Methane is diffusing at steady state through a 0.5mm diameter and 4mm long tube containing nitrogen gas at 101.32 kPa and 298K. Methane entering the tube is at 2.31x10 Pa and leaving the tube at 1.013x10 Pa. The diffusivity of nitrogen in methane gas is 0.140 x10 m2/s. Calculate flux of methane. Mention the unit of the flux. Paragraph BIEE

Methane is diffusing at steady state through a 0.5mm diameter and 4mm long tube containing nitrogen gas at 101.32 kPa and 298K. Methane entering the tube is at 2.31x10 Pa and leaving the tube at 1.013x10 Pa. The diffusivity of nitrogen in methane gas is 0.140 x10 m2/s. Calculate flux of methane. Mention the unit of the flux. Paragraph BIEE

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Calculate the entropy increase in the evaporation of one mole of water at 100 °C. Heat of vaporization of water at 100 °C = 2259.4 J g-1.
Water is boiled at 100°C electrically by a 3-kW resistance wire. Determine the rate of evaporation of water.
A stream of gas at 70°F and 14.3 psia and 50% saturated with water vapor is passed through a drying tower where 90% of the water vaopr is removed. Calculate the pounds of water removed per 1000ft³ of entering gas.A. 0.0004 lbB. 0.52 lbC. 120 lbD. 85 lb
Hi, please provide the need solution for this problem. The final answer is already provided below. Thank you so much. *** Determine the result when 100g of steam at 100C is passed into 200g of water and 20g of ice at exactly 0C in a calorimeter which behaves thermally as if it were equivalent to 30g of water. Answer: 49 grams of steam condense, final temperature 100°C
The pressure and temperature of a mixture of equal masses of hydrogen are 120 kPa and 27 degree celcius. The gas constants of hydrogen and oxgen are 4.125 and 0.2598 kJ/kg-K respectively. Calculate the partial pressure of ocygen in Kpa.
The normal boiling point of copper is 2845 K and its molar enthalpy of vvaporization is 300.3 kj/mol. What is the change in the entropy in the system when 127 g of copper vapor condenses to liquid at the normal boiling point? MW=63.5
In an electrolysis of water experiment, 39.75 mL of H2 gas was collected over water at 60.0 °C and an atmospheric pressure of 1.03 atm. The vapour pressure of water at 60.0 °C is 19.92 kPa. What mass of H2 was collected?
The heats of vaporization and fusion of water are 2490 J g-1 and 335 J g-1 at 0oC. The vapor pressure of water at 0oC is 611 Pa. Calculate the sublimation pressure of ice at -15oC, assuming that the enthalpy changes are independent of temperature. Answer:[166 Pa]
Water is boiled at atmospheric pressure in a square (0.2 m x 0.2 m) pan placed on top of a heating unit. Pan is made of polished copper and the surface tension of liquid-vapor interaction is 0.06 N/m. The coefficient Ccr is 0.15. What should be the maximum bottom surface temperature of the pan for safe operation? Properties of water: ρl=960 kg/m3 ρv=0.6 kg/m3 μl=0.3x10-3 kg/ms cpl=4200 J/kgK Prl=2 hfg=2257x103 J/kg
Consider a glass of ice water at 0 °C. Moisture from the air is observed to condense on the outer sides of the glass. This condensation causes the ice in the glass to melt faster than if there were no condensation. For this problem use LvLv= 2430 kJ/kg for the latent heat of vaporization of water at 37 °C as a better approximation than LvLv for water at 100 °C.) Determine the mass of ice, in grams, in the glass that would melt as a result of the condensation of 6.6 g of water from the air onto the sides of the glass.
A poultry house in Mogobane, is made of 100mm fired clay bricks. In winter, the inside air temperature is 24°C and the relative humidity is 75%. The outside temperature is at 1°C and the relative humidity is 25%. Determine whether condensation will occur within this wall. If there is condensation, suggest mitigating measures and show that indeed the measures will work.
Water is boiled at atmospheric pressure by a horizontal polished copper heating element of diameter D = 5 mm and emissivity ε = 0.05 immersed in water. If the surface temperature of the heating wire is 350°C, determine the heat flux from the wire to the water. The properties of water at the saturation temperature of 100°C are ρl= 957.9 kg/m3 , hfg = 2257.0×10^3J/kg, The properties of vapor at the film temperature ρv = 0.441 kg/m3 , µv = 1.73 × 10^-5 kg m/s , Cpv= 1977 J/kg °C, kv = = 0.0357 W/m °C Select one: a. 5.94 × 104 W/m2 b. 7.94 × 104 W/m2 c. 3.94 × 104 W/m2 d. 1.94 × 104 W/m2