machine mounted on elastic supports, is free to vibrate vertically. The machine has a mass of 40 kg and rotor out-of-balance effects are equivalent to 2 kg at 150 mm radius. Resonance occurs when the machine is run at 621 rpm. the amplitude of vibration at this speed being 45 mm. Determine the amplitude when running at 500 rpm and find the angular position of the out-of-balance mass when the machine is at its highest position during vibration.

machine mounted on elastic supports, is free to vibrate vertically. The machine has a mass of 40 kg and rotor out-of-balance effects are equivalent to 2 kg at 150 mm radius. Resonance occurs when the machine is run at 621 rpm. the amplitude of vibration at this speed being 45 mm. Determine the amplitude when running at 500 rpm and find the angular position of the out-of-balance mass when the machine is at its highest position during vibration.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Determine the differential equation of motion for the double pendulum shown in terms of12anduu where 12u and u are the horizontal distances of the masses from the leftmost verticalline that makes angle 1 from it. Find the natural frequencies, the ratios of the amplitudes, and thelocation of the nodes for the two modes of vibration. Assume m1=m2=m, and l1 =l2 = l=
A single-cylinder compressor with a mass of 150 kg is mounted on rubber wedges.Compressor rubber wedgesit has been observed that the wedges collapsed by 2mm when placed on it Damped free on wedges without starting the compressorwhen released into vibration, it completed 100 full oscillations in 10 seconds. The stroke of compressor is 100mm a-)Calculate the spring constant (k) of the wedges. b-) Calculate the degree of damping (c) of the wedges. c-)The vibration amplitude of the regular regime was measured as 1mm when the compressor was operated at a speed of 1000rpm In the compressorcalculate the amount of moving masses.
When a free vibrations is run on the system, the ratio of amplitudes on successive cycles is 2.5 to 1. determine the response of the machine due to a rotating unbalance of 0.25 kg*m when the machine operates at 2000 Rev/min.
with the aid of an engineering sketch of the mass and spring system, calculate the frequency of natural vibration of the dispenser
An electric motor of mass 25 kg is supported on a three-spring system. Thesprings are arranged in parallel, with the three stiffnesses being 10 kN/m,5 kN/m and 25 kN/m respectively. Viscous damping is present within the systemand has a magnitude of 0.4 kNs/m.i) Produce a sketch of the system and state its equation of motion.ii) Determine the damping ratio and comment on its value.iii) Determine the amplitude of vibration of the motor 5 cycles afterit is released from an initial displacement of 15 mm.
Determine the steady-state amplitude of the mass center of the bar of Fig P6.3 when its right end is subject to a moment M=4000sin105t N.m. Expected answer X=0.988mm
4) Large amplitude of vibration is experienced when an engine having mass (1500 + 2) kg operates at a speed of 1500 rpm. An absorber having stiffness k2equal to 1500 N/m and mass m2 is attached to the primary system to absorb the vibration. Find: The magnitude of the mass of the absorber. The natural frequencies of the system after the addition of the absorber. The values of the stiffness k2 and mass m2 of the absorber in order to have the natural frequencies of the two degrees of freedom system 15% away from the forcing frequency.
A mass weighing 4 lbs. stretches a spring 1.5 inches. The mass is given a positive displacement of 2 inches from its equilibrium position and released with no initial velocity. Assuming that there is no damping and that the mass is acted on by an external force of 2cos3t lbs., formulate the IVP describing the motion of the mass. What is the position of the mass at any time t? Determine also the period and amplitude of motion of the mass.
2. The mass ? = 20 kg is suspended from an ideal spring of stiffness ? = 500 N/m. If the mass is set into motion at ? = 0 with the initial conditions ?0 = 45.5 mm and ?0 = −104 mm/s, calculate (a) the amplitude of the motion; and (b) the time when the mass stops for the first time. Assume that ? is measured from the equilibrium position of the mass.
A 1.5 kg mass is attached to a vertically oriented spring, stretching it 0.45 m. The mass is moved upwards 0.25 m from its equilibrium position and held. A 0.8 kg mass is added to the hanging mass and the total mass is released from rest. Find the amplitude of motion for the two mass system equal to? Find the total amounts (their are two answers) is the spring stretched when the speed of the mass is three fourths the maximum speed?
The weight of an empty railway vehicle is 250 kN. On loading it with goods weighing 420 kN, its spring gets compressed by 29 cm. (a) Calculate its natural period of vibrations when the vehicle is (i) empty and (ii) loaded as above. (b) It is set into natural vibrations with an amplitude of 260 mm when loaded. Calculate the velocity and acceleration of the vehicle when its displacement is 90 mm from statically equilibrium position. Also calculate the maximum acceleration
A smooth disk with a mass of 3 kg is placed on a cylindrical surface.It can move without slipping. This cylinder has a mass of 2 kgproperly connected to the AB bar at its midpoint. AB bar is also middleIt is connected to a spring with a constant k = 300 N/m. EUrod can move freely around point A. Boccurs when the tip is given a small displacement and released.Calculate the period of the vibration.