M in water. M is recovered from the solution using solvent S. lf 9 kg of S is used per kg of solution and the distribution equilibrium is X/Z = 3, where X = kg M/ kg water and Z = kg M/ kg S a. What is the %M that will remain using single batch equilibrium stage ? b. What is the %M that will remain using two successive batch equilibrium steps using fresh solvent for each step?  Answer: a. 25% b. 16.6

Q: 1. A gas mixture containing 85.0 mole% N2 and the balance N-hexane flows through a pipe at a rate of…

A:

Q: Consider an iron ore consisting of Fe2O3 and Fe3O4. What are the weights of Fe2O3 and Fe3O4 if the…

A: To get the Ratio of Fe is unity in Fe2O3 and Fe3O4 we get the reaction:  3 Fe2O3  + 2 Fe3O4…

Q: ,The internal energy change in the conversion of 1.0 mole of the calcite form of CACO3 to the…

A:

Q: Liquefied butane(c4h10)is supplied to the combustion chamber at a mass flow rate of 2kg/min and…

A: Given that  the reaction of butane is occuring in the chamber and the reaction happens at 25oC and…

Q: 3. Determine the pressure exerted on the surface of a submarine cruising 175 ft below the free…

A:

Q: Cyclohexane vapor at 180°C and 5 atm is cooled and condensed to liquid then solidified to solid at…

A:

Q: Q. for case 3 the end of the fin is insulated so that dT/dx-D0 at x-L. and then e-mx emx 1+e-2mL…

A: It is required to prove that, θθ0 = e-mx1 + e-2mL + emx1 + e2mL = coshmL-xCosh mL

Q: 6

A: Q - what you learned most about the importance of using technology in understanding customer…

Q: A Carnot cycle uses 5 mol of gas as the working substance from an initial state of 5 bar and 550 K.…

A: Given Data  From the given information , we have : Moles of gas (n) = 5 moles γ = 1.35Isothermal…

Q: For the reaction A à B, the process flow diagram is shown in figure.1.The fresh feed of A contains…

A:

Q: Calculate the enthalpy of combustion of ethyl alcohol using the table for molar enthalpies. Select…

A:

Q: 2. A person is standing in a room with an ambient temperature of 25.3°C. Determine the total rate of…

A: Given, Emissivity = 0.95

Q: A CSTR reactor is to be used to carny out a second order reaction 2A → Products, with rate constant…

A:

Q: A fluid ‘A’ with a specific enthalpy of 2260 kJ/kg flows steadily into a mixing tank at a rate of…

A:

Q: The feed to a distillation column is separated into net overhead product containing nothing with a…

A: Given Distillation gives distillate and bottom products. Distillate-No n-butane and n-pentane,…

Q: What are the external environmental weakness/threats to yeti holdings inc?

A: YETI Holdings Inc can use the SWOT matrix to exploit the opportunities and minimise the threats by…

Q: Water flowing at 1.5 L/s in a 0.05m diameter tube is metered by means of a simple orifice of…

A:

Q: A liquid-phase reaction is said to be done in an isothermal and constant-volume CSTR: A → P when the…

A:

Q: If Vroluene 25ml and Voit 25ml %3D Viwater 1ooml mwt

A: Given that  Vtoluene = 25 ml, Voil = 25 ml, Vwater = 100 mlNoramility of NaOH = 0.1 N,molecualr…

Q: In a convergent-divergent nozzle where air, at 540 degrees F and 15200 torr enters and flows…

A: Note-Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: *To prepare 250ml of 0.02M of NaOH the weight of pure NaOH required is: 1000mg 500mg 2000mg 1500mg

A: Molarity is defined as the ratio of the number of moles of solute to the volume of solution in…

Q: Consider a system in which component A is being transferred from a gas phase to a liquid phase. The…

A:

Q: At 630°K the heat of sublimation of ZrBr, is 25,800 cal/mole, while the vapour pressure is 1 atm.…

A:

Q: Estimate the effective diffusivity of thiophene (molecular weight 84) in hydrogen at 660K and 30…

A:

Q: Pathway: Production of glutamic acid from sugarcane molasses by Corynebacterium glutamicum Chemical…

A: Given in question, the Production of glutamic acid from sugarcane molasses by Corynebacterium…

Q: 3.16, using the data below. Determine the number of plates required in the following cases: 1_Feed…

A:

Q: A gaseous fuel mixture has following molal analysis: H2-14%, O2-0.6%,CH4-3%, CO2-4.5%, CO-27%,…

A: Given: A gaseous fuel mixture having molal analysis H2-14%O2-0.6%CH4-3%CO2-4.5%CO-27%N2-50.9%…

Q: Find the density in pound per cubic feet of ammonia gas at 100C when confined by a pressure of 1600…

A: Find the density ? Molecular weight of ammonia is 17 g/mol.

