ngle phase transformer has arated secondary voltage of (230v).when Loaded by a purely inductive load to its rated Value of current ,its terminal voltage drops to (200 v). Calculate its regulation and efficiency

ngle phase transformer has arated secondary voltage of (230v).when Loaded by a purely inductive load to its rated Value of current ,its terminal voltage drops to (200 v). Calculate its regulation and efficiency

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.27P: A three-phase transformer is rated 1000MVA,220Y/22kV. The Y-equivalent short-circuit impedance,...

See similar textbooks

Related questions

Q: True or False? Consider a 3 phase transformer with same line to line voltage ratio. The delta…

A: Delta to Delta transformer: The primary phase current is,I1=13IL1The secondary phase currennt…

Q: Derive emf equation for an ideal transformer

A: We will use faraday law to derive EMF equation of ideal transformer.

Q: A transformer with primary winding 1000 turns and primary volatage is 220v, 5OHz and at secondary…

A: The data given in the question are: N1=1000,V1=220V,N2=500,V2=? The secondary voltage can be…

Q: Equivalent circuit diagram and electromotive force phasor for the idle operation of a step-up phase…

A: A transformer is a static device, it consist of two winding interlinked by common magnetic circuit…

Q: A 3300/230 V, 50-kVA, transformer is found to have impedance of 4% and a Cu loss of 1.8% at…

A: Given data, A 3300/230 V, 50-kVA transformer percentage impedance = 4% and Cu loss = 1.8% at…

Q: A 200 – MVA, 15/200 kV single-phase power transformer has a per – unit resistance of 1.2 percent…

A: Part (1): Consider the base voltage to be 15 V and the base MVA to be 200 MVA. Since the base…

Q: The full load voltage drop in a single phase transformer are 2% and 4% due respectively to…

A: Given values are - Voltage dropR%=2%%R=2%Voltage dropX%=4%%X=4%

Q: 1) How can you prove that Lsec = Lan (RI/ Rs) for matching impedance with the ideal transformer?

A: We are authorized to answer the only single question at a time since you have not mentioned which…

Q: Differentiate an ideal transformer and a practical transformer. Explain the ideal and practical…

A: Before differentiate between ideal and practical transformer let us understand the basics of simple…

Q: ou are employed in transformer fabrication unit. You have to design core of transformer. With regard…

A: Transformer: Transformer is an electrical static device works on the principle of electromagnetic…

Q: The open circuit test in a 100 kVA, 2000/200 V, 50 Hz, single phase transformer gives 200 V, 90 A, 5…

Q: A single phase 500/200 V ,55HZ transformer has an efficiency of 98% at full-load. Determine the…

A: Given input frequency = 55 Hz and no load terminal voltage = 200 volts full load terminal voltage =…

Q: Important Note Up to this point, an ideal transformer has been described by a ratio given either as…

Q: a) What is the complex power drawn and delivered by the transformer? (b) Draw a per-phase equivalent…

Q: Derive step by step, the electromotive force equation for a single-phase transformer.

Q: In a 100 kVA, 1100/220 V, 50 Hz single-phase transformer with 2000 turns on the high-voltage side,…

A: The solution is given below.

Q: What are the advantages of the star/star connected transformer? And why it is preferred by many…

A: advantages of the star/star connected transformer?

Q: Using the parameters from the Typical Transformer Values Sheet for a 12.4kV/600V, 100 kVA…

Q: a) An ideal single-phase two-winding transformer with turns ratio a, = N1/N2 is con nected with a…

A: A. The basic relation for a single- phase two winding transformer…

Q: (a) The size of transformer is usually defined in term of apparent power (VA) while the size of…

Q: Detailed conclusions we can come up with after conducting open circuit test on single phase…

A: According to the question we have to, Detailed conclusions we can come up with after conducting an…

Q: A single-phase transformer (assumed to be ideal) with the rated values are given in the figure, is…

A: Two winding transformer rating given S=11KVA Voltage ratings 2200/220V After change in auto…

Q: Explain the importance of transformer and basic insulation level in the distribution system. Justify…

