motor may be controlled remotely or automatically by using a
Q: 25.a. There are two wires labeled P1 and P2 at a DC motor's junction box. These wires will attach to…
A:
Q: A large DC motor is started without starter. True or False
A: Starter is used to start dc motor . Starter prevents damage of windings from heavy currents.
Q: At a very low speed of shunt motor, increasing in field resistance will has no effect decrease the…
A: In a shunt motor, the shunt current is Ish=VRsh If we increasing the field resistance by connecting…
Q: Choose the correct statement below motors are actuators but not transducers DC motors and servo…
A: The actuator generates motion in the system by changing the electrical energy into mechanical. The…
Q: The shaft power of a shunt motor is 7.8 hp. Its armature draws 50 Amps from 120 V. The field winding…
A: It is given that: Psh=7.8 hpV=120VIa=50 AIf=1.2A
Q: When you turn on an electric motor, it takes longer to come up to final speed if a grinding wheel is…
A: When the value of I is larger then it is more difficult to change the state of object rotation as…
Q: Generally modern type mechanical gearbox have efficiencies depends on size and speed of rotation
A: efficiency is the ratio of the output power to the input power. outpower is gearbox speed and load…
Q: 1. Explain the difference between a slip ring and a squirrel -cage motor.
A: WOUND ROTOR (SLIP RING):- The rotor windings is uniformly distributed and is usually connected in…
Q: Three - wire control prevent the restarting of machinery when power is restored.
A:
Q: For switching OFF the motor normally open push butt Select one: O True False
A: The explanation is as follows.
Q: A Series Motor has an Armature Resistance of 0.2 and a Series Field Resistance of 0.3 ohm. It is…
A: Need to find back EMF of motor
Q: The DC motor is start by using the four point starter.
A: Fil the blank The DC... Motor is start by using the four point stator
Q: name 3 methods of braking a motor
A:
Q: For shunt generator which kind of apparatus is used for adjusting the voltage
A: For shunt generator, the potentiometer is used for adjusting the voltage. It controls the field of…
Q: What is power input of motor.
A: Given motor diagram is -
Q: An electrician inspects an electric motor that doesn't run properly. What is wrong with this motor?
A: In this question we need to inspects an electric motor that doesn't run properly. What is wrong with…
Q: Which Battery is discharging and which one is charging ? and why ?
A:
Q: 25. As you walk up to a machine, you see a technician tapping on the back section of a DC motor with…
A: In this solution we discusses about the constructional details of the DC machine along with the use…
Q: The fixed part of an electrical motor is called ........................... .
A: The parts of electrical motor are 1. Armature 2. Stator 3.shaft 4. Bearings 5. Carbon brushes 6.…
Q: 1.) Compare AC Motor and DC Motor. 2.) Define the parts and functions of AC Motor.
A: S.NO. AC MOTOR DC MOTOR 1. This is a motor which is managed by alternating current (AC). It is the…
Q: Mechanical balance mechanism
A:
Q: Figure 1 Figure 2 Figure 3
A: DC machines (Generator/ Motor) are the important parts of electrical drives. These machines are used…
Q: Compare between servo motor and universal motor
A: Solution Servo motor does not rotate freely and continuously like DC motor. Its rotation is limited…
Q: Indicate whether the following statements are true or false and correct the false statements are…
A: “Since you have asked multiple question, we will solve the first question for you. If you want any…
Q: A certain shunt motor armature has a resistance of 0.07 2 and current of 50 Amperes at 120 Volts.…
A:
Q: Incorrect Question 21 When an electrical load is connected to a DC generator, current flows None of…
A:
Q: a power failure,a manual starter motor automatically restarts when the power returns
A: To explain that whether a manual starter motor automatically restarts when the power returns after…
Q: The rotational speed of a motor is measured in units of _____?
