Please provide Handwritten answer QUESTION 3Figure Q3(a): Single pendulumа)A single pendulum is controlled by force u as shown in Figure Q3(a). The harmonicequation of motion is given as, d²0dt2ml -+ mgl 0 = l uwhere m is the mass of the bob, l is the rod's length and g is the gravitational force.Evaluate the system's controllability and observability.

m Figure Q3(a): Single pendulum а) A single pendulum is controlled by force u as shown in Figure Q3(a). The harmonic equation of motion is given as d²0 ml?. + mgl 0 = l u dt2 where m is the mass of the bob, l is the rod's length and g is the gravitational force. Evaluate the system's controllability and observability

m Figure Q3(a): Single pendulum а) A single pendulum is controlled by force u as shown in Figure Q3(a). The harmonic equation of motion is given as d²0 ml?. + mgl 0 = l u dt2 where m is the mass of the bob, l is the rod's length and g is the gravitational force. Evaluate the system's controllability and observability

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

PART OF MECHANICAL VIBRATIONS Derive the differential equation of motion of the inverted pendulum shownin Fig. P3.8. Let m = 0.5 kg, l = 0.5 m, a = 0.2 m, and k = 3000 N/m. Determine the damping coefficient c if: (a) the system is underdamped withξ = 0.09, (b) the system is critically damped; and (c) the system is over-damped with ξ = 1.2. In these three cases determine the angular displacementand velocity after 0.4 s if the system has zero initial velocity and initialdisplacement of 4◦ counterclockwise
A washing machine with a mass of 60 kg and a drum radius of 15 cm, rotates at 1000 rpm and washes 3 kg of unbalanced laundry. a) How much dynamic force would be transmitted to the ground if no vibration isolation was taken from the machine?b) What would be the stiffness (k) of the visco-elastic floor if an insulation measure with a damping ratio of 0.1 was taken, which would reduce the force transmitted to the floor by 90%?
In the system in the figure, the static equilibrium position of the thin, slender homogeneous rod of mass m and length L is horizontal.During the movement of the system, the bar is separated from the horizontal by small angles. (A makes oscillating motion with small angles relative to the simple support point)a) Find the equation of motion of the system in terms of the given parameters.b) Since M=4 kg, m=1 kg, L=1 m, k=600 N/m, c=200 Ns/m, F=300 N, w=4 rad/s, is there resonance in the system? If there is resonance, what would you recommend to get rid of resonance?
PART OF MECHANICAL VIBRATIONS SUBJECT USE VIRTUAL WORK The uniform bar shown in Fig. P3.6 has mass m, length l, and mass moment of inertia 1 about its mass center. The bar is supported by two springs kı and k2, as shown in the figure. Obtain the differential equation of motion and determine the natural frequency of the system in the case of small oscillations.
A spring-mass system is shown in the following figure. Use m=3.5 kg and k=100 N/m. a. Determine the static deflection δst . Insert your answer in meters correct up to at least a third decimal place. b. Determine the system period τ. Insert your answer in seconds correct up to at least a third decimal place. c. Determine the maximum velocity vmax which results if the cylinder is displaced 140mm downward from its equilibrium position and released from rest. Insert your answer in m/s correct up to at least a third decimal place.
A 0.31kg block rest on a orizonal surface and is attached to a spring (constant=41 N/m ). The block is initially moved 9cm from equillibrium position and is released. As the block oscillated, there is a frition force of 0.4 N between the oscillating block and surface. Calcualte the block's speed web it goes through the equilibrium pasiotion after ebing released from 9-cm desplacement pint, Assume the block underges simple harmonic motion. 0.681 m/s 2.266 m/s 0.916 m/s 1.034 m/s none
In the figure below Atwood’s machine is drawn - two masses  and  hanging over a massive pulley of rotational inertia  and radius , connected by a massless unstretchable string. The string rolls on the pulley without slipping.a) Find the acceleration of the system and the tensions in the string on both sides of the pulley in terms of in terms of given variables.b) Why are the rope tensions on two sides of the pulley not the same? Explain it physically.c) Suppose mass    and the system is released from rest with the masses at equal heights. When mass  has descended a distance , find the velocity of each mass and the angular velocity of the pulley.[4***] A string is rolled around a cylinder(   kg) as shown in figure. A person pulls on the string, causing the cylinder to roll without slipping along the floor
MECHANICAL VIBRATIONS USE VIRTUAL WORK HOW DID IT REACH TO THIS ANSWER? THIS IS ACCORDING TO THE ANSWER KEY OF THE BOOK The uniform bar shown in Fig. P3.6 has mass m, length l, and mass momentof inertia I about its mass center. The bar is supported by two springs k1and k2, as shown in the figure. Obtain the differential equation of motion anddetermine the natural frequency of the system in the case of small oscillations.
Suppose a spring with spring constant 7 N/m is horizontal and has one end attached to a wall and the other end attached to a 2 kg mass. Suppose that the friction of the mass with the floor (i.e., the damping constant) is 1 N⋅s/m a) Set up a differential equation that describes this system. Let x to denote the displacement, in meters, of the mass from its equilibrium position, and give your answer in terms of x,x′,x′′. Assume that positive displacement means the mass is farther from the wall than when the system is at equilibrium. b) Find the general solution to your differential equation from the previous part. Use c1 and c2 to denote arbitrary constants. Use t for independent variable to represent the time elapsed in seconds. Your answer should be an equation of the form x=… c) Enter a value for the damping constant that would make the system critically damped. ?Ns/m
Parameters Mass 5kg A=2 B=7 C(m)=3 D(m)=4.583
Q3.Consider a spring–mass–damper system with m = 80 kg, c = 15 kg/s, and k = 1500 N/m with an impulse force applied to it of 1200 N for 0.01 s. (C) Calculate the damped natural frequency of the system (D) Calculate the system response to the impulsive force at time t = 1 s
question 2 A mass ! hangs on the end of a cord around a pulley of radius 5 and moment of inertia 6, rotating with an angular velocity ,, as shown in the figure below. The rim of the pulley is attached to a spring (with constant 7). Assume small oscillations so that the spring remains essentially horizontal and neglect friction so that the conservation of energy of the system yields: 1 2 !91 + 1 2 6,1 + 1 2 7;1 − !); = =, ?ℎABA , = 9 5 , = = CDE&/, ; = FG&H'5CA!AE/ IBD! AJ(G'GKBG(! Find the natural circular frequency of the system in terms of !, 5, 7,6, and ).