Length of Pipe 3 = 210 m Length of Pipe 4 = 450 m *Pipe 2 and Pipe 3 are parallel Diameter of Pipe 1 = 200 mm Diameter of Pipe 2 = 150 mm Diameter of Pipe 4 = 250 mm discharge of the pipe system = 45 Liters/second Total hf = 8 meters f= 0.02 What is the diameter of Pipe 3? (in mm)

Length of Pipe 3 = 210 m Length of Pipe 4 = 450 m *Pipe 2 and Pipe 3 are parallel Diameter of Pipe 1 = 200 mm Diameter of Pipe 2 = 150 mm Diameter of Pipe 4 = 250 mm discharge of the pipe system = 45 Liters/second Total hf = 8 meters f= 0.02 What is the diameter of Pipe 3? (in mm)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Three pipes are connected in parallel, The difference in heads in each pipe is 40 m. Pipes Diameter…

Q: 4. Using the figure below, find the time it takes for tank 2 to increase water level by 2m. (C =…

Q: PROBLEM 6: A gasoline line is connected to a pressure gage through a double-U manometer, as shown.…

A: Pgage =260kPa To find gage pressure of gasoline line

Q: 75-mm inside diameter Flow 0.25 m 200- mm inside 0.60 m diameter Water

A: Venturi meter is used to find the rate of flow through closed pipe . Venturi meter has 3 parts…

Q: 10. What is unit for flow rate for gases? a) m³/s b) litres/s c) cm³/s d) kgf/s

A: Explanation : m3/sec, litres/sec and cm3/sec are the units for discharge. The unit flow rate for…

Q: 2) In the figure shown pipes are in parallel connection with properties given. If the flow into the…

Q: Find the loss of head when a pipe of diameter 200mm is suddenly enlarged to a diameter of 400mm. The…

Q: Water with a velocity of 4.13 m/s flows through a 119 mm diameter pipe. Solve for the volume flow…

Q: A cylindrical tank 400 mm in diameter, discharges water through a 30 mm orifice under a constant…

A: given:Diameter of orifice, d=30 mm or 0.03 mhead above orifice, h=5 mg=9.8 m/s2Q2: Diameter of pipe,…

Q: If 150 L/s of water flows through the system shown in the figure below, calculate the pressure at 2.…

A: For the point 1 - P1 = 0, V1 = 0, Z1 = 35m For the point 2 - Z2 = 0

Q: A cylindrical tank having a diameter of 1.5 m and a height of 4 m. is open at one end and closed at…

A: To determine the value of distance h. Given, Diameter of the tank (D) = 1.5 m Height of the tank…

Q: A fluid flowing through a pipe of diameter 450 mm with velocity 3 m/s is divided into two pipes of…

Q: 1.) Water flows at 10m3/s in a 150-cm diameter pipe; the head loss in a 1000-m length of this pipe…

A: Losses in pipe: Two types of energy losses are considered in the pipe, there are major losses and…

Q: FIGURE Q2 The diameters of the nozzle and the pipe are given by dn = 25 mm and d, = 50 mm,…

A: To determine flow rate through the nozzle and the pressure at points A and B. Given, Diameter of…

Q: A nozzle of inner radius 1.04 mm is connected to a hose of inner radius 8.55 mm. The nozzle shoots…

Q: Three pipes of different lengths and diameters are connected in series and discharge 160 liters/s.…

A: The Darcy Weisbach equation generally explains an empirical equation that relates the head loss and…

Q: PROBLEM 40 : An orifice 30 mm diameter is located at the vertical side of a tank having water 1 m…

A: As per our guidelines we are supposed to answer only first question. Kindly repost other questions…

Q: Question 3 a) Consider the water container with a conical plug at the bottom, as shown. Determine…

Q: Topics: Fundamental of fluid flow In Lake Geneva (Switzerland), there is a water jet (called the…

A: step 1-

Q: A circular pipe of diameter 0.5 m carries the discharge of 50 litres/s. The head loss due to…

Q: A three-fluid system (immiscible) is connected to a vacuum pump. The specific gravity values of the…

Q: Problem 4. An infinitely large tank is supplying air at a constant gage pressure of P 3 kPa through…

A: Since we answer only three sub-parts so will answer the first three. Please upload another question…

Q: Pipe No. Length - m Diameter - cm 1 1000 90 2 500 50 600 40 4 800 700 75

Q: A tank contains gasoline and glycerine with open piezometer tubes attached as shown. The depths of…

Q: SUPPLEMENTARY QUESTION The figure shows two reservoirs connected by a pipe. The discharge rate in…

A: From the given problem, the SN value was not given. I'm taking SN = 26

Q: A cylindrical tank contains air, oil and water, as shown; the air is under gage pressure p = 60 kPa.…

Q: Water flows through a 75 mm diameter pipe at a velocity of 3 m/s. Find the mass flow rate in kg/sec…

Q: diameter of pipe = 200mm Cc = 0.61 Cv = 0.97 Considering the figure, what is the flow of water?

Q: 4. A large tank has a height of 5.0 m and an area (in plan) of X m2. It has a small outlet (orifice)…

Q: Question: Water is flowing in the vertical pipe system shown in the figure. Water exits to the…

A: The given figure is shown below:

Q: Water flows from the rectangular outlet as shown in the figure. Estimate the flow rate per unit…

A: The pipe flow always follows Bernaullis Equation i.e discharge at all the section will be equal. But…

Q: A nozzle meter is connected with a pipe line to measure fluid flow rate as shown in Fig. 2. The…

Q: Heavy oil discharges from a pipe through a sharp-crested, 100-mm-diameter orifice having discharge…

Q: Water flows from the rectangular outlet as shown in the figure. Estimate the flow rate per unit…

Q: Two tanks connected by three pipes in series are shown in Figure 2. The lengths of these pipes are…

A: Calculate entry loss and friction loss for the first pipe:

Q: The performance data for a centrifugal water pump are shown in Table below for water at 20°C (Lpm :…

A: Solution Given Tabulated Data Case V, LPM H, m bhp, W 1 0.0 47.5 133 2 6.0 46.2 142 3 12.0…

Q: 3250 ft of 12 in 2 2750 ft of 21 in 2250 ft of 10 in 4750 ft of 27 in A 1 + B 3 -- C 5 D 2750 ft of…

Q: A circular pipe of diameter 0.5 m carries the discharge of 50 litres/s. The head loss due to…

Q: Q1: Air flows through a pipe that consists of two sections at a specified rate. The differential…

A: The given data is shown below:

Q: Three pipes are connected in parallel. The difference in heads in each pipe is 40 m. Pipes Diameter…

Q: PROBLEM: In Lake Geneva (Switzerland), there is a water jet (called the Jet d'Eau) that is…

Q: In the figure shown pipes are in parallel connection with properties given. If the flow into the…

Q: The velocity of the water jet discharging from the orifice can be obtained from V= V/2gh, where h= 2…

Q: Problem 2: A 0.10 m^3 volume of water is observed to be 0.0982 m^3 after a pressure is applied. What…

Q: A pump discharges water through a horizontal pipeline at 30 L/s. At a point in the suction side of…

A: Given data, Q = 30 L/s Suction side Diameter (D1) = 100 mm Suction side pressure (p1) = 125 Kpa…

Q: Water at 10 °C is pumped from a lake as shown in the figure below. If the flowrate is Q=0.018 m³/s,…

Q: In the figure shown, the distance y + 1/2 z = 1.20 m. When fluid A is water, fluid B is mercury, and…

A: Given data: y+z2=1.2 fluid A is water Fluid B is mercury pressure at m = 37 kPa vacuum

Q: The flow rate of water through a 10-cm-diameter pipe is to be determined by measuring the water…

