MA VA a M L b VB M₂

Q: What is meant by Earth-centered, Earth-fixed (ECEF) coordinate systems?

A: Earth-centered, Earth fixed (ECEF) coordinate system is a coordinate system in which center of earth…

Q: calculate the reaction at each support.

A:

Q: ake a introduction about transportation (

A: From the given question it is require to make an introductory note on  Transportation.

Q: • Give insights and reflection about "Neglecting the health and safety in construction industry in…

A: Public and private construction may be seen everywhere on the land.

Q: A hydraulic jump is formed in a 5 m wide outlet at a short distance downstream of control gate. If…

A: Given- Width of the outlet B= 5m, flow depths y1=10 m & y2=2 m. Discharge- Q=150 m3/s. It is…

Q: Current Attempt in Progress (Buoyancy) An irregularly shaped piece of a solid material weighs 8.13…

A:

Q: express each measurement in feet.60 inches

A:

Q: Problem # 2 a. A distance 1,750m is measured using a 50.0m standard steel tape. The tape is known to…

A: Given:Measured distancel' =1750 mlength of standard steel tape(L)=50 mNow,Incorrect length of…

Q: Determine the reactions of the structure, given that X= 7 ft. 10 kips F ———X—₁▬▬▬▬▬▬5²- The…

A: Given data:- X = 7 ft.

Q: determine the stiffness k of each spring so that the 30-N force causes the bar to tip angle = 15…

A:

Q: At a certain station, the mean of the average temperature is 25°C and mean of the maximum daily…

A: Given data: The mean of average temperature, Ta=25 °C The mean of the maximum daily temperature,…

Q: Explain anti-spoofing?

A: Today's cybercriminals are continuously coming up with new strategies to enter systems and…

Q: The sewage from an area of 400.79 or take it 400.8  acres is to be carried by a circular sewer at a…

A: Given,  A=400.8 acers  Vmin=3.0 fpsn=0.013population density=16 person/acerpercentage of water…

Q: RA L/2 W L/2 RB

A: Given- A simply supported beam carrying triangular loading Required-  To derive an expression for…

Q: "n, find the reaction at the supports.

A:

Q: The runway length after correcting for elevation and temperature is 2845 m. If the effective…

A: Given- corrected length=2845 m,effective gradient=05%, It is needed to find the revised runway…

Q: The gradient for a B.G. railway line such that grade resistance together with the curve resistance…

A: GIVEN :- Degree of curve = 4° Rolling gradient = 1/250 Broad Gauge railway line TO DETERMINE :-…

Q: The control shown is for a window air conditioner.b. Through what angle must this dial be turned to…

A: Given:- A window air conditioner's control is shown  To determine:- Through what angle must this…

Q: 5.0 40.0 EG-44 lbs 38.66 38.66 5 lbs 38.66 40.0 -40 lbs GH = 0 FGX = 5 lbs Angle GH to FG = 38.66°…

A:

Q: By using unit-load method,determine the slope and deflection at point B for the cantilever in Fig.…

A:

Q: 1. High Reynolds number flows are characterised by their slow rates of mixing and 'reversibility'.…

A: Note : Hi! Thank you for the question, As per the honour code, we are allowed to answer three…

Q: Find the angle through which this conduit has been bent.

A: Given conduit: We need to find the angle theta.

Q: Calculate the corrected staff reading at point A, if the staff reading is taken from an instrument…

A: given- distance D=1.5 km, staff reading = 3.46 m

Q: A submarine is modeled as a cylinder with a length of 280 ft, a diameter of 50 ft, and a conning…

A: Calculate the specific weight of the seawater: ρseawater=1.03×64ρseawater=65.92 lbft2

Q: What is the double differencing technique?