A:
Q: the machine is operating at rated voltage,
A:
Q: Using the following control devices draw an electrical circuit that will manage the direction of…
A: In the case of DC motor, the Direction of rotation can be reversed by either reversing the polarity…
Q: 54 Damping torque in an indicating instrument is alwa O opposite to the deflection torque O in the…
A: In this question we will write about damping torque....
Q: List the four basic faults which can prevent a self excited generator to buildup voltage. For the…
A: Four basic faults are described which can prevent a self-excited generator from buildup voltage as…
Q: D.b- A DC motor will normally require that you replace which one of the following components on a…
A: In DC motor the brushes used . Due to friction they there size become short which may cause…
Q: Different between motor and generator
A: Given : In the they are asking the difference between motor and generator Depending on the…
Q: What is the mechanism of operation motion control lamp
A: mechanism of operation motion control lamp:
Q: The DC motor is start by using the two point starter.
A: Given To find which DC motor is started by using two point starter.
Q: A motor will undergo three major conditions throughout its operation. State and explain what takes…
A: Modes of motor operation Motoring ( Reverse and forward direction) Breaking ( Reverse and forward…
Q: 19. You’re powering up a new motor in a brushless motor control system. After moving the shaft of…
A: It is being given that : after moving the shaft of the motor slightly left to right, the motor…
Q: Explain why direct current shunt generator generates voltage.
A: A DC generator is a rotating machine which converts an mechanical energy into electrical energy. The…
Q: Question: Which motor can correct its speed when unexpected load is happen Servo Motor Stepper Motor…
A: Given that Which motor can correct its speed when unexpected load is happen
Q: Using the following control devices draw an electrical circuit that will manage the direction of…
A:
Q: Explain the function of Ballast and Starter in the discharge lamp
A: The starter in the discharge lamp is "simply timed-switch". Which allows current to flow through the…
Q: Does the EM Counter depend on the direction of rotation of the Input Handwhee
A:
Q: is the amount of torque load on the motor that causes it to slip.
A: Torque in machine varies as speed changes from zerp to maximum. There are diffeeenr types of…
Q: High Speed Very sensitive to The Disadvantage of Air Blast Circuit Long Arcing Both option A…
A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…
Q: Compare between servo motor and universal motor
A: Based on the construction and operation there are various classification of motors. Some of the…
Q: Puestion. Explain ĄC its he construction of motor also. servo draw
A: The servo motor are the devices used in the feedback control system. As like other motor the servo…
Q: teo
A: The capacitor acts as an open circuit for steady-state analysis and acts as a short circuit for…
A motor may be controlled remotely or automatically by using a
Step by step
Solved in 2 steps
- What is the mechanism of operation motion control lampA 300 V Series motor draws a current of 50 A. The field resistance is 40 m ohm and the armature resistance is 0.2 ohm. Determine the maximum efficiency of the motor.In the event of a power failure,a manual starter motor automatically restarts when the power returns.
- Hall effect sensors do not depend on electromagnetic induction to operate. Explain how they can sense the presence of a magnetic field if induction is not involved.Select the best answer for each of the following. The purpose of overload protection on a motor is to protect the a. motor from sustained overcurrents. b. wire from high currents. c. motor from sustained overvoltage. d. motor from short circuits.The symbol shown is a a. normally open pressure switch. b. normally open flow switch. c. normally open float switch. d. normally open temperature switch.
- 10.a. A normal commutator will have which one of the following colors where the brushes contact thecommutator?A. Slate-grayB. Chocolate-brownC. Auburn-brownD. Black 10.b. If an electronic control system is starting a motor, it will keep start-up current within limits by usingA. an acceleration ramp.B. coast-up system.C. a rheostat and a relay.D. a pulsed diode control.The pointer moving across a scale in the speedo meter is an example for ___________ of the instrumentation system. a.Feed back element b.Sensing element c.Data presentation element d.Signal conditioning element? drives are used to control the speed of electric motors and reduce the amount of power they consume. a. Analog b. Digital c. Electric Motor d. Motor