logic circuit with tree inputs A,B,C and an output Q that goes LOW only when A is LOW while B and C are different. develop the truth table and give MINIMIZED boolean expression of the output Q. which logic gate produce 1 at the disabled state

logic circuit with tree inputs A,B,C and an output Q that goes LOW only when A is LOW while B and C are different. develop the truth table and give MINIMIZED boolean expression of the output Q. which logic gate produce 1 at the disabled state

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Related questions

Q: 10-Draw the synchronous generator phasor diagram for unity, lag and lead power factor.

A: An alternator also called the synchronous generator is an electrical device that converts mechanical…

Q: Find the total charge lying within the cylinder, p = 3, ,-2 ≤ z ≤ 2, if Ď =: 20 Z (b) 5z² sind) āp…

Q: 4- a) Find vo and io in the circuit below.

Q: For this problem, each transformer is a single-phase ideal transformer with turns ratio N1:N2 =…

Q: Consider an extrinsic semiconductor. Given: Un = 6550 cm² /V sec = 400 cm²/V sec Hp = n₁ = 5.6 x…

A: The conductivity of an extrinsic semiconductor is given by the following equation:where:σ is the…

Q: Chapter 14, Problem 61. Find the transfer function for each of the active filters in Fig. 14.90. +0…

A: Opamp has a negative feedback so according to the virtual ground concept, inverting terminal voltage…

Q: lot the amplitude and phase spectrum for the f(t) = 4cos(nfot +30°) + 2 sin(aft)

A: In this question, we need to plot the amplitude and phase spectrum of the given function.

Q: R₁ '8 Ω 12 + E₁32 V 6A R₂240 R14

Q: There phase power supply load R is 1699 VA, S is 15584 VA and T is 12818 VA. Find (a) the…

Q: Find the current in the 6K2 (1x) resistor (I_X) USE THE FOLLOWING METHODS e) Thevenin equivalent…

Q: In the circuit shown in Figure A3, with the use of Thevenin's theorem, determine the value of…

A: Given:Required:We need to calculate the current I flowing through the 4 Ohm resistor and also the…

Q: ! Required information Element values of 8 mF and 2 nH are employed in the construction of a simple…

A: Given Data:A source-free RLC circuit with,Resistor Inductor Capacitor Initial conditions,To Find:The…

Q: 2.40 For the Network fig (3) O I R₁ 55 M R₂ Calcuate Iz V 3₂ VS, V PRE Ru www 21 V₂RzY2 V₂ Rs6n…

A: The given circuit is

Q: The following figures show the block diagram of a memory-based state machine with two inputs A and B…

A: According to the question, we need to find how many states we need to insert into the ASM chart in…

Q: The op amp in the circuit given below has Ri= 100 k, Ro= 100 , vs= 2 mV, and A = 100,000. Vs 100 Ω…

Q: how many IC in each gates? explain

A: According to the question, for the given circuit diagram as shown belowWe need to find total number…

Q: In a RC type low pass fitter, the cut-off frequency is 1500 Hz, Assuming the capacitance to be 500…

A: It is given that:

Q: for a 20kW PM synchroneous generator that produces 400V and 50A at its output. the resistance of the…

A: The given information about the PM synchronous generator is written below.Frequency Hz.Magnetic…

Q: Determine n and the percentage of the total power carried by the sidebands of the AM wave for tone…

Q: Find the inverse laplace of the following:

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: Use superposition to solve for i, and v, in the circuit.( Figure 1) Take v = 20 V and i = 3.6 A.…

A: The circuit diagram is given as,The voltage is .The current is .Using the superposition theorem, we…

Q: Question 3 A two-winding transformer rated at P = 90 kVA, V₁/VH=240/1200 V, f = 60 Hz. When this…

Q: Q2(b) Find the voltage across capacitor and the current passing through inductor L₁ and L₂ for the…

A: The given circuit isWe need to find the voltage across the capacitor and the currents flowing…

Q: What is diode and transistor?

A: Define diode and transistor?Here we need to define diode and transistor.

Q: 12V 1KQ (a) 2KQ www Io www ΣΚΩ 2mA www 1KQ Problem: Calculate Io using superposition.

Q: Use the node-voltage method to find the total power dissipated in the circuit in the figure if i₁ =…

A: Given:Required:We need to find the total power dissipated in the circuit.

Q: 306 CHAPTER 10 Lighting Branch Circuit-Bathrooms, Hallway 11. Circle the correct answer as to…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: What is transformer in electrical engineering?

A: it was asked to explain the term transformer in terms of electrical engineering domain

Q: Can you draw its equivalent circuit for furtger understanding and easy analysis. Also can you…

A: The above question is based on the DC analysis of the BJT circuit.

Q: QUESTION 20 O b ww R C For the circuit shown above, what is the magnitude of the equivalent…

A: Given:A circuit, with, To find:Magnitude of the equivalent impedance seen from a-b terminal.

Q: A balanced, three-phase circuit is characterized as follows: Y-A connected; ● ● ● Source voltage in…

A: In this question, we need to determine the single phase equivalent circuit of phase a, Given Data:A…

Q: 1. Let v(0) = 2 V and i(0) = 1 A in the circuit shown. Find the voltage vo(t) across the capacitor…

A: We need to find the voltage across the capacitor V0(t) for t>=0 using nodal analysis.

Q: If VGG = -1.5V calculate Vout and rds. verify answer in NI Multisim.

A: The given value of .Calculate the value of and .Here, the given diagram is,

Q: A single-phase 60-Hz power line is supported on a horizontal crossarm. The spacing between…

A: Distance between power conductors is 8ft.The distance between telephone conductors is 2ft.

