Mechanical Engineering. Need solution for this problem. Thanks A 15-lb block of brass with a specific heat of 0.089 is heated to 189°F and then immersed in 5 gal of water at 66°F. What is the final temperature of the brass and water? Assume there is no heat loss.

Q: A saturated steam at 410K is being transported in a pipeline (brass drawing tubing) at a rate of 1…

A: Given data Temperature of saturated steam = 410 KMass flow rate = 1 g/s = 10-3 kg/s = 0.001…

Q: For the joint shown below, an SAE Grade 5 7/8-9 screw connects two plates. The joint stiffness…

A:

Q: A saturated steam at 410K is being transported in a pipeline (brass drawing tubing) at a rate of 1…

A: (1)Heat loss for 1 ft of pipe using resistances (2)Overall Ui using the area Ai

Q: 1. A Cantilever beam deflects downwards when a mass is attached to its free end. The deflection(8)…

A:

Q: Which of the following is incorrect about the overall energy balance and mechanical energy balance…

A: All energies entering the system equal all energies exiting the system plus the change in storage…

Q: For seaworthiness trial of a new ocean-going vessel design, the total convective heat transfer rate…

A:

Q: A 5 gram cork floats in a glass of water. It floats such that 4 of its total volume is above the…

A: Mass of the cork, mc= 5 g. Let total volume of the cork is represented as Vc and volume of the water…

Q: A 2,500-kg car is rounding the curve of radius 250 m. If the road is bank at an angle of 10°, what…

A:

Q: The velocity of a particle moving along a straight line is v=t2+2t m/s, where t is in seconds. Of…

A: Find the acceleration and position of a particle.

Q: 1. An irregular container, closed at the end, is filled with water (999 kg/m). Consider the opening…

A:

Q: For the truss shown, the working stresses are 20 000 psi in tension and 12 000 psi in compression.…

A: From guidelines first question will be done from multiple questions posted. Please post again for…

Q: A certain coal has the following ultimate analysis: Carbon = 69% Nitrogen = 5% Hydrogen = 2.5%…

A: Given: Heating value = 27280.68 kJ/kg Carbon = 69% Nitrogen = 5% Hydrogen = 2.5% Sulfur = 7%   To…

Q: In an air-conditioning unit 3.5 m3/s air at 27°C dry-bulb temperature, 21°C wet-bulb temperature,…

A:

Q: 70° 70° F2 F1 5m 2m A column of 5m height is subject to 2 forces, F1 = 83N and F2 = 50N as shown…

A:

Q: 4.6 Show that velocity profile for fully developed laminar flow on an inclined plane, shown in Fig.…

A:

Q: Which is the correct path of information through a control loop

A:

Q: Draw the shear and moment diagram for Beams ACD and DE that are supported at A, C, and E, and are…

A:

Q: Imagine a head on collision between a 10-wheeler truck and a bicycle. During the collision, The…

A:

Q: T. Consider a two degree of freedom bar elements as shown in figure. Using finite element method to…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: In an air-conditioning unit 3.5 m3/s air at 27°C dry-bulb temperature, 21°C wet-bulb temperature,…

A:

Q: 8. The coefficient of friction between the 50 Ib weight and the 300 lb weight is 0.5. The 300 Ib…

A: Given  Mb=50lb P=16lb Find  Acceleration of block B

Q: Determine the phase and required properties in the following. Indicate the steam table number and…

A: We must identify the phase and needed parameters in the following and specify the steam table number…

Q: Find the moments of the lamina S of constant density p = 2 g/cm? occupying the region between y = x²…

A:

Q: A Carnot engine contains 2.00 mol of neon gas as its working substance. It operates with a hot…

A: Solution to first three sub-parts as per our company policy:

Q: As the fish looks at you, does your head appear to be at a greater or lesser height above the…

A: The light rays reflected from the fish are refracted at the water's surface, but the eyes and…

Q: A centrifugal pump has a 41.5-in-diameter impeller. It is used to deliver water at about 12,000…

A: Given Data, D_old =41.5-in Q_old =12,000 gal/min. N_1=N_2=710 RPM

Q: uf pl pa 13700 kalmt V Smls tz 20°C d=25m N-? epoe H (total head ow ey

A: Given dataDensity = ρ = 13700 kg/m3velocity = v = 5 m/stemperature = 20°CPressure = 150 kPaDiameter…

Q: An airplane used to drop water on brushfires is flying horizontally in a straight line at 315 km/h…

A:

Q: 1. An ideal Otto engine, operating on the hot-air standard with k = 1.34, has a compression ratio of…

A: Solution to first three sub-parts as per our company policy:

Q: One of the smooth vertical walls supporting end Bof the 235-kg uniform shaft is turned througha 30°…

A:

Q: What is the enthalpy at 2.438 MPa and 353°C?

A:

Q: You are designing a storage container for COVID vaccine. The volume of the storage container will be…

A: Given dataLength of cylinder  = 4 mDiameter of cylinder = 56.42 cm = 0.5642 mSurface Temperature =…

Q: A block of wood slides down a slope of frictionless inclined plane. Which of the following…

A:

Q: = 100Mpa 2=40 Mpa tens. tens. メ= 7o Mpa tens. V=0.3 E= 200 6pa {; =? by %3D %3D Oz = 7 %3D ノ

A:

Q: A particle is moving along a curved path. At a certain instant when the slope is 0.75, ax = 2 m/s2…

A: Given   Acceleration in x direction, ax = 2 m/s2    Acceleration in y direction, ay = 3 m/s2 Find…

Q: The 600-mm pipe shown in Figure 8 conducts water from reservoir A to a pressure turbine, which…

A:

Q: A load of P = 4900 N is acting on member AC. The length of AC is d = 300 mm. The cross-sectional…

A:

Q: The dynamic viscosity of water is 0.001 N-s/m2. Determine the kinematic viscosity in English…

A:

Q: The 1021-kg uniform bar AB is suspended from two cables AC and BD each with cross-sectional area 472…

A:

Q: PLEASE USE THE D'ALEMBERTS METHOD

A: Drawing the free body diagram as shown below, Since both the pulley is fixed so the 8 kg mass does…

Q: Determine the velocity of the aircraft flying at 2500 m, when the dynamic pressure is 45N/m^2?…

A: Given: Altitude of the aircraft→h=2500 m At this altitude the temperature of the air→T=272 K And…

Q: The dynamic viscosity of water is 0.001 N-s/m2. Determine the kinematic viscosity in English…

A:

Q: 3. A 4-stroke, 8-cylinder, petrol engine, has the following parameters at sea level; fuer…

A:

Q: placed by oil in the wate

A: Given Data : Water is replaced by oil in water pump

Q: Determine the difference between the total pressure of an aircraft flying at sea level, and an…

A:

Q: Q/ At the commencement of the compression stroke, the cylinder of an oil engine is charged with air…

A: Given dataP1 = 96.5 kPaT1 = 65 °C V1/V2 = 14Compression follows PV1.35 = CMass of fuel injected =…

Q: T3 T2= 50N 30° T1 a. Find 7, +7, b. Find 7-7, c. Find the resultant of the three forces as shown…

A:

Q: A 5 gram cork floats in a glass of water. It floats such that % of its total volume is above the…

A: 3/4th of the cork is floating above water. This implies, that 1/4th of the cork is immersed in the…

Q: heating value of fuel is 27444.25 kJ/kg.

A:

Q: Question 3 A fluid is evaluated for its viscosity using a Brookfield viscometer. Collected data of…

A: Given  Collected data using a brookfield viscometer.   Speed rev/min Apparent viscosity…

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.