is illuminated by white light normal to its surface. The index of refraction of the film is 1.50. What wavelength will be intensified in the reflected beam? 450 nm 540 nm 420 nm 675 nm 600 nm