μ Show Transcribed Text Three containers filled with the same incompressible fluid are shown in the illustration above. The surface area in contact with the table is the same for each container, as is the height of the fluid (the fluid surface area at the top of the container is not the same, however). Also, when empty, each container weighs the same. Please answer the following question(s): 1. Which of the following statements are true? Write the letters of all that apply in the box below. Use all capital letters, with no punctuation. For example, if A and B are correct, write "AB". If only A is correct, write "A". A) The atmospheric force at the top surface of the fluid is the same for each container. B) The density of fluid is greater at the bottom of the container than at the top. C) The pressure at the bottom of each container is the same. D) The force of the fluid at the bottom of each container is the same. E) The weight of the filled containers as exerted on the table is the same.

μ Show Transcribed Text Three containers filled with the same incompressible fluid are shown in the illustration above. The surface area in contact with the table is the same for each container, as is the height of the fluid (the fluid surface area at the top of the container is not the same, however). Also, when empty, each container weighs the same. Please answer the following question(s): 1. Which of the following statements are true? Write the letters of all that apply in the box below. Use all capital letters, with no punctuation. For example, if A and B are correct, write "AB". If only A is correct, write "A". A) The atmospheric force at the top surface of the fluid is the same for each container. B) The density of fluid is greater at the bottom of the container than at the top. C) The pressure at the bottom of each container is the same. D) The force of the fluid at the bottom of each container is the same. E) The weight of the filled containers as exerted on the table is the same.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 89P: A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be...

See similar textbooks

Similar questions

Prove the sped of an incompressible fluid through a constriction, such as a Venturi tube, increases by a factor equal to the square of the factor by which the diameter decreases. (The converse applies for flow out of a constriction into a larger-diameter region.)
A glucose solution being administered with an IV has a flow rate of 4.00 cm3/min. What will the new flow rate be if the glucose is replaced by whole blood having the same density but a viscosity 2.50 times that of glucose? All other factors remain constant.
A rectangular gasoline tank bold 30.0 kg of gasoline when full. What is the depth of the tank if is 0.500-m wide by 0.900-m long? (b) Discuss whether gas tank has a reasonable volume for a passenger car.
How would you determine the density of an irregularly shaped rock?
What is the mass deep breath of air having a volume of 2.00 L? Discuss this effect taking such a breath has on your body's volume and density.
(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using be relationship for pressure due to the weight of a fluid (p=hg) rater a conversion factor. (b) Explain why be blood pressure of an infant would likely be smaller than that of an adult. Specifically, consider the smaller height to which blood mast be pumped.
Verify that pressure has units of enery per unit volume.
A straightforward method of finding the density of an object is to measure its mass and then measure its volume by submerging it in a graduated cylinder. What is the density of a 240-g rock 89.0 cm3 of water? (Note that the accuracy and practical applications of this technique are more limited than a variety of others that are based on Archimedes' principle.)
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
Is there a limit to the height to which an entrainment device can raise a fluid? Explain your answer.
Doppler ultrasound can be used to measure the speed of blood in the body. If there is a constriction of an artery, where would you blood speed to be greatest: at or after the constriction? What are the two distinct causes of higher resistance the constriction?
Check Your Understanding Would a hydraulic press still operate properly if a gas is used instead of a liquid?