k0.9 m. The 3 kg slider is released from rest at A point A and slides with negligible friction in a vertical plane along the circular and straight rod. The attached spring has a stiffness of 350 N/m and has an unstretched length of 0.6 m. Determine the distance x when the velocity of slider is zero. IB 1.8 m

k0.9 m. The 3 kg slider is released from rest at A point A and slides with negligible friction in a vertical plane along the circular and straight rod. The attached spring has a stiffness of 350 N/m and has an unstretched length of 0.6 m. Determine the distance x when the velocity of slider is zero. IB 1.8 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Questions b and c. The pressure from part a is 0.86832 Mpa
Determine: -vertical component of reaction at C Last time i post but answer is wrong expert did not consider moment 60 kn. M Please consider moment
There is a (45/10) kg slider ring is going down from the rest position A and slides in frictionless guide pipe as seen in the picture below. (h= 5+5 m.) For this situation, please determine the velocity as the slider ring at B and calculate the maximum compression of the spring in millimeters.
The piston C moves vertically between the two smooth walls. If the spring has a stiffness of k = 15 lb/in., and is unstretched when θ = 0°, determine the couple M that must be applied to AB to hold the mechanism in equilibrium when θ = 30°.
Compute the value of EIy at 2.5 m from the left support.
Determine the force that the smooth 40-kg cylinder exertson members AB and CDB. Also, what are the horizontaland vertical components of reaction at pin A?
Properties: • b1 = 300 mm • b2 = 180 mm • d1 = 250 mm • d2 = 350 mm • f'c = 28 MPa • fy = 414 MPa • eccentricity = 200 mm Determine the following: 1. Location of the plastic centroid measured from the y-axis in mm 2. Depth of the compression block in mm 3. Nominal Axial in kN 4. Moment Capacity in kN-m
The cylinder weighs 10 lb and is held in equilibrium by the belt and wall. If slipping does not occur at the wall, determine the minimum vertical force P which must be applied to the belt for equilibrium. The coefficient of staticfriction between the belt and the cylinder is μs = 0.25.
The three forces act on the pipe assembly. If F1 = 80N and F2= 50 N replace this force system by an equivalent resultant force and couple moment acting at O. Express the results in Cartesian vector form.
A minimum force of P = 50 lb is required to hold the cylinder from slipping against the belt and the wall. Determine the weight of the cylinder if the coefficient of friction between the belt and cylinder is μs = 0.3 andslipping does not occur at the wall.
Determine support reaction at B . Given P=100 Kn L=10 m
Determine support reaction. Given a=5 m b=10 m P=30 KN