m h A block of mass m sliding down an incline at constant speed is initially at a height above the ground, as shown in the figure. The coefficient of friction between the mass and the incline is k. If the mass continues to slide down the incline at a constant speed, how much energy is dissipated by the friction by the time the mass reached the bottom of the incline? * kmgh/sin(Theta) mgh kmgh/cos(Theta) O mgh/k

m h A block of mass m sliding down an incline at constant speed is initially at a height above the ground, as shown in the figure. The coefficient of friction between the mass and the incline is k. If the mass continues to slide down the incline at a constant speed, how much energy is dissipated by the friction by the time the mass reached the bottom of the incline? * kmgh/sin(Theta) mgh kmgh/cos(Theta) O mgh/k

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter7: Conservation Of Energy

Section: Chapter Questions

Problem 6P: A block of mass m = 5.00 kg is released from point and slides on the frictionless track shown in...

See similar textbooks

Similar questions

At hokey puck of mass 0.17 kg is shot across a rough floor with the roughness different at different places, which can be described by a position-dependent coefficient of kinetic friction. For a puck moving along the x-axis, the coefficient of kinetic friction is the following function of x, where x is in m: (x)=0.1+0.05x . Find the work done by the kinetic frictional forte on the hockey puck when it h moved (a) from x=0 to x=2 m, and (b) from x=2 m to x=4 m.
“ E=K+Uconstant is a special case of the work energy theorem.” Discuss this statement.
Shown below is a box of mass m1 that sits on a frictionless incline at an angle above the horizontal =30. This box is connected by a relatively massless string, over a frictionless pulley, and finally connected to a box at rest over the ledge, labeled m2 . If m 1 and m2 are a height h above the ground and m2m1: (a) What is the initial gravitational potential energy of the system? (b) What is the final kinetic energy of the system?
A block of mass m = 5.00 kg is released from point and slides on the frictionless track shown in Figure P7.6. Determine (a) the blocks speed at points and and (b) the net work done by the gravitational force on the block as it moves from point to point . Figure P7.6
In the Back to the Future movies (https://openstaxcollege.org/l/2lbactofutclip), a DeLorean car of mass 1230 kg travels at 88 miles per hour to venture back to the future. (a) What is the kinetic energy of the DeLorean? (b) What spring constant would be needed to stop this DeLorean in a distance of 0.1m?
Consider the following scenario. A car for which friction is not negligible accelerates from rest down a hill, running out of gasoline after a short distance. The driver lets the car coast farther down the hill, then up and over a small crest. He then coasts down that hill into a gas station, where he brakes to a stop and fills the tank with gasoline. Identify the forms of energy the car has, and how they are changed and transferred in this series of events. (See Figure 7.34.) Figure 7.34 A car experiencing non-negligible friction coasts down a hill, over a small crest then dill again, and comes to a stop at a gas station.
A 100 — kg man is skiing across level ground at a speed of 8.0 m/s when he comes to the small slope 1.8 m higher than ground level shown in the following figure. (a) If the skier coasts up the bill, what is his speed when he reaches the top plateau? Assume friction between the snow and skis is negligible. (b) What is his speed when he reaches the upper level if an 80 — N frictional force acts on the skis?
A couple of soccer balls of equal mass are kiched off the ground at the same speed but at different angles. Soccer ball A is kicked off at an angle slightly above the horizontak, whereas boll B is kicked slightly below the vertical. How do each of the following compare for ball Aand ball B? (a) The initial kinetic energy and (b) the change in gravitational potential energy from the ground to the highest point? If the energy in part (a) differs from part (b), explain why there is a differenne between the two energies.
Suppose a car travels 108 km at a speed of 30.0 m/s, and uses 2.0 gal of gasoline. Only 30 of the gasoline goes into useful work by the force that keeps the car moving at constant speed despite friction. (The energy content of gasoline is about 140 Mi/gal.) (a) What is the magnitude of the force exerted to keep the car moving at constant speed? (b) If the required force is directly proportional to speed, how many gallons will be used to drive 108 km at a speed of 28.0 m/s?
A crate on rollers is being pushed without frictional loss of energy across the floor of a freight car (see the following figure). The car is moving to the right with a constant speed v0 . If the crate starts at rest relative to the freight car, then from the work-energy theorem, Fd=mv2/2, where d, the distance the crate moves, and v , the speed of the crate, are both measured relative to the freight car. (a) To an observer at rest beside the tracks, what distance d is the crate pushed when it moves the distance d in the car? (b) What are the crate’s initial and final speeds v0 and v as measured by the observer beside the tracks? (c) Show that Fd=m(v)2/2m(v0)2/2 and, consequently, that work is equal to the change in kinetic energy in both reference systems.
The force exerted by a diving board is conservative, provided the internal friction is negligible. Assuming friction is negligible, describe changes in the potential energy of a diving board as a swimmer drives from it, starting just before the swimmer steps on the board until just after his feet leave it.
A roller-coaster car of mass 1.50 103 kg is initially at the top of a rise at point . It then moves 35.0 m at an angle of 50.0 below the horizontal to a lower point . (a) Find both the potential energy of the system when the car is at points and and the change in potential energy as the car moves from point to point , assuming y = 0 at point . (b) Repeat part (a), this time choosing y = 0 at point , which is another 15.0 m down the same slope from point .