Mean radiant temperature sketch for calculations Using the sketch above, calculate the MRT for Person B, if the temperature on the exterior glass wall is 14 o C, the temperature on the solid exterior wall is 17 o C and the temperature on the interior walls is 22 o C . Round to one decimal place at your answer only.

Mean radiant temperature sketch for calculations Using the sketch above, calculate the MRT for Person B, if the temperature on the exterior glass wall is 14 o C, the temperature on the solid exterior wall is 17 o C and the temperature on the interior walls is 22 o C . Round to one decimal place at your answer only.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.56P: A pipe carrying superheated steam in a basement at 10C has a surface temperature of 150C. Heat loss...

See similar textbooks

Similar questions

A pipe carrying superheated steam in a basement at 10C has a surface temperature of 150C. Heat loss from the pipe occurs by radiation (=0.6) and natural convection (hc=25W/m2K). Determine the percentage of the total heat loss by these two mechanisms.
1.79 Consider the cooling of (a) a personal computer with a separate CPU and (b) a laptop computer. The reliable functioning of these machines depends on their effective cooling. Identify and briefly explain all modes of heat transfer involved in the cooling process.
1.19 A cryogenic fluid is stored in a 0.3-m-diameter spherical container is still air. If the convection heat transfer coefficient between the outer surface of the container and the air is 6.8 , the temperature of the air is 27°C, and the temperature of the surface of the sphere is –183°C, determine the rate of heat transfer by convection.
Consider a house that has a 10-m x 40-m base and a 4-m-high wall. All four walls ofthe house have an R-value of 2.50 m2 · °C/W. The two 10-m x 4-m walls have nowindows. The third wall has four windows made of 0.5-cm-thick glass (k = 0.78 W/m ·°C), 2 m x 2 m in size. The fourth wall has the same size and number of double-panedwindows, with a 1.2-cm-thick stagnant air space (k = 0.026 W/m ·°C) enclosedbetween two 0.5-cm-thick glass layers. The thermostat in the house is set at 22 °C andthe average temperature outside at that location is 2°C during the four months longheating season, Solve for the money this household will save per heating season byconverting the single-pane windows to double-pane windows. Consider that the houseis electrically heated and the price of electricity is $0.10/kWh.
Consider a house that has a 10-m × 20-m base and a 4-m-high wall. All four walls of the house have an R-value of 2.31 m2 · °C/W. The two 10-m × 4-m walls have no windows. The third wall has five windows made of 0.5-cm-thick glass (k = 0.78 W/m · °C), 1.2 m × 1.8 m in size. The fourth wall has the same size and number of windows, but they are double paned with a 1.5-cm-thick stagnant air space (k = 0.026 W/m · °C) enclosed between two 0.5-cm-thick glass layers. The thermostat in the house is set at 22°C and the average temperature outside at that location is 8°C during the seven-month long heating season. Disregarding any direct radiation gain or loss through the windows and taking the heat transfer coefficients at the inner and outer surfaces of the house to be 7 and 15 W/m2 · °C, respectively, determine the average rate of heat transfer through each wall.
What is the total heat loss through a triple glazing (U-value: 1.3) window with an area of 2m2 on a day when the outdoor and indoor temperatures are 5 C and 20 C, respectively?
The temperature on the two surfaces of a 25mm thick steel plate (k=48w/m°c)
A single-phase fluid reservoir is described by four equal blocks as. The reservoir is horizontal and has homogeneous and isotropic rock properties. k-270 md and -0.27. The gridblock dimensions are Ax-300 ft. Ay-350 ft, and h 40 ft. The reservoir fluid properties are B-B-1 RB/STB, p-50 lbm/ft, and μ-0.5 cP. The reservoir left boundary is kept at constant pressure of 4000 psia, and the reservoir right boundary is sealed off to flow. A 7-in vertical well was drilled at the center of gridblock 4. The well produces 600STB/D of fluid and has a skin factor of 1.5. Assuming that the reservoir rock and fluid are incompressible, find the pressure distribution in the reservoir and the FBHP of the well. Perform a material balance check.
The hollow sphere has an outside radius of 1 m and is made of polystyrene foam with a thickness of 1 cm. A heat source inside keeps the inner surface 5.20°C hotter than the outside surface. How much power is produced by the heat source? The thermal conductivity of polystyrene is 0.033 W/m°C.
An electric windshield defroster is used to remove 0.25-in of ice from a windshield. The properties of the ice are Tsat = 328F, uif = hif = 144 Btu/lbm, and v = 0.01602 ft3/lbm. Determine the electrical energy required per square foot of windshield surface area to melt this ice and remove it as liquid water at 328F. What is the minimum temperature at which the defroster may be operated? Assume that no heat is transferred from the defroster or ice to the surroundings.
What is the minimum amount of ice at OPC that must be added to the contents of a can of diet cola (340m) to cool it down from 20.5C to 0C Assume that the specific heat and density of the diet colo are the same as for water and that no heat is gained or lost to the surroundings. The latent heat of fusion of ice à 3353/g Specific Heat of water 4.184 J/gK and Density of water is 1 g/mL
Hi, can you help me to answer this question using the first law of thermodynamics formula to explain this event? On a hot summer day, a student turns his fan on when he leaves his room in themorning. When he returns in the evening will the room be warmer or cooler than theneighborouing rooms ? Explain your answer using the first law of thermodynamics.Assume ALL doors and windows are kept closed.