Q: Hydrogen chloride HCI 36.47 °C 29.13 -0.1341 0.9715 -4-335 0-1200 A hydrochloric acid solution[ 2…

A: Given HCL solution                      ⟵  HCl/(g)   in water by absorption n=2 mole SG=1.03…

Q: Describe the relationship of entropy, heat, and temperature using  the analogy of sneezing in a…

A: The relation between entropy, heat, and temperature is the change in entropy is equal to the ratio…

Q: 2. A composite furnace wall is made up of a 14 in. lining of magnetite refractory brick, a 5.3 in.…

A: Given that For brick thickness L1 = 14 inch =1.16667 ftFor magnesia L2=5.3 inch = 0.441667 ftFor…

Q: Q. for case 3 the end of the fin is insulated so that dT/dx=0 at x=L. and then e-mx emx 1+e-2mL…

A:

Q: Consider the 3-component system of ethanol-benzene-water shown in the diagram below.  What amount of…

A: The solvent here is benzene. The Extract has more percentage of benzene and the raffinate has a…

Q: A 2-liter constant-volume bomb is evacuated and then filled with 0.10 gmol of methane, after which…

A: Given data: Volume of tank = 2 L Initial number of moles of methane = 0.1 mol T = 1273 P = 7.02 atm

Q: A plug flow reactor of volume 2 m' is being used for the first order liquid phase reaction of…

A: Given that, Volume V = 2 m3 The feed rate of A FAo = 0.2 kmol/s The initial concentration of A CAo =…

Q: Estimate the power required to compress 5000kmol/hr stream of process gas from STP conditions to 3…

A: For HCl Critical Pressure, Pc=2 bar Tc=324.6 K Cp'=30.30-0.72 x 10-2T+12.5x 10-6T2-3.9 x 10-9T3…

Q: 5. The cylindrical vessel in the right figure is full of water at a pressure of 1000 psig. The top…

A:

Q: First order reaction for both A and B. An autocatalytic reaction occurs: A +R → R+R k= 0.0315/min If…

A: For first order MFR (mixed flow reactor); τ=CA0 XA-rA=CA0 XAKCAKτ=XA1-XAXA=Kτ1+Kτ Damkohler Number…

Q: A 20-cm-square plate loses heat at a rate of 5000 W/m2. Air at 1 atm and 300 K flows across the…

A:

Q: aiker caught in a thunderstorm loses heat when her člouh- mes wet. She is packing emergency rations…

A: Assumption whole body at uniform temperature. Cp of body = cp of water only as major heat lost from…

Q: A reheat cycle with two stages of reheating is executed with steam expanding initially from 25 MPa…

A: Given that

Q: A hot cylinder ingot of 50mm diameter and 200mm long is taken out from the fuatace at 800°C and…

A:

Q: Consider the following reaction: 4PC13(g) → P4(g) + 6C12(g) If the initial concentration of PCI3(g)…

A: Given: Reaction is, 4Pcl3 -----> P4 + 6Cl2 Initial concentration of PCl3 = 1.5 mol/L  X =…

Q: Which of the following is not true about K- values? a. K=0.5 when an azeotrope exists at the given…

A: Of the given options , we need to choose the incorrect options :

Q: Which mode of control effectively eliminates offsets in the controlled variable? a. integral b.…

A:

Q: A centrifugal pump used to take water from reservoir to another through 800 m length and 0.15 m i.d.…

A:

Q: A heat engine operates in a reversible cycle consisting of the following steps: a. Adiabatic…

A:

Q: Thermodynamic calculus. a. Show that the variation of Cp with pressure at constant temperature is…

A:

Q: thermometer having a time constant of 0.2 min is placed in a temperature bath, and after the…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Find the Inverse Laplace Transform of 32+4s +4 A Pe te B 2 te 2 te ~2

A: First Re-solving the denominator we get,  1s2 + 4s + 4  = 1(s+2)2        -----------(1)  we know…