Methane is heated in a steady-flow process at approximately atmospheric pressure. 1000 kJ of heat is added to 10 moles of methane initially at 500.0K. Note: There can be more than 1 exiting temperature that can give a heat of 1000 kJ. For this one, the exiting temperature does not exceed 3500 K. What is the average specific heat capacity, C,, for the temperature range of this heating process?

Q: A 500 cu ft tank contains 10lb of methane and 22lb of ethane at 90F. Whatis the apparent molecular…

A: Given data; Weight of Methane (CH4)= 10 lb Weight of Ethane (C2H6)= 22 lb Capacity of the tank= 500…

Q: The weight of a clean sand core sample in the air is 27.76g. When saturated with kerosene, it…

A: Given data:  The weight of a clean sand core sample in the air (Wsand )= 27.76g When the core sample…

Q: NaCL and the feed solution react to form CaCL2. In the reactor the conversion of CaCO3 is 76%…

A: Given data: Conversion of CaCO3 = 76 % Feed = 1000 kg/h

Q: Air with a 1.7 atm gauge and a temperature of 15°C enters a horizontal 0.075m steel pipe 70 m long.…

A: Given Air P1=1.7 atm T1=15C Steel pipe,L=70 m,D=0.075m Uin=60m/s Use equation Find P2=?

Q: Calculate the AS (system) for the reversible heating of 1.0 mol of ethane from 300 K to 1800 K at…

A:

Q: Methane (CH4) at 298 K, 1 atm enters a furnace operating at steady state and burns completely with…

A: Write the reaction for the combustion of methane as follows: CH4 + 2O2  →CO2 + 2H2O   One mole of…

Q: Drag and drop the acids given in the boxes below to rank them in increasing order according to their…

A: Given,ka values We know, The acids of large dissociation constant is the strongest acid.

Q: The partition coefficient for an organic solute A distributed between ether and water is 5.0. That…

A:

Q: . The level of toluene (a flammable hydrocarbon) in a storage tank may fluctuate between 10 and 400…

A: Given, Level of toulene fluctuate between 10 cm and 400 cm

Q: ' The role of a catalyst in a reversible reaction is to Select one: a. change the equilibrium…

A: Catalyst  Catalyst is a substance that increases the rate of reaction without getting consumed .…

Q: Q/ Three chemical engineers (Mohammed, Ahmed and Ali) discussed about the effect of the pressure…

A: If we increase the pump pressure then in pump then the rankine cycle jumps to higher constant…

Q: Water is flowing at velocity of 0.8m/s in a pipeline (diameter = 1.25 inch). Its initial pressure is…

A: we solve with the help of poiseuille equation

Q: Find the Laplace transform of f(t) = t cosh(3t) s2-9 A F(8) (8²+9) s² –9 (s2–9) 2 B F(s) S+9 © F(s)…

A: Let Laplace L [ f(t) ]  =  f(s)    and L [ t f(t) ] = -dds f(s)  we know that,  L [ coshat] = ss2 -…

Q: 3. The following values have been obtained for the velocity constant (k) in the decomposition of…

A:

Q: A hot fluid flows through a well-mixed stirred tank which is provided with a cooling jacket. The…

A:

Q: How does heat transfer work in the chemical industry? Explain each step of the heat transfer process…

A: Introduction The transfer of heat from one fluid to another is an essential component of all…

Q: Q. for case 3 the end of the fin is insulated so that dT/dx=0 at x=L. and then e-mx emx 1+e-2mL…

A:

Q: A mole of argon is allowed to expand adiabatically from a pressure of 10 bar at 298.15K to 1 bar.…

A:

Q: A gas storage tank initially contains 40 wt.% i-butane, 40 wt.% n-butane, and the rest is propylene.…

A: Given that  i-butane = 40 wt%  n-butane = 40 wt% propylene = 20 wt% the required n-butane = 50 mol%…

Q: 1. A 5.2 cm diameter spherical ball whose surface is maintained at a temperature of 71°C is…

A: Given, Emissivity = 0.8

Q: A vessel contains 1 kg of H2O as liquid and vapor in equilibrium at 1000 kPa. If the vapor occupies…

A: At 1000 KPA [From steam table] we get,  Vliq = 1.127 cm3/g Vvap= 194.29 cm3/g Hliq = 762.605 J/g…

Q: What is the most proper name for this structure? O.