A: Solution The answer of the above question is in second step

Q: EXAMPLE 10.1 The internal and external diameter of the impeller of a centrifugal pump are 300 mm and…

A: D1=300mm D2=600mm N=1000rpm

Question

Length of Pipe 1 = 300 m

Length of Pipe 2 = 240 m

Length of Pipe 3 = 210 m

Length of Pipe 4 = 450 m

*Pipe 2 and Pipe 3 are parallel

Diameter of Pipe 1 = 200 mm

Diameter of Pipe 2 = 150 mm

Diameter of Pipe 4 = 250 mm

discharge of the pipe system = 45 Liters/second

Total hf = 8 meters

f= 0.02

What is the diameter of Pipe 3? (in mm)

150 mm ø, 240 m
2
200 mmø 30o m
250 mmøs 450 m
4
D= ? > 210 m
3
Solution:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A 15 ft long , 6 ft rectangular tank open to the atmospher is towed by a truck on a level road. The tank is filled with water to a depth of 5 ft. Determine the maximum acceleration or deceleration in ft/s^2 allowed if no water is to spill during towing. Show the free body diagram. a.5.23 b.4.29 c.6.45 d.7.02
An orifice (area = 0.035 ft^2) is placed at the bottom of a cylindrical (diam = 5.93 ft) container. Determine the time (minutes) required for the head to fall from 4.99 ft to 2.35 ft. Use Cc = 0.67, Cv = 0.93. Round of to two decimal places.
Convert the units:Use 1 mi = 5280 ft and 1 h = 3600 s to convert 60 mph to units of ft/s.
4. The box of negligible size is sliding down along a curved path defined by the parabola y = 0.38x ^ 2 When it is at A(x_{A} = 2m, y_{A} = 6m) , the speed is v_{B} = 30kph and the increase in speed is d*v_{B} / d * t = 14 m/s^ prime . Determine the magnitude of the acceleration of the box at this instant.
Two cars A and B have a velocity of 21.00m/s in the same direction. Car A is 58.12m behind Car B when the breaks are applied to Car B, causing it to decelerate at a constant rate of 3m/s2. a. In what time will A overtake B? b. How far will car B travel? c. What is the relative velocity of car B with respect to car A when A overtakes B? 3 decimal places only
Water, at a rate of 10 ft3 /min, is pouring into a leaky cistern whose shape is a cone 16 ft deep and 8 ft in diameter at the top. At the time the water is 12 ft deep, the water level is observed to be rising at 4 in/min. How fast is the water leaking away in ft/hr? a. 0.575 b. 9.42 c. 34.51 d. 565
Convert 350 gpm into cfs and m3 /hr.
The position of a particle moving along the x-axis is given by x=t^3+3t^2 -9t-6, when t =1sec particle is 11m to the right of origin. (a) When t=2 sec, determine v and a. (b)During the time interval from t=0 to t=2sec, determine the v(ave) and v(ave )speed
The velocity of a particle traveling along a straight line is v = (8t ^ 2 - 9t) * f * t / m * i * n , where t is in mins. s = 6m when t = 0min , determine the position of the particle when (a) t = 0.6min and (b) t = 0.2min .
The motion of a particle moving in a horizontal direction is described by its position x(t). Determine the position, velocity, and acceleration at t=1.5s ifc) x(t) = 10sin(10t) + 5e5t
Santa Claus sleigh starts from rest and accelerates at a= 30+20t, until its velocity is constant at 400 m/s. It then hits an iceberg and the equat ion of the acceleration is a= -0.003 v^2 until the velocity decreased to 100 m/s. Compute the time the sleigh reaches v=400m/s What is the total distance Santa Claus traveled? Computethe total time of travel.
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. Block B starts from rest and then moves to the right with a variable acceleration given by the acceleration-time curve. Determine:(a) the acceleration(b) the velocity of block A at t = 3.71 s.*dont copy other experts' answer, i'm looking for a different approach in solution