Manalu, Apron Ryu B. 1-40182₁-1 PEIT -09-YOUR- 31161 V₁ 200L0° V F-50 Hz 200 LogoV 23 2+334 |72|5tsgr V2 22028°V Zs 81391 127 81102 V3 200LBV

Q: Find the Laplace Transformation of y" -3y + 2y = 2e-2x when y (0) = 6, y' (0) = 2 OY (s) = 6s²-8s+30…

A:

Q: 11.9 Find the equivalent Z of the network in Fig. P11.9. 20 -j10 -jin Z c b 192 102 www

A: Solve the problem

Q: 11.8 Find the equivalent Z of the network in Fig. P11.8. 20 -jin 192 19 Z→ 1/29 ww Figure P11.8 jin…

A:

Q: Draw the circuit diagram of power system layout with three phase CT and three phase PT.

A: Electrical Transformers can be used as Measuring devices when used in specific configuration. These…

Q: 16. The resistance of a parallel circuit consisting of two branches is 12 ohms. If the resistance of…

A: Given, The resistance of two branch parallel circuit, Req=12 Ω Resistance of one branch, R1=18 Ω

Q: appropriate response The RF signal level at the input to a directional tap is 30 dBmV. You measure…

A: In this question,  We need to choose the correct options  What is losses in the mdB?      as per our…

Q: What are the state space equations for the circuit below? + 23 C Vout Vin O Possible Answer 2- O…

A: State-space analysis: It is the method to analyse the control system behaviour. It gives information…

Q: For the above circuit, determine: a) The value of a resistance Rv, so that there is maximum power…

A:

Q: The single-phase half-wave controlled rectifier supplies a resistive load draws a average current of…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Manalu, Apron Ryu B. 1-40182₁-1 PEIT -09-YOUR- 31161 V₁ 200L0⁰V F-50 Hz 2.00 LogoV 23 2+334…

A:

Q: Calculate the reactive power consumed by the circuit coil shown in the figure in front of you

A:

Q: Q3 A Single phase 400/250 Volt 1, 50 Hz transformer has an equivalent resistance and leakage…

A:

Q: An 11,000/230-V, 150-kVA, 50-Hz, 1-phase transformer has a core loss of 1.4 kW and full-load Cu loss…

A:

Q: 4- When a 100-kVA single-phase transformer was tested in this way, the following data were obtained:…

A: The efficiency of a transformer is a measurement of the performance factor of the windings. This…

Q: In the figure shown below, if R=212 and L=3 H, find the current in A flowing through the inductor…

A:

Q: A. Minimum current circuit Circuit connection for minimum current delivered by a 30V DC source:…

A:

Q: Q2 (B): Answer with True or False for with following: 1. The system shown in figure (2) is stable.…

A: (1). The system is shown below,

Q: If the input voltage in the figure below is increased, the peak negative value of the output voltage…

A: The given circuit is a clamper circuit, it will shift the DC line of the input waveform. The diode…

Q: 37. A 3 Q resistor having 2 A current will dissipate the power of (a) 2 watts (b) 4 watts (c) 6…

A: Given data, R=3 ΩI=2 A

Q: - When a 100-kVA single-phase transformer was tested in this way, the following data were obtained:…

A:

Q: Determine its efficiency

A:

Q: OZ Draw S. F.G for the sys. shown in the figure below and fin Y/U + U A B +

A: In this question,   We need to determine the transfer function using Mason gain formula?  And draw…

Q: хах 10 -0.5 757 10 لاما

A:

Q: Find the value of VDs for the given network if loss= 8 mA VDD +12 V RD 1.0 ΚΩ (1) VDS RG 10 ΜΩ

A: In this question,   We need to determine the voltage Drain to source VDS   ?

Q: (b) Consider the high-pass transitional filter: C DO x1 ww R₁ R₂ in which R₂ << R₁. Noting that the…

A: Given: Consider the high-pass filter circuit as shown below: Here, R2&lt;&lt;R1 To find: The…

Q: Give an example of a screen and an application generator

A:

Q: 3- A transformer, when tested on full-load, is found to have Cu loss 1.8% and reactance drop 3.8%.…

A:

Q: Build a 16x4 encoder using two 8x3 encoders with enable.

A: The encoder is a digital electronic device which has 2n input lines, any one of them will be higher…

Q: 8- A transformer, when tested on full-load, is found to have Cu loss 1.8% and reactance drop…

A: Given transformer. We have to calculate voltage regulation.

Q: resistance of the light bulb

A:

Q: Peak to peak ripple

A: Rectifier- An electronic device setup for converting an alternating current into a direct current…

Q: a1. Calculate the total resistance assuming that the resistors are in series connection. a2.…

A:

Q: 5- A single-phase transformer, working at unity power factor has an efficiency of 90 % at both…

A:

Q: R₁ Hilt V1 30V R23 V1 30V Hilt PR4 0 PR4 1.0000A 171.43mA PR1 PR1 v 30.000V v 20.000V v 10.000V R1…

A: Given five multisim circuits of different combinations of resistors ,we need to evaluate equivalent…

Q: Using Nodal Analysis, solve for VA.

A:

Q: What is the inductor current if VL is 500 sin(50t + 20°)? 4 5 sin(50t - 70°) 5 sin(50t + 20°) 5…

A: The inductor voltage is VL=50sin50t+20°

Q: Determine the discrete-time Fourier transform of the signal x [n] = (0.50)-¹u[n 1].|

A:

Q: 4- When a 100-kVA single-phase transformer was tested in this way, the following data were obtained:…

A: Given data, KVA rating S = 100 KVA Open circuit test gives iron loss, Pi=1300 W Short circuit test…

Q: 3) Let's design a 1mA current source with this NMOSFET. For the circuit below, write an equation for…

A:

Q: 2. Find output voltage and current for a binary-weighted resistor DAC of 4 bits with given condition…

A:

Q: 1 5. Four metal plates, each of surface area A on one side, are placed at a distance d from each…

A:

Q: 84 일 Re - H2 Q4 G2 H3 G3 Loc K-

A:

Q: A lighting load of 1500kW and a motor load of 2200kW at a pf of 0.707 are supplied by two…

A:

Q: 8. A 555 timer is configured to run as an astable multivibrator as shown in below Figure. Determine…

A: We need to find frequency of given timer .

Q: (b) Simplify the Boolean expression (5 + ac)(āb + c)(a+b) by Boolean algebra.

A:

Q: In a 220 Vrms, 50 Hz. Source, determine the following values: V peak and the trigonometric…

A:

Q: 4. A circuit has a transfer function (8+1) H(s)-(² +65 +25) a. Determine the partial fraction…

A: A circuit has a transfer function: H(s)=s+1s2+6s+25 a) We need to determine the partial fraction…

Q: Data Simulated Data Simulated i Simulated V Computed Data Faculty of Engineering Computed i i,…

A:

Q: Q3: For the Single Line Diagram shown below, draw the reactance diagram and specify all reactance in…

A: In this question ,   We  need to draw the single line diagram of the given circuit for the given…

Q: why is it 10 v instead if 20v?

A: In the given circuit, the input voltage magnitude is given as 20 V (peak-to-peak).

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.