A: The detailed answer to the given question is solved below according to the given parameters and…

Q: For a conceptual single-phase phase-shifting transformer, the primary voltage leads the secondary…

A: Note: As per our policy, I have attempted the first three subquestions. Given data: E1=E2+308E2=277…

Q: What's The relation between turn ratio current ratio annd voltage ratio(if it exists) for single…

A: The transformer is a static device that steps up or steps down the voltage depending upon the turn…

Q: Consider a single phase transformer of rating 150 KVA, 3600/360, 50 Hz. Let the series resistance…

A: Formula to calculate voltage required to produce rated current at short circuit is: VSC=V1×ZPUwhere…

Q: step down transformer rated 2200:220 having an effective core area of 100sqcm. and has 120 turns on…

Q: 4. Write a conclusion for the experiment, stating the role of core loss.component and magnetizing…

Q: Discuss the potential transformer with neat schematic diagram.

Q: Consider a single phase transformer of rating 150 KVA, 1500/150, 50 Hz. Let the series resistance…

A: Given: Z1=R1+jX1=0.2+j0.45 ΩZ2=R2+jX2=0.002+j0.0045 ΩKVA=150

Q: A 200 – MVA, 15/200 kV single-phase power transformer has a per – unit resistance of 1.2 percent and…

Q: 1. (a) The diagram for a single phase 60 MVA transformer is given below. Convert it to a Step-down…

A: Given 2-winding transformer details are V1/V2=50/100 kV.S=60 MVA The input and output currents of…

Q: What are the factors affecting the dielectric strength of Transformer oil?? Explain the maintenance…

A: Given Questions on transformer oil. Please find the answers below.

Q: Determine: A2rdg, A3rdg, IL(ave), PL(ave), & turn ratio of transformer

A: For a given circuit, Vp(rms) =220 V f=50 Hz A1 =400 mA load resistance RL =120 Ω

Q: For an ideal 2-winding transformer, the armpere-turns of the primary winding, N1/1, is equal to the…

A: For the magnetic circuit, the magneto-motive force is given as:

Q: 3. A 10 kVA, single-phase transformer has a turns ratio of 15:1 and is supplied from a 2,0 kV…

A: Single phase transformer 10KVA , turn ratio 15:1 Primary side voltage 2KV Find the secondary…

Q: A 2000/400 V, 100 kVA, 60 Hz step-down single-phase transformer has a primary and secondary…

Q: A 37.5-kVA, 6900-230-V, 60-Hz, single-phase transformer is operating in the step-down mode at rated…

A: a) Given data Apparent power is S = 37.5 KVA Low side voltage is VLS = 230 V Frequency is f = 60 Hz…

Q: transformer with a 10:1 ratio and rated at 60kVA, 2200/220V, 60Hz is used to step down the voltage…

Q: Justify if in a Yy transformer (without neutral wire on the supply side) there are homopolar…

A: Here it is mentioned that in a three Yy transformer there are homopolar components of fluxes,…

Q: Sketch a basic transformer structure. Identify and labelled the core, primary winding and secondary…

A: The correct solution is given below

Q: Let a 5-kVA, 400/200-V transformer be approximately represented by a 2-2 reactance referred to the…

A: Equivalent model oftransformer- Since no load current is very small 2 to 5% of full load current. No…

Q: 12.a. Comparing the transformer cores of core-form and shell-form transformers shows that the a.…

A: Solution of question (12.a): Four options are given, we need to choose the correct option. The…

Q: The label values of the single-phase transformer whose electrical equivalent circuit is given…

Q: A 50-kVA 13.8-kV/208-V (rms, line-line) ∆ − Y three-phase distribution transformer has a per unit…

A: Given,High voltage side, line voltage(Base) =13.8 kVApparent power (S)(Base)=50 kVAa) As primary is…

Q: During short-circuit test of a transformer, which winding must be short-circuited? Why?