A: Whenever two types pf single differences are coinciding, that makes up the double difference in the…

Q: 4. Forces P and F acting along the bars shown maintain equilibrium of pin A. Determine the values of…

A:

Q: Check the beam(350x800mm) for bending moment to carried the loads shown in the figure below,usefe…

A:

Q: 24.01 Stresses in a Soil Mass For the state of stress as shown, determine the inclination of minor…

A: Draw the Mohr's circle corresponding to the given state of stress. The angle required can then be…

Q: Differentiate GPS differencing techniques, Single differencing, Double differencing, and Triple…

A: GPS, the global positioning system consists of 24 satellites in 6 orbits means 4 satellites in each…

Q: A simply supported beam is 0.6 feet long, and has a distributed load of 8.9 kips/ft pointing in the…

A: Given:  Length of beam, L=0.6 feetUDL, w=8.9 kips/ftMoment of inertia, I=100 in4Distance of furthest…

Q: A boat having a mass of 80 Mg rests on the bottom of the lake and displaces 11.25 m³ of water. Since…

A:

Q: HAMMA A steel bar 100 mm long is subjected to a tensile stress o. If change in length of bar is 0.05…

A:

Q: Problem 3. Calculate the maximum depth, h, behind the concrete dam below that maintains a factor of…

A:

Q: MA Att VA a L W -b VB M₂

A:

Q: MA VA L/2- P * L L/2- 1 VB MB

A:

Q: Assume that the ESP of Problem 5.1 is built with an actual collection area of 5400 m2, Now suppose…

A: Given values: ESP actual collection area, A = 5400 m2 Actual drift velocity, we = 5 cm/s = 3 m/min…

Q: What are the major ITER buildings? Select one: A.Tokamak Building B.Radio Frequency Building…

A: ITER buildings are International Thermonuclear Experimental Reactor Buildings. It gave importance to…

Q: A solid cylindrical pine (S = 0.50) spar buoy has a cylindrical lead (S = 11.3) weight attached, as…

A:

Q: Calculate the total collection area for a 98% efficient ESP that is treating 10,450 m2/min of air.…

A: Q=10450 m3/min w=6m/min To find collection area of ESP

Q: 4 k 30° 8 k A " Ꭰ -6 ft- 4 ft 2 ft 15 k. ft B 5 Assume Pin/Internal Hinge at D ^_^ 12 k 4 8 ft8 ft-8…

A: Given data  Find support reaction and draw shear force and moment diagram.

Q: Define kinematic surveying?

A: Positioning, navigational, and scheduling are the three areas into which GPS work is sometimes…

Q: Determine the displacement at B. 12 m I 80 kN B E= constant = 200 GPa I=600 (106) mm* 12 m 21 C

A: E=200 kN/mm2 I=600 * 106 mm4 To find displacement at point B

Q: Give an insight and reflection about this "Development of cost engineering system in construction"

A: Introduction:- The current construction pricing system comprises not only budget production at the…

Q: Why multiple receivers are oriented in the same azimuths for older antennas?

A: The azimuths can be defined as the horizontal angles from the true north which is in a clockwise…

Q: A soil sample has a unit weight of 21.1 kN/m³ at a moisture content of 9.8%. When completely…

A: Given:Unit weightγ=21.1 KN/m3Moisture contentw=9.8%w=0.098saturated unit weightγsat=22.58…

Q: Disregarding material cost, how much is the total salary expenses for Design 1 and for Design 2.…

A: Given Data:Design 15 men costing P500/day Duration = 4monthsDesign 210 men costing P350/dayDuration…

Q: 1-34 A 4-kW resistance heater in a water heater runs for 2 hours to raise the water temperature to…

A: E = 4 KW x 2 hrs E = 8 kWh

Q: Compute adjusted forward bearings of the following open traverse;

A:

Q: Sitt Strength Of Materials The threaded bolts A and B of the same material and length are subjected…

A: given- strain energy of A=4 times B,mean dia of A=12 mm,Mean dia of B is to find out.

Q: hydraulic jump is formed in a 5 m wide outlet at a short distance downstream of control gate. If e…

A: Given- depth of flow u/s=10m depth of flow downstream (sequent depth at section 1), depth1=2m…

Equilibrium and Support Reactions

Civil engineers deal with structures that are composed of several members connected or with individual members such as beams and columns. To analyze such structures, the condition of statics must be applied. Under the static condition, the members are considered to be in equilibrium under the action of forces, that is, the members are assumed to be having negligible velocity.