Loose refuse with no processing or compaction has a bulk density of Alb/yd³.

Q: Cantilever beam loaded as shown in fig., draw the shear force diagram and bending moment diagram. 20…

A:

Q: Calculate the Moment of inertia about XX AXIS

A:

Q: Find the flow rate in m'/sec/m at right angles to the cross section shown through the permeable soil…

A:

Q: Help Save & Exit S Check my w Consider a uniform right circular cone of specific gravity S < 1,…

A:

Q: Consider two axially loaded columns, namely, 1 and 2, made of a linear elastic material with Young's…

A:

Q: Define the seismic isolation strategy of the building

A: Given data: seismic isolation strategy.

Q: Explain how the concentration of a pollutant is related to the severity of its impact on the…

A: Pollution will affects the Earth's land, air, and the water by releasing the various pollutants in…

Q: t diameter 30 cm and throat diameter 15 c fferential manometer shown a reading of 25

A:

Q: What is the recommendations of Bulk density of concrete lab test? What is the errors that might…

A: Explanation- The density testing in hard concrete is performed to determine the relative yield, and…

Q: 58. What can be the phase inspections done by local authority while construction?

A: Brief concept introduction- Inspection- It is a process of careful examination. Inspection is a very…

Q: 10. For isothermal flow and non-flow steady processes, prove that S₁ pdv v.dp 1 Also state the…

A:

Q: A compound shaft drives three gears, as shown. Segments (1) and (2) of the compound shaft are hollow…

A:

Q: What is the errors that might happen on this lab test and how to prevent it?

A: Adsorption tests determine the water absorption capacity of hardened concrete by capillary suction.…

Q: Problem 3: M1 = 5.5 1) (2) 8₂ = 12° Air at Mach, M1 = 5.5 at a pressure of P1 = 70 kpa flows along a…

A:

Q: the deflection curve of the simply supported beam of Fig. 8-7 subject to the uniformly distributed…

A:

Q: A concrete beam of rectangular cross section of 200 mm x 400 mm is prestressed with a force 400 kN…

A:

Q: The force F is directed from A toward D and D is allowed to move from B to C as measured by the…

A:

Q: A 20 KN weight is suspended by two wires as shown in the figure. The length of each wire is 2 meter.…

A:

Q: Cantilever beam loaded as shown in fig., draw the shear force diagram and bending moment diagram. 20…

A: A fixed beam is given with the load diagram as shown in the figure above and it has been asked in…

Q: A steel cantilever beam is of 1 m long, having a squa of 4 cm side length. The beam is fixed on one…

A: The given data is: Beam length, L=1 m Cross section=4 cm*4 cm E=210 GPa

Q: Estimate the inside volume of a soda can. We have used a ruler to measure the height and the…

A: Given:- d=6.3cm Ht=12cm To find:- Inside volume

Q: The following observations on maximum concrete pressure (KN/m2) were selected from a normal…

A: first calculate the mean of given data next find standard deviation

Q: Q-1: Determine the resultant force at pins A, B and C on the three member frame. 800 N С 200 N/m 2m…

A: length of member AC = 2sin 600= 2.31 m load on member AC = 200 x 2.31 =462 N horizontal component =…

Q: s from a spillway with a velocity of 15 m/sec and critical depth at the toe of the spillway for the…

A:

Q: Check my A solid block, of specific gravity 0.93, floats such that 75% of its volume is in water and…

A: Problem details of immersed bodies is given.

Q: Consider the following Global Carbon Cycle information to answer the question: 29 Gt out from fossil…

A: A Pre-industrial carbon cycle would be in or out balance as due to the absence of industries the…

Q: 1m 1m² fy x 3m 1.8m 3m 52m L 0.5 m Im 1m 2m >X

A: For ease of calculation first let's assume the origin at the extreme left of the diagram as shown…

Q: Cantilever beam loaded as shown in fig., draw the shear force diagram and bending moment diagram. 20…

A: Consider the figure,

Q: Q/ The force in the member (CA) is 12m 50 ку. 5m

A:

Q: The 52-kg cylinder is suspended from a clamping collar at C which can be positioned at any…

A:

Q: d waste in a landfill to the nearest $10/ton? (tipping fee) $ 50/ton $ 70/ton

A: Municipal solid waste is known as garbage especially discarded after usage like cloths, packaging,…

Q: If M₂ = 285 kip-ft, find the magnitude of the bending stress at a point H. For the beam cross…

A:

Q: Calculate the corresponding drawing measurement (in inches) of an actual dimension of 40 miles using…

A:

Q: Draw the NTM diagrams for frame on the picture. 90= F/a 10000 a 2a F = 1 kN a = 1 m

A:

Q: Four columns of a building are to be located within a plot size of 10 m x 10 m. The expected load on…

A: given bearing capacity = 100kn/m2 column load =4000kN Area required for each isolated footing =…

Q: Give the reasons both in favor of and against the use of personal time charge as a cost estimate for…

A: In favor Personal time spend on the project must be charged in the cost estimate of the project as…

Q: The beam shown in Fig. is made from two boards. Draw the shear stress at (A.B.C.D) to hold the…

A: Reaction calculation For equilibrium of static  (i)∑ME = 0 (ccw +ve, cw -ve) (RE x 8) - [6.5 x 4 x…

Q: PORTAL METHOD Analyze the Frame using Portal Method. Disregard the area given of the column. P 0 R…

A:

Q: 3= The state of strains at a point are defined as follows. Find X and Y such that the normal and…

A:

Q: Find the stresses in A, B and C?

A:

Q: Q/ Find the reaction forces at point (B)

A: Given Data:W=300kg= 300×9.81=2943NL=3.6m

Q: of active & Passive of 8m in dey an angle of of 18 kN lm 3 intensities of active pressure if the…

A: Case 1 When soil is dry For cohesionless soil Ka=1-sinϕ1+sinϕ Kp=1+sinϕ1-sinϕ Active earth pressure…

Q: 1. Event: A large landslide occurred in a mountain hillside near a large, populated city in a sunny…

A: The main reasons behind the landslide are : Road construction on hill slope making it unstable  and…

Q: Q2) A concrete slab shown in the figure (2) has a thickness of 130 mm. It supports a service…

A:

Q: A catchment has an area of 150 hectares and a run-off/rainfall ratio of 0.40. if due to 10 cm…

A:

Q: Problem I. With the ongoing extension of Manila Skyway, a series of 250 mm diameter circular poles…

A: The given load acting on the pole and at the base cross section can be shown below The combined…

Q: -, and mat midspan (i.e., x = 2.7 m). O kN-m² for the beam; MA = 7.2 kN-m, wo = 17.9 kN/m, L

A:

Q: Define imbibition and drainage

A: Imbibition refers to the increasing the wetting-phase saturation. Drainage refers to the decreasing…

Q: A catchment has an area of 150 hectares and a run-off/rainfall ratio of 0.40. if due to 10 cm…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: 33.503 KNV/M 16.187 KN/M 14.094 KN/M B 2m 17 3 1 7M (BMD) and Find the Bending moment diagram Shear…

A:

Collection Systems

The collection systems form a part of sanitary engineering, which is a sub-branch of civil engineering. It is also known as public health engineering and wastewater engineering. It is a methodology followed to remove and properly dispose of human waste, along with creating systems to provide safe and clean usable water. These measures ensure a hygienic and disease-free community. Sanitary engineering, apart from building sewer disposal units, is also involved in plumbing, fire protection, hydraulics, life safety, environmental protection, information technology, microbiology, pathology, and so on.