A: Given that there is structure given of compound we have to identify what is the name of given…

Q: Q/ Three chemical engineers (Mohammed, Ahmed and Ali) discussed about the effect of the pressure…

A: The most ideal cycle in thermodynamics is the Rankine cycle. The steam engines are run through this…

Q: Question 3. Consider a piston-cylinder assembly that initially contains 0.5 kg of steam at 400 °C…

A:

Q: The pressure difference between two air tanks A and B is measured by a U - tube |manometer, with…

A:

Q: Tomato juice having 12% total solids is being concentrated to 25% total solids in a film type…

A: As we know that; Q=U×A×∆T    ............... equation 1  where; Q= Amount of Heat Energy U= Overall…

Q: explain the Rayleigh equation for batch distillation

A:

Q: Kc is 8.3 x 10-4 at 360°C. R 0.0821 atm.L/mol.K. a. Temperature (K) = K p. An (gas) = %3D

A: the detailed part of above question is attached below.

Q: At 318 K and 24.4 kPa, the composition of the system ethanol (1) and toluene (2) at equilibrium is…

A: Raoult's law is applied to calculate the activity coefficient. This consists of saturated pressure,…

Q: Two liters of a liquid mixture that is 50 mol% pentane and 50 mol% heptane is injected into an…

A:

Q: Q1 It is well known that any radiocarbon takes several decades to disintegrate. In an experiment,…

A:

Q: A very large horizontal plate in water at 20 oC is suddenly set in motion at 1 cm/s. Using Matlab…

A:

Q: What type of alcohol is ( O primary O secondary O tertiary O quaternary

A: As  We know  (E)-2-methylhex-4en-ol structure

Q: 2. A composite furnace wall is made up of a 14 in. lining of magnetite refractory brick, a 5.3 in.…

A:

Q: The wall of a furnace is made up of 9.5 in. firebrick (k=0.72 Btu/hr-ft-'F) 5.3 in. of insulating…

A: Given that, The thickness of firebrick L1 = 9.5 in = 0.792 ft The thermal conductivity of firebrick…

Q: 1. Consider a homogeneous gas reaction conducted in a plug flow reactor with the following…

A:

Q: a) Caculate all the six flow rates Fi to F6 in kg mol/hr. b) What is the percent conversion of…

A: The overall balance of the system is considered. The three-component balances are also considered.…

Q: Calculate from the data, AH° for the hydrolysis of urea to give carbon dioxide and ammonia in…

A:

Q: The vapor-phase molar volume of a particular compound is reported as 23,000 cm3.mol–1 at 300 K and 1…

A: Given that At 300 k and P1 = 1 bar ν1 = 23000 cm3mol=23000 x 10-6  m3molT2=300 kP2 = 5 bar = 5 x 105…

Q: Consider the following reaction: 4PC13(g) - Pa(g) + 6C12(g) If the initial concentration of PC13(g)…

A: Given that, 4PCl3g → P4g + 6Cl2g Initial concentration of PCl3 = 1 mol/L The equilibrium…

Q: A reheat cycle with two stages of reheating is executed with steam expanding initially from 25 MPa…

A: Given that

Q: The chemical equilibrium of a reversible reaction is not influenced by. Select one: O the…

A: The Chemical equilibrium of a reversible reaction is not influenced by catalyst.

Q: How does evaporation work in the chemical industry? Explain each step of the evaporation process in…

A: An evaporator is a system used in a technique to flip the liquid structure of a chemical substance,…

Q: What is the purpose of the "blowoff valve " in the Water distiller instrument? and What are the…

A: A blowoff valve (also known as a dump valve or compressor bypass valve) is a pressure release…

Q: At 25 °C, a sealed, rigid container is completely filled with liquid water. If the temperature is…

A: Given  Temperature T1 = 25 oC = 297.15 K                   Temperature rise = 10 oC…

Q: The heat capacities of a gas is expressed by Cp = a + bT + cT^2. For nitrogen, a = 26.984; b = 5.91…

A: Given that there is heat capcities of nitrogen gas is given as a function of temperature T1=300 kT2…

Q: Calculate the weight of each component of a 850 kg slag with the following percent composition:…

A: Given, 850 kg of slag

Q: Provide a matrix of cradle-to-grave analysis diagram of cosmetic products by a chemical engineer.

A:

Q: Choose the most correct set of reagents for the following reactions. OH 1.? OMe 2.?

A:

Q: A storage tank at 1000F is part full of a liquid mixture which contains 50 mole % n-butane and 50…

A: