Name two depositional environments that are most likely to form fine-grained mud sediment?

Q: A footing 1.5 m square is located 1.5 m below the surface of a uniform soil deposit of density 20…

A:

Q: Problem 4. Determine the reactions at the supports for the structures shown. 222.5 kN 135.7 kN-m 22…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: 8. A 9.00 m span simply supported beam carries a uniformly distributed load of 100 kN/m and point…

A: Given:- The length of the beam = 9 m  The magnitude of the uniformly distributed load = 100 kN/m The…

Q: (a) A strain of E. coli bacteria taken from a sample of waste water in a treatment plant are…

A: (a) N = Aekt (i) A/q at t=0 N = 20 So, 20 = A * ek*0 or, A = 20

Q: 3- The maintenance costs for a bridge with an expected 50 years life are estimated to be…

A:

Q: A beam is constructed from two i-sections as shown in Fig. Determine the 200 mm maximum shear stress…

A:

Q: Calculate the forces in members BC, BE, and EF. Solve for each force from an equilibrium equation…

A:

Q: tests are carried out on cylindrical specimens of a ck with 30 mm diameter, as shown in the figure.…

A:

Q: Question 6 In the schematic below, water flows through the pipe and enters a sudden contraction…

A: Anchoring force Wind, tide, and waves combine to create the forces that an anchor must contend with.…

Q: Which of the following is/are correct about BOD in municipal sewage? 1. It must be removed because…

A: Answer 1- option A( 3,4,5) It is typically wholly particulate and can be removed by settling. It is…

Q: Q5. Table 2 shows the result of the California Bearing Ratio (CBR) for the road base material.…

A: Calibration factor is given as 0.02 kN/div Penetration (mm) Dial Gauge Reading (div) Load (kN)…

Q: Problem #3 A 16 mm thick tension member is connected by two 6.25 mm spliced plates as shown. The…

A:

Q: what is the concetrated load of tge triangular loading from left beam, top of the middle , right of…

A: Given The way you explained question is some what not clear.but I have understood your question…

Q: The factor of safety of an infinite soil slope shown in the figure having the properties c = 0, ¢ =…

A:

Q: 5. 25 mm x- (horizontal) and y- (vertical) axis through the centroid of the two 250 x 25 mm steel…

A: Given Steel plate at top and bottom Channel section at right and left  Welded together to form cross…

Q: In a system in which the solids in the biomass cannot be ignored, the F:M ratio is equal to: Q(S, -…

A:

Q: Determine the magnitude and direction of the moment reaction at A. Use (+) sign convention for…

A:

Q: A T-beam floor consists of 15 cm thick RC slab monolithic with 30 chm The beams are spaced at 3.5 m…

A:

Q: Explain what a concrete mix design is.

A: Since the concrete is mixed according to the desirable strength. Thus there are different types of…

Q: The modulus of rigidity and Poisson's ratio of the wire are 2.87 x 10" N/m and 0.379 res modulus of…

A:

Q: Q3) Calculate the stretch (elongation) in spring AC www A NA m- 100 Kg

A:

Q: SITUATION: A 20 m long beam is simply supported at the left end and 5m from the right end. It is to…

A:

Q: Q1 The wide flange beam shown below, supports the concentrated load 2W and a total uniformly…

A: Given: Concentrated Load = 2W UDL = 3W (total) Allowable stress in flexure = 20 MPa Allowable stress…

Q: vesign a built up sal wood column fabricated out of 50 mm thick planks of 250 mm 300 mm width to…

A:

Q: Calculate the chainage of the tangent points of the compound curve from the following: Stat.…

A:

Q: eam's support shown in Figure 7. Table bur solutions. You must need to Indicate e maximum bending…

A: Moment distribution method is a displacement in which we apply equilbrium equation to obtain forces…

Q: ,it expanded át čóńštánt Calculate the work done,

A:

Q: Assume that the average water usage of the Ermelo community is approximately 130 litres per person…

A: Qi = 130L/person/day Volume of water treatment plant = 10*106 L /day Volume of water for residential…

Q: Example. Consider a household on a given day received 20 Ib of consumer goods (food, paper,…

A: Material balance/Mass balance  A mass balance, also known as a material balance, is a method of…

Q: Solved problems: SP 1 The diameter in fig are 90 cm and 60 cm, at the larger end the pressure is…

A: Bernaulli equation When the force-momentum equation is applied to an inviscid, incompressible fluid…

Q: the velocity of the bedrock _________meter/second. 4) Critical distance from the source point ___

A:

Q: Determine the value of Elv (in Ib ft³ ) at the section below the load P for the beam loaded by two…

A:

Q: The pressure in the outlet pipe from the reservoir is 61.3 kPa abs and h =15 m. Because of the…

A:

Q: SITUATION: From the given figure, determine the following: Determine the percent retained at Sieve…

A: The answer is found to be Mass retained on sieve no 100 = 36.4% For explanation please refer the…

Q: SITUATION: A 12 ftx 10 ft footing carries a total load of 300 tons. Standard penetration test was…

A: Given, P= 300 ton B = 10 ft Df = 7 ft

Q: SITUATION: The tank shown in figure is accelerated to the right. Determine the pressure at point Bin…

A:

Q: what is the concetrated load of tge triangular loading from left beam, top of the middle , right of…

A:

Q: A rural highway difflicate by angle of 50° 40' Find: I. The tangent and curve length, D=4° 2.…

A:

Q: as a span of 3 m. The beam carries a uniform service load w = 22 kN/m includes the weight of the…

A: Given:- Properties of W 10 x 77 A = 14581 mm2                                 Lp = 2.799 m d =…

Q: If the pressure in the air shown in figure, is increased by 10 kPa, the magnitude of H will be…

A:

Q: any method, Calculate the maximum deflection in mm (absolute

A:

Q: The speed of the traffic flowing past EDSA between the hours of noon and 7:00pm is approximately v =…

A:

Q: SITUATION. A trapezoidal masonry dam with vertical upstream face is 6 m. high, 0.6m. at the top and…

A:

Q: The return line in a secondary clarifier Returns sludge at a lower concentration than in the aerator…

A: The return liner in a secondary clarifier    Option : C

Q: Water at 25°c is being supplied to an irrigation ditch from an elevated storage reservoir. A 3 m 10…

A:

Q: A simple beam has a span of 5 m. The maximum moment in the beam is 69 kN- m. The allowable bending…

A:

Q: identify and describe the importance in construction of conducting the following ASTM procedure…

A: Concrete temperature test  The temperature of fresh concrete may be measured using ASTM C1064 to…

Q: A parcel of land is defined as follows: CORNER NORTHINGS EASTINGS 9835 9765 9700 9840 3 9640 9572…

A: To find out the length of side 1-2 in meter.

Q: Two identical soil specimen were tested in a triaxial apparatus. First specimen failed at a deviator…

A:

Q: SITUATION: The table shows a 15-min volume count during peak hour on an approach of an intersection.…

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.