Q: (b) A 2500 V, 1200 kVA, 0.80 power factor (PF) lagging, four-pole, A-connected synchronous generator…

A: Given:V=2500VS=1000KVAPower factor=0.8 laggingsynchronous reactance X=1.4 ohmArmature resistance R=…

Q: The value of n()" is n=0

A: It is given that:

Q: What are the potential applications of a finite state system

A: A finite state system also known as a finite state machine (FSM) is a computational model used to…

Q: (a) A discrete-time input signal is given by: [Suatu isyarat masukan masa-diskret diberikan oleh:]…

Q: An angle-modulated signal with carrier frequency o 2 x 10 is described by the equation PEM (1) = 10…

A: It is given that:The angular frequency of the carrier is The angle modulated signal is given as:

Q: A combinational circuit has 3 outputs F1, F2 and F3: F₁ = xyz + xy F₂ = xyz +xy F3 = xyz + xy Design…

Q: The drawing shows a straight wire carrying a current I. Above the wire is a rectangular loop that…

A: The circuit diagram,

Q: Write a findings to the 3 different circuits attached.

A: Given three different circuits are(1) Half wave rectifier,(2) center tapped rectifier,(3) bridge…

Q: Complete The timing diagram and the AND gate by drawing the input (A, B, C) and the output (F)…

A: given that Function F as F = A'B'C' + A'BC' + ABC'with three inputs and one output

Q: 9- Explain how does a synchronous generator work. Support your answer with drawing. generator phasor…

Q: Given the output equations for convolutional code: c₁(1)=b (1) + b(1-1) + b(1-2) c₂(1)=b (1-1) +…

A: Given the output equations for convolutional code is shown below...The received message is.It is…

Q: What is transistor in electronic

A: A transistor is a fundamental semiconductor device used in electronics to amplify and switch…

Q: Figure 2 gives the electric potential Vs(x) along a copper wire carrying a uniform current, from a…

A: Radius of the copper wire .Conductivity of conductor .Highest potential .Total length .

Q: Q3: Multiple Choice Questions: 1. An ideal operational amplifier has A. zero input impedance B.…

A: Given:Here, we are given multiple statement based questions.Required:We need to mark correct answer…

Q: 10V + Is R1 R2 R4 R3

Q: ! Required information Element values of 8 mF and 2 nH are employed in the construction of a simple…

Question

A logic circuit with tree inputs A,B,C and an output Q that goes LOW only when A is LOW while B and C are different. develop the truth table and give MINIMIZED boolean expression of the output Q.

which logic gate produce 1 at the disabled state

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Taken required information to find truth table and logic circuit

VIEW

Step 2: finding the truth table and logic circuit

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Design a gating circuit which lights up a bulb, when its 4-bit binary number inputs detected the presence of a number divisible by 2.a. Show the truth table for this logic circuitb. State and simplify the Boolean expression using Karnaugh Mapc. Draw the logic circuit.
Design a combinational Logic circuit in which whenever input is an even number between 1 and 10 a light bulb switches on. Extract and simplify the min terms from the Truth table deduced from the problem definition and state the Boolean expression for output F.
For the logic circuit shown: 1. Write the Boolean expression that directly implements this circuit. 2. Simplify the Boolean expression using Boolean identities. Identify the identities used as each step. 3. Simplify the Boolean expression using a Karnaugh map. Show the sum of products form, the truth table, resulting map with the groupings marked, and the simplified expression. 4. Draw the combinational circuit resulting from the simplified circuit.
For given logic circuit, a)Build the math model. b)Configure the truth table.
a. Fill in the Karnaugh map for the logic functiondefined by the truth table.b. What is the minimum expression for the function?
a. Fill in the Karnaugh map for the logic function defined by the truth table of Figure below.b. What is the minimun expression for the function?
2. Give the Truth table, Boolean expression and logic circuit diagram for a 1 to 8 demultiplexer
24.2) Simplify the given Boolean expression and draw the logic diagram for the solution.
. Design the logic circuit of the Following Boolean Expression and write truth table F=(A' + B') (C' + D') F=(A' + B') (C' + D')(B' + D')
4.1 Investigate if the following Boolean “identity” is correct, or not. If it is not correct, formulate the correct version of the identity (?′?+?)′=?+?′?′. [2]4.2 Use the identities of Boolean algebra to verify the following identity: [4]?(?+?)+??′+??′+?=?+?+?4.3 Consider the logic gate circuit below:a) Formulate the Boolean expression corresponding to the output of the logic circuit diagram above. [2]b) Hence, show that the Boolean expression formulated in part (a) reduces to ??+?. [3]c) Draw the logic gate circuit diagram corresponding to the reduced expression inpart (b) above. 3.1 Let r, s, t denote the statements “Joe is registered for MCI511S”, “Joe will go to the zoo next week”, “Joe is registered for PBT512S”, respectively. Translate the symbolic statement (∼?∨?)→∼? into words. [2]3.2 Write the negation of the statement “If Joe writes the exam, he will go the airport but he will not catch the flight”. [2]3.3 Determine the truth value of the compound statement (?∧∼?)∨∼?, if p…
*A traffic light system uses logic gates as part of the control system. The system is operated when the output D has the value . This happens when either (a) signal A is red or (b) signal B is green and signals B and C are both red( NOTE: Assume for this problem that red=0 and green =1) Deduce the truth table for the system and the Boolean expression from the truth table, Hence Design a logic circuit or network
1. Given the Boolean expression (b + d)(a’+ b’ + c),a. Convert the expression to the other standard form. What do you call this standard form?b. Derive its canonical form. What do you call this canonical form?c. Derive the other canonical form. What do you call this canonical form?d. Provide the truth table of the expressione. Draw the logic circuit diagrams of the 2 standard forms