Q: The per-unit system calculations method allows to: Select one: O a. improve the efficiency of the…

A: In the power systems analysis, Per Unit values are defined for per phase only not for 3 phase . A…

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

A single phase transformer has arated secondary voltage of (230v).when Loaded by a purely inductive load to its rated Value of current ,its terminal voltage drops to (200 v). Calculate its regulation and efficiency.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An ideal transformer has no real or reactive power loss. (a) True (b) False
Consider Figure 3.25 of the text for a transformer with off-nominal turns ratio. (i) The per-unit equivalent circuit shown in part (c) contains an ideal transformer which cannot be accommodated by some computer programs. (a) True (b) False (ii) In the - circuit representation for real c in part (d), the admittance parameters Y11 and Y12 would be unequal. (a) True (b) False (iii) For complex c, can the admittance parameters be synthesized with a passive RLC circuit? (a) Yes (b) No
For an ideal 2-winding transformer, the ampere-turns of the primary winding, N1I1 is equal to the ampere-turns of the secondary winding, N2I2 (a) True (b) False
Consider Figure 3.4. For an ideal phase-shifting transformer, the imda nce is unchanged when it is referred from one side to the other. (a) True (b) False
A two-winding single-phase transformer rated 60kVA,240/1200V,60Hz, has an efficiency of 0.96 when operated at rated load, 0.8 power factor lagging. This transformer is to be utilized as a 1440/1200-V step-down autotransformer in a power distribution system. (a) Find the permissible kVA rating of the autotransformer if the winding currents and voltages are not to exceed the ratings as a two-winding transformer. Assume an ideal transformer. (b) Determine the efficiency of the autotransformer with the kVA loading of part (a) and 0.8 power factor leading.
Consider a source of voltage v(t)=102sin(2t)V, with an internal resistance of 1800. A transformer that can be considered as ideal is used to couple a 50 resistive load to the source. (a) Determine the transformer primary-to-secondary turns ratio required to ensure maxi mum power transfer by matching the load and source resistances. (b) Find the average power delivered to the load, assenting maximum power transfer.
A single-phase, 50-kVA,2400/240-V,60-Hz distribution transformer has the following parameters: Resistance of the 2400-V winding: R1=0.75 Resistance of the 240-V winding: R2=0.0075 Leakage reactance of the 2400-V winding: X1=1.0 Leakage reactance of the 240-V winding: X2=0.01 Exciting admittance on the 240-V side =0.003j0.02S (a) Draw the equivalent circuit referred to the high-voltage side of the transformer. (b) Draw the equivalent circuit referred to the low-voltage side of the transformer. Show the numerical values of impedances on the equivalent circuits.
The ideal transformer windings are eliminated from the per-unit equivalent circuit of a transformer. (a) True (b) False
(a) An ideal single-phase two-winding transformer with turns ratio at=N1/N2 is connected with a series impedance Z2 across winding 2. If one wants to replace Z2, with a series impedance Z1 across winding 1 and keep the terminal behavior of the two circuits to be identical, find Z1 in terms of Z2. (b) Would the above result be true if instead of a series impedance there is a shunt impedance? (c) Can one refer a ladder network on the secondary (2) side to the primary (1) side simply by multiplying every impedance byat2 ?
A 23/230-kV step-up transformer feeds a three-phase transmission line, which in turn supplies a 150-MVA,0.8 lagging power factor load through a step-down 230/23-kV transformer. The impedance of the line and transformers at 230kVis18+j60. Determine the tap setting for each transformer to maintain the voltage at the load at 23 kV.
An ideal transformer with N1=1000andN2=250 is connected with an impedance Z22 across winding 2. If V1=10000VandI1=530 A, determine V2,I2,Z2, and the impedance Z2, which is the value of Z2 referred to the primary side of the transformer.
A single-phase 100-kVA,2400/240-volt,60-Hz distribution transformer is used as a step-down transformer. The load, which is connected to the 240-volt secondary winding, absorbs 60 kVA at 0.8 power factor lagging and is at 230 volts. Assuming an ideal transformer, calculate the following: (a) primary voltage, (b) load impedance, (c) load impedance referred to the primary, and (d) the real and reactive power supplied to the